接觸式電極 的英文怎麼說

中文拼音 [jiēchùshìdiànjí]
接觸式電極 英文
contact electrode
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 觸 : Ⅰ動詞1 （接觸） touch; contact 2 （碰; 撞） strike; hit 3 （觸動） touch 4 （感動） move sb ; sti...
  • 式 : 名詞1 （樣式） type; style 2 （格式） pattern; form 3 （儀式; 典禮） ceremony; ritual 4 （自然科...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 極 : i 名詞1 （頂點; 盡頭） the utmost point; extreme 2 （地球的南北兩端; 磁體的兩端; 電源或電器上電流...
  • 接觸式 : contact; contacting; contact-type接觸式變流器 contact converter; 接觸式送話器 contact microphone
  • 接觸 : 1. （交往） come into contact with; get in touch with 2. （沖突） engage 3. （挨上; 碰著） contact; touch
  • 電極 : electrode; pole
  1. An experimental system of electro - spray with two different charging methods - inducted by ring electrode and polarized by contacted needle electrode is established. an effective charging equipment for fuel is designed. water and kerosene ' s characteristics of charging and atomization in the electro - spray are measured and analyzed

    2 、建立了環狀感應電極充電和閉式接觸電暈充電的荷電噴霧實驗系統，對煤油和水兩種不同物性介質的荷電特性與荷電霧化特性進行了測量及分析。
  2. Abstract : with the aids of computer ' s hardware, executive mechanism of weld arc length automatic controller of all - position pipe welder and additional software, an automatic system for arc striking has been developed, in which touch - starting method using tiny current is introduced. utilizing this method, the ablation ratio of tungsten electrode and tungsten inclusion ratio of welded seam is far smaller than normal touch - starting method. and the successful ratio of arc striking is high

    文摘:用全位置自動焊管機弧長自動控制系統的計算機硬體和執行機構，僅增加部分程序，設計了採用小電流接觸引弧法的自動引弧系統，鎢極燒損和焊縫夾鎢遠小於普通的接觸引弧方式，引弧成功率很高。
  3. Research on surface and grain boundary passivation mechanism obtained effects of surface recombination on crystalline silicon solar cell performance and the theoretical expression of grain boundary recombination velocity. the limit ratio of short - circuit current increment for anti - reflection coating utilization on solar cells was obtained. the crystalline silicon solar cell spectral response, contact resistance and minority carrier lifetime measurement systems were established

    鈍化機理研究獲得了表面復合對不同表面摻雜濃度晶體硅太陽電池性能的影響、表面和界面復合速度的理論表達式；研究得到了減反射膜對太陽電池短路電流增量比的極限；建立了太陽電池光譜響應、柵線電極接觸電阻和少子壽命等測試系統。
  4. Leakage current is one of key factors for the energy resolution of the detectors, the mis detector has lower leakage current thus improve the energy resolution. the mis structure is a good contact type for the cdse detectors

    可見漏電流是影響探測器能量解析度的重要因素，具有mis接觸電極的探測器能有效地減小漏電流，提高能量解析度，因而是cdse探測器的一種較佳電極接觸方式。
  5. But, with the development, it can ’ t meet the need of modern manufacture more and more. as a result, handhold digital storage oscilloscope is studied. handhold dso is an important genre of digital storage oscilloscope, it ’ s outstanding feature include small form, use battery instead of ac supply for power, and include the whole function of dso while implementing the basic function of multimeter. handhold dso can measure wave range automatic, analyze wave use cursor, measure resistance 、 diode and short circuit if choice digital multimeter

    手持式數字存儲示波器是數字示波器的一個分支，它具有體積小、重量輕、便於攜帶、電池供電、無須外接交流電源等優點，它集數字萬用表（ dmm ） 、數字存儲示波器於一體，可自動對信號進行幅度的測量，也可用光標對波形進行分析，同時還可以通過菜單選擇來實現對電阻、二極體以及電路通斷的測試;可以選擇觸發通道和觸發模式。
  6. The immersion electrical heater is chiefly applied in the direct contact mode of fluid heating. it features fast heat exchange and high thermal efficiency. it has the varieties of water heater, oil heater and gas heater. its heating element power density, i. e. the power per unit of heating area of the heating element, is an important parameter of the electrical heating element, which has a direct bearing on the performance and working life. the working out of the value is a highly specialized problem, being under the influence of many factors ( media flow rate, tempt, physical and chemical properties and direction in which the medium flows past the element etc )

    浸入式電加熱器主要用於直接對流體接觸加熱的場合，具有熱交換快，熱效率高等特點，分為水用加熱器、油用加熱器、氣體用加熱器，加熱元件的功率密度：即電加熱元件單位發熱面積上的功率，它是電加熱元件極重要的參數，直接影響加熱器的使用性能及使用壽命，它的取值是一個非常專業的問題，受到許多因素的影響（如介質的流速、溫度、物理和化學性質及介質流過加熱元件的方向等等） 。
  7. Hence, our oral history project allows us to make contact with film people and conduct interviews with them, as part of an ongoing project to research into the history of the development of hong kong cinema from all perspectives

    資料館除了保存和修復影片，亦積極搜集各式各樣有關電影的資料，所以我們開展了口述歷史計劃，與曾經親身參與的影人直接接觸，從多角度探求香港電影發展的歷史。
  8. Circuit design is the basis of design of demultiplexer. speed, power and chip area are the main factors that should be considered in circuit design. every circuit structure has its merits and drawbacks, e. g. cmos logic family has a slower speed, but lower power, smaller area, scfl ( source couple fet logic ) family has a higher speed, but higher power, larger area. we should choose a proper circuit structure or their mixed structure for certain design to get a good tradeoff among the three factors. flip - flop is the fundamental element of demultiplexer, setup time and hold up time are key factors, which influence the speed of circuit, thus the design aim is how to reduce them. in this thesis we place emphasis on the design of scfl latches

    速度、功耗、面積是電路設計要考慮的主要因素，不同的電路形式具有不同的優缺點，如cmos互補邏輯電路功耗低，面積小，速度相對較慢； scfl （源極耦合fet邏輯）電路速度高，功耗和面積較大。所以要針對具體設計需要選用適當的電路形式或其組合結構，以滿足設計要求。觸發器是分接器的基本組成單元，建立時間和保持時間是影響電路速度的關鍵，所以減小建立時間和保持時間是觸發器設計的主要目標，本文著重介紹了scfl鎖存器的設計和優化方法。
  9. It advancement is not expected to replace conventional office by home - based office, conventional business transactionretailing by e - commerce, schools by cyber learning center, at least over the short to medium term, as human interactions are still considered indispensable and that the small size and efficient transportation system are positive factors in helping such interactions ; it development is unlikely to lead to significant reduction in the demand for office space

    由於港人仍極重視人與人的接觸，加上高效率的運輸系統促進了人與人的直接溝通，故預計于中、短期內，資訊科技的發展並不能讓家居辦公室取代傳統的辦公室，也不能讓電子商貿取代傳統商業交易及零售模式，而學校亦不會由虛擬的學習中心取代。
  10. A indirect fiber - trigger system is adopted for high voltage thyristor vale, which solves the problem of high voltage insulation and improves the capability against interfering and the reliability of the control signal. the thyristor gate electronics is also designed

    論文採用間接光纖觸發方式作為高壓晶閘管閥的觸發隔離系統，很好地解決了系統的高低壓隔離問題，大大提高了控制信號的傳輸抗干擾能力和可靠性，並設計了相應的晶閘管門極電子電路。
分享友人
分享到 Line

分享到臉書