振蕩次數 的英文怎麼說

中文拼音 [zhèndàngcìshǔ]
振蕩次數 英文
oscillation number
  • 振 : 動詞1. （搖動; 揮動） shake; flap; wield 2. （奮起） brace up; rise with force and spirit
  • 蕩 : Ⅰ動詞1 （搖動; 擺動） swing; sway; wave 2 （無事走來走去; 閑逛） loaf; wander; roam; loiter; go a...
  • 次 : Ⅰ名詞1 （次序; 等第） order; sequence 2 [書面語] （出外遠行時停留的處所） stopping place on a jou...
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 次數 : number of times; frequency
  1. This simplification principle is the foundation of the following analysis. using the test signal method, a detailed analysis of subsynchronous oscillation for a hvdc system is performed

    （ 3 ）對一個僅含有直流輸電線路的系統，採用復轉矩系數- - - -測試信號法，對其次同步振蕩特性進行了分析。
  2. Because the larger the event, the larger the number of oscillations of the transducer before they decay below the trigger level.

    因為事件越大，傳感器在它衰減到低於觸發器電平之前的振蕩次數越多。
  3. On account of the low q - factor and small tuning range of the p - n junction varactor, the inversion - mode mos varactor is used in the lc voltage controlled oscillator in this thesis. the simulation results show that the designed lc voltage controlled oscillator has 15 % tuning range

    3 .由於lc壓控振蕩器中的pn結變容管品質因數低、調諧范圍小，本次設計的lc壓控振蕩器採用了強反型mos變容管，模擬結果表明，所設計的lc壓控振蕩器具有15 %調諧范圍。
  4. According to the guidline, two nd : yag lasers have been designed and set up, one is end - pumped by lower output power ld using a selfoc micro lens, and the other is end - pumped by high output power ld using a pair of lenses are designed, and the characteristics such as output power and power stabilization of both solid - state lasers are investigated. thirdly, when an empty liquid crystal cell is inserted in the cavity of the nd : yag laser pumped by high power ld, the laser can operates in single axial mode. finally, according to the relationship between the laser output power and the longnitudinal a ld - end - pumped nd : yag laser sensor for displacement measurement has been investigated theoretically and demonstrated experimently, the results indicate that when the mean radius of pumping inside the laser cavity is far less than that of the oscilating laser mode, the exponential of the output power is a gauss function of the longitudinal positon of focused spot of ld pumping beam, both the measurement range and the sensitivity are dependent on the incident pumping power, as the incident pumping power is increased, the measurement range is enlarged and the sensitivity is improve d

    本文首先介紹了ld泵浦nd ： yag激光器的發展狀況、主要特性及其應用，從四能級速率方程出發，推導了ld泵浦nd ： yag激光器的閾值、輸出功率和斜效率的表達式，並簡述了激光器的工作原理、結構型式和倍頻方法；其次，以空間相關的速率方程為基礎，提出了ld端面泵浦nd ： yag激光器的設計方法，給出了一定泵浦耦合方式下，振蕩光模尺寸、最佳輸出耦合率、泵浦光模尺寸、泵浦光焦斑位置等參數的選取依據，以此為依據，設計了自聚焦透鏡耦合小功率ld泵浦nd ： yag激光器和透鏡組耦合高功率ld泵浦nd ： yag激光器，對激光器的輸出功率和功率穩定性等特性進行了實驗研究；再次，在帶尾纖輸出的高功率ld泵浦nd ： yag激光腔內插入一隻空液晶盒，觀察到了激光器以單縱模運轉；最後，根據泵浦光焦斑端面位置對激光輸出功率的影響規律，提出了ld端面泵浦nd ： yag激光位移傳感新方法，並進行了理論和實驗研究，研究結果表明：當激光晶體內泵浦光平均光斑半徑遠小於振西安理工大學碩士學位論文蕩光束腰半徑時，激光輸出功率的自然指數與泵浦光焦斑的縱向位置成高斯變化規律，測量范圍和靈敏度依賴于泵浦功率，隨著泵浦功率的增加，測量范圍擴大，靈敏度提高，當端面泵浦功率為7 . 24w （最大輸出功率為1 . 926w ）時，激光位移傳感器的測量范圍和靈敏度分別是13 . 045mm和0 . 148mw / pm 。
  5. There are five parts are as follows : in part one, the concept of switching function is introduced first to establish the nonlinear mathematical model of the induction motor variable frequency speed adjustment system which is fed by a sine pulse width modulated ( spwm ) inverter and takes the effect of the main magnetic circuit saturation into consideration, then the low frequency oscillation of the system is simulated according to the model. next, from the view point of energy conversion of the inverter - induction system, a criterion for the low frequency oscillation is proposed to determine whether the system is in low frequency oscillation which is judged by whether the interval of the negative current component of the inverter input current is more than 1 / fc ( fc is the carrier wave frequency of the inverter ) or not

    首先引入開關函數概念，建立了正弦脈寬調制（ spwm ）逆變器供電異步電動機，考慮主磁路飽和時的變頻調速系統整體數學模型，模擬系統的低頻振蕩；其次從逆變器-異步電動機系統能量轉換角度出發，提出通過檢測逆變器輸入電流中負電流的間隔時間是否大於1 / f _ c （ f _ c為逆變器載波頻率）來判定系統是否出現低頻振蕩；最後的實驗結果驗證了系統低頻振蕩建模和判據的實用性和正確性。
  6. The results show that all the orders of the stress singularities at the interface edge can be determined precisely, and the related stress intenisity coefficients can also be determined by extrapolation method

    計算結果表明，本方法可以精確地求得振蕩應力奇異性次數，並且與奇異性對應的復應力強度系數也可以很方便地應用外插法得到。
  7. Some practical method to lifting the rated capacity of vsc - hvdc is discussed. ( 4 ) the subsynchronous oscillation ( sso ) characteristics of a synchronous machine connected to a static var compensator is studied with the complex torque coefficient method realized by time domain simulation, and some important conclusions are obtained which can guide the design and operation of svcs to avoid sso problem

    （ 4 ）基於時域模擬實現的復轉矩系數法，對與靜止無功補償器svc相聯接的同步發電機組的次同步振蕩（ sso ）特性進行了深入的研究，得出了一些重要結論，可為svc的設計和運行提供避免sso的依據。
  8. All these changes, which are of importance to subsynchronous oscillation analysis, cannot be described with the quasi steady state ( qss ) model any more. therefore, the deficiency of qss - model - based eigenvalue method is pointed out and a novel method named complex torque coefficient - test signal method is adopted to analyze the subsynchronous oscillation caused by hvdc or facts devices

    基於此，指出了採用準穩態模型進行hvdc系統次同步振蕩分析的局限性，並引入了分析hvdc或含有facts裝置的系統次同步振蕩問題的方法：復轉矩系數- - - -測試信號法。
  9. Finally, the rules used to design the induction motor and set the inverter v / f curve are summarized to improve the stability of the system movement in the forth part of the dissertation, three measures are brought forward to eliminate the system low frequency oscillation. the first measure adopts pulse based dead time compensation to suppress the oscillation. as second measure, considering the motor and inverter as an integration, the discontinuous space vector modulated strategy named dpwm3 is proposed for the first time to suppress the oscillation

    措施一是在總結常用死區補償方法的基礎上，提出脈沖為基礎的死區時間補償法（ pbdtc ）對死沈陽工業大學博士學位論文區進行補償，抑制系統的低頻振蕩;措施二是從逆變器與電機的機電一體化配合更加完善的角度，首次提出採用不連續空間矢量調制策略dpwm抑制系統的低頻振蕩;措施三是通過對系統中電機參數的調節，達到抑制系統低頻振蕩的目的;最後進行了實驗驗證。
  10. 3. the different forms of oil whip presented in engineering practice are verified by the numerical examples from nonlinear theory. the influence of different mass eccentricity, rotating speed, bearing load and external damper are numerical studied also

    運用數值積分的方法，對油膜振蕩的發生、發展、失穩機理及諸多影響因素進行分析，從理論上深層次揭示工程實際中表現出來的油膜振蕩形式的多種多樣性。
  11. Abstract : this paper proposed a numerical method to determine the oscillatory stress singularities and the related stress intensity coefficients, by use of common numerical solutions ( stresses or displacements ) which obtained by an ordinary numerical technique such as finite element method or boundary element method

    文摘:本文以具有振蕩應力奇異性的平面問題為例，提出了一種利用普通的數值分析結果（由有限元或邊界元程序計算得到的應力分量或位移分量） ，來確定奇異點附近的振蕩應力奇異性次數以及相應的復應力強度系數的數值分析方法。
  12. In this chapter, the suitable devices and circuit structure have been choosed to design a second order multiplier, a fifth order multiplier, a sixth order harmonics mixer and a dro operating in 9. 4ghz. the forth chapter is a section of system realization and test, in this chapter, the system of low phase noise frequency source has been constructed and tested. the results show that the targets of the system have been achieved

    第三章的系統分器件與實驗數據部分，主要是以上述第二章的分析為基礎，以所推導的理論公式為指導選取必要的器件和合適的電路拓撲結構，分別設計實現了一個二次倍頻器，五次倍頻器， 6次諧波混頻器和一個9 . 4ghz的介質振蕩器，為後述整個系統的實現在硬體上做了必要的準備。
  13. This paper realized frequency modulation using the video signal to directly control the resonance loop ' s diode of the vco at the early stages, and then through using radio frequency bipolar junction transistor, designed a lc voltage controlled oscillator which was emulated by advance design system. in addition, it also implemented the design and debugged the hardware circuit

    本文第一次實驗採用視頻信號直接控制vco諧振迴路變容二極體的方式實現頻率調制，並且利用射頻雙極性晶體管（ bjt ）設計了一種lc壓控振蕩器，通過ads軟體進行了參數模擬，最後進行了硬體電路的製作和調試。
  14. The complex oscillation of higher order nonhomogeneous linear differential equations with meromorphic coefficients

    高階亞純系數非齊次線性微分方程的復振蕩
分享友人
分享到 Line

分享到臉書