振蕩誤差 的英文怎麼說

中文拼音 [zhèndàngwùchā]
振蕩誤差 英文
oscillation error
  • 振 : 動詞1. （搖動; 揮動） shake; flap; wield 2. （奮起） brace up; rise with force and spirit
  • 蕩 : Ⅰ動詞1 （搖動; 擺動） swing; sway; wave 2 （無事走來走去; 閑逛） loaf; wander; roam; loiter; go a...
  • 誤 : Ⅰ名詞（錯誤） mistake; error Ⅱ動詞1 （弄錯） mistake; misunderstand 2 （耽誤） miss 3 （使受損害...
  • 差 : 差Ⅰ名詞1 （不相同; 不相合） difference; dissimilarity 2 （差錯） mistake 3 [數學] （差數） differ...
  • 誤差 : error
  1. The accelerometer bias errors result in an average constant offset plus an oscillatory component.

    加速度計的偏置誤差形成一平均的常值偏離加上一振蕩分量。
  2. The error caused by the photoperiodic induction changes along with the initiatory and terminative radiation level. and the effect of photosynthetic oscillations should be emphasized in fast measurement of photosynthesis

    在誘導期間（光誘導期或光合振蕩期）進行光合速率測定造成的誤差與葉片光環境變化前後的強度水平及光質有關。
  3. The paper analyzed the relationship of the scale factors and several main performance indexes of the system ' s respond curve like over - regulation, divergence, surge - degree, steady - state error and transient time, and denoted these indexes by some fuzzy membership functions

    溫室溫度響應的主要動態性能指標包括：超調量、系統發散程度、系統振蕩程度、穩態誤差、過渡過程時間等。
  4. When this fault is cutted off and the breaker is reclosed, this scheme ca n ' t start by mistake. the availability of this scheme is proved with matlab test. the single phase high - impedance grounding fault is settled properly

    Matlab模擬分析證明了該方案耐受過渡電阻的能力強，在故障切除和重合閘時不會因出現的暫態信號而誤啟動，不受系統振蕩、頻率偏差的影響，克服了常規保護靈敏度不足的缺點，較好地解決了單相高阻接地故障的難題。
  5. In the meantime, the all sub - circuits are also designed and emulated carefully including inverter, rs type flip - flop, voltage reference circuit, error amplifier, voltage comparator, sawtooth - wave generator, pwm comparator, soft activation circuit and so on. as a result, all of the sub - circuits answer the requirements. this chip has taped out with the 0. 5um mix - signal process of csmc

    本文利用cadenceeda集成電路設計工具、 spectres模擬工具，對集成電路內的各個模塊包括反相器、基本rs觸發器、基準電壓電路、誤差放大電路、電壓比較電路、鋸齒波振蕩發生電路、 pwm比較電路、軟啟動電路、驅動電路等進行了具體的設計和模擬，且達到了預先設定的指標。
  6. On the aspect of errors analysis of hrg, a brief introduction of the close - loop detection theory of hrg is present first. later the expressions of close - loop detection errors are deduced in theory. the impact of stimulating signals, turning speed, outside appended oscillation, the location & area of electrodes, and the current loss in capacitor is considered, and the primary analysis of error compensation is given

    在半球諧振陀螺誤差分析方面，本文從半球諧振陀螺的閉環檢測原理出發，對半球諧振陀螺閉環檢測誤差進行了分析和推導，考慮了激勵信號、轉動速率、外界附加振蕩、電極位置及極板面積和電容傳感器等因素造成的陀螺誤差並對誤差補償進行初步分析。
  7. And then, based on the above theories, the circuit design and simulation means have been concretely applied in the internal modules of voltage reference, bias circuit, oscillator, error amplifier and drive circuit of the chip and so on. the relevant design indexes are successfully achieved. at last, the whole circuit simulation and layout design are completed

    在此理論基礎上對該電源晶元內部的各個模塊，如電壓基準源、偏置電路、振蕩器、誤差放大電路和驅動電路等模塊進行了具體的電路設計和分析模擬，且達到了相應地設計指標，最後，完成了整體電路模擬和版圖設計。
  8. Consequently, an integrate switch mode power supply with high efficiency and good reliability can be realized by the controller with very few external parts. the fundamental principle of monolithic voltage - mode switching regulator is firstly introduced in this thesis, which is followed by a comparison between voltage - mode and current - mode converters where the pros and cons of both converters are discussed in detail ; next, the global system architecture is proposed upon the design requirements and sub - block circuits are also introduced that focuses on several essential sub - blocks such as amp, wave, pwm control, psc, osc and vref. finally, all sub - circuits and the whole chip circuit are simulated by hspice whose results indicate that the circuit function and performance have perfectly satisfied the design requirements

    在論文中，首先闡述了電壓控制模式pwm開關電源的基本原理，對比了電流控制模式和電壓控制模式，分析了各自的優缺點;隨后根據設計要求進行了電路的總體設計，完成了各個子電路的原理分析，電路設計和模擬驗證，重點闡述了誤差放大電路、三角波發生電路、 pwm控制電路、節能控制電路、振蕩電路和基準源電路的分析、設計和驗證過程;最後，利用eda軟體hspice對整體電路進行了功能模擬驗證，模擬結果表明，本文完成了設計工作，達到設計要求。
  9. Subcircuit models are designed and simulated, which includes bias current source, voltage reference, error amplifier, pwm comparator, driver circuit, protection circuits for over - temperature, over - current. at last, combined with periphery component, the circuit is simulated, and the result meets the anticipant requirement

    並對集成電路內的各個模塊包括電流偏置電路、基準電壓電路、誤差放大電路、三角波振蕩發生電路、 pwm比較電路、驅動電路、過熱保護電路和過流保護等進行了具體的設計和模擬，並對整體應用電路進行了模擬，結果均達到了預先設定的指標。
  10. In the thesis, some of the most important functional modules of the pwm power control ics are designed and simulated, including error amplifier, voltage reference, voltage regulator, comparator, and oscillator. the topologies, schematics and layouts of some circuits are introduced and developed

    本畢業設計研究和提出了構成pwm電源控制晶元的主要功能模塊，設計了其中主要模塊ip核的多種結構電路並進行了模擬，完成了部分電路的版圖設計? ?包括誤差放大器，基準電壓源，電壓調節器，比較器，振蕩器等。
  11. Traditional inertial mechanized - platform uses velocities to damp the system attitude to improve the precision of attitude, when the system acceleration is small. referring to the idea, this paper designeda damp kalman filter in strap - down attitude heading reference system ( ahrs ). the new method makes use of 3 - d accelerometer ' s measurements to estimate the system attitude, which is measured to compensate attitude errors. because the acceleration affected the precision of fiher directly, the fuzzy adaptive system was presented. the fuzzy logic inputs are three accelerations and the output is to control the measurement noise covariance matrix. simulations and experimental results prove that the damp algorithm can damp most of schuler oscillation and foucauh oscillation, so that to assure the filter convergence and efficiently improve the precision of strap - down ahrs

    在系統機動性不強的情況下，傳統的平臺內阻尼演算法將系統本身的速度信息通過阻尼網路加到系統中，達到提高姿態角精度的目的.將這種平臺內阻尼的思想引入到捷聯慣性航姿系統中，在系統加速度較小的情況下，利用加速度計的輸出估計系統姿態角，通過卡爾曼濾波的形式補償系統姿態誤差.由於加速度的大小直接影響濾波器精度，本文設計了模糊自適應卡爾曼濾波演算法，根據三軸加速度計的輸出調整內阻尼量測誤差方差陣，從而避免了濾波器的發散.模擬和實驗驗證，內阻尼演算法可明顯抑制舒勒周期振蕩和傅科周期振蕩，避免了系統姿態漂移，有效提高了捷聯慣性航姿系統的精度
  12. Analyze the interpolation filter, timing - error detector and controller in loop of timing recovery detailedly

    詳細分析了定時恢復環路中的內插濾波器、定時誤差信號的提取、數控振蕩器。
  13. The frequency of the pulse is the same as that of the crystal oscillator. the pulses sampled the output of the vco and generate the error signal. the error signal is amplified,

    誤差電壓經放大後送入環路濾波器進行濾波和再放大，然後去改變變容管偏置電壓，控制振蕩器輸出頻率，達到穩頻的目的。
  14. 4. we design the experiment of acvity - ring - down to measure reflectivity of the mirrors of coil and df laser with high reflectivity respectively at wavelength 1. 315 m and 3. 8 m, and perform the experiment of measuring reflectivity of coil laser resonant mirrors. the experimental result is discussed in detail

    設計並建立了用光腔衰蕩法測量氧碘激光器（波長為1 . 315 m ）和氟化氘激光器（波長為3 . 8 m ）高反射腔鏡的實驗平臺；測量了氧碘激光器振蕩腔鏡的反射率，並對實驗結果做了詳細的誤差分析。
  15. The wt coefficient disposed by the compromise of the hard and soft threshold method can reform its continuity on the threshold and guarantee the reconstituted single unable to surge, also can make the signal error smallest

    該方法將小波系數經過軟硬閾值折衷法處理后，可以改善小波系數在閾值處的連續性，使重構信號不會振蕩，又使變換后的重構信號與實際信號誤差最小。
分享友人
分享到 Line

分享到臉書