接觸電阻 的英文怎麼說

中文拼音 [jiēchùdiàn]
接觸電阻 英文
contact area
  • : Ⅰ動詞1 (靠近;接觸) come into contact with; come close to 2 (連接; 使連接) connect; join; put ...
  • : Ⅰ動詞1 (接觸) touch; contact 2 (碰; 撞) strike; hit 3 (觸動) touch 4 (感動) move sb ; sti...
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 動詞(阻擋; 阻礙) block; hinder; impede; obstruct
  • 接觸 : 1. (交往) come into contact with; get in touch with 2. (沖突) engage 3. (挨上; 碰著) contact; touch
  • 電阻 : (物質阻礙電流通過的性質) resistance; electric resistance (電路中兩點間在一定壓力下決定電流強度...
  1. On the contact resistance between graphite polypropylene composite plate and carbon paper

    聚丙烯復合板與碳紙間的接觸電阻
  2. Tensile properties and impact properties measurements were done at room temperature. the volume resistivity of rectangular samples was measured using a zc36 electrometer and a high 240a voltage supply, for samples with a low resistivity level a dt - 9205b digital multimeter was used, silver paint was applied to ensure complete contact between sample and electrodes, namely, to eliminate the contact resistance. the phase morphology of blends was also studied using a jeol jsm - 5900lv scanning electron microscope ( sem )

    體積率的測定:當r _ v 10 ~ 8時,製成100 100 4mm板材,用zc36型高儀測量;當r _ v 10 ~ 8時,用dt - 9205b型數字式萬用表測試試樣的體積,為了減小接觸電阻對測試的影響,採用銀導膠將銅片粘在試樣的兩個端面上,靜置24小時,待銀導膠凝固,試謝長瓊:熱拉仲對pet / pe / cb復合導體系形態和性能的影響樣的穩定后再測量。
  3. This paper selects dc double - arm bridge, uses the four - port connection to remove the contact and connection resistances and reduce the electromagnetism interfere. grounding grid conductors fault levels are established during a lot of emulational computations, simulative experiments

    使用直流雙臂橋,採用四端鈕連法,可大大降低現場中磁干擾及引線接觸電阻的誤差影響。
  4. Connectors for electronic equipment - tests and measurements - electrical continuity and contact resistance tests - test 2a - contact resistance - millivolt level method

    子設備用連器.試驗和測量.氣連續性和接觸電阻試驗.試驗2a .接觸電阻.毫伏壓級方法
  5. Connectors for electronic equipment - tests and measurements - part 2 - 1 : electrical continuity and contact resistance tests ; test 2a : contact resistance - millivolt level method

    子設備連器.試驗和測量.第2 - 1部分:連續性和接觸電阻試驗.試驗2a :接觸電阻.毫伏法
  6. Wire clip features easy installation, compact connection, small contact resistance, low temperature and good insulation with outstanding anti - electricity - theft function, which ensures safely and reliability

    線夾安裝方便、連緊密、接觸電阻小、溫升低、且有絕緣性能良好的防竊護罩,使用安全可靠。
  7. With four and out, wire clip features easy installation, compact connection, small contact resistance, low temperature and good insulation with outstanding anti - electricity - function, which ensures safety and reliability

    線夾四進四齣、安裝方便、連緊密、接觸電阻小、溫升低、且有絕緣性能良好的防竊護罩,使用安全可靠。
  8. In order to improve process quality and increase probability, we optimize ohm contact resistance and breakdown voltage of devices by adjusting process conditions. finally, dc - 500mhz midf switch is fabricated, in which some important conclusions and suggestions are introduced

    工藝研究的重點是改進工藝質量,提高成品率,為此我們通過調整工藝條件來優化歐姆接觸電阻和提高器件的擊穿壓。
  9. A model of the interface state density distribution near by valence band is presented, and the dependence of the threshold voltage on temperature, the c - v characteristics and the subthreshold characteristics are predicted exactly with this model ; the effects of s / d series resistance on the output characteristics, transfer characteristics and effective mobility of sic pmosfets are analyzed. thirdly, the output characteristics and the drain breakdown characteristics are modeled with the procedure medici. the output characteristics in the room temperature and 300 ? are simulated, and the effects of gate voltage. contact resistance, interface state and other factors on sic pmos drain breakdown characteristics are analyzed

    提出了一個價帶附近的界面態分佈模型,用該模型較好地描述了sicpmos器件閾值壓隨溫度的變化關系、 c - v特性曲線以及亞閾特性曲線;分析了源漏寄生對sicpmos器件輸出特性、轉移特性以及有效遷移率的影響;論文中用模擬軟體medici模擬了sicpmos器件的輸出特性和漏擊穿特性,分別模擬了室溫下和300時sicpmos器件的輸出特性,分析了柵壓、接觸電阻、界面態以及其他因素對sicpmos擊穿特性的影響。
  10. The sort, material composite, structure properties and conduction mechanisms of eca ( electrical conductive adhesive ) were discussed in this paper. then three types of ega specimens were designed and made, on which temperature cycles test from - 55 ? to + 125 ? and thermal aging at + 125 ? were carried out. changes of the adhesive strength, eca ' s bulk resistance and contact resistance under the environment stress were summarized and a detailed evaluation on these specimens was given

    本文在全面闡述導膠的分類組成、物理結構、導機理的基礎上,設計並製作了三批導膠樣品,通過對樣品進行長時間的- 55 ? ? + 125溫度循環和125高溫存儲試驗,總結了導膠粘強度、體接觸電阻在環境應力下的變化規律,對三類樣品的長期可靠性做出了全面的評價,並結合導率和「穿流閾值」的計算機模擬,給出了提高導膠可靠性和導率的建議,介紹了國內外在高導率高可靠性導膠研製方面的一些最新進展。
  11. The main work includes three contents as followings : 1, the situation of ohmic contact about al electrode, ti / al electrode on n - gan in different annealing conditions are investigated

    主要工作如下: 1 、研究了al單層及ti al雙層極與n型gan在不同退火條件下的歐姆情況,並用挖補圓盤法計算出接觸電阻率。
  12. This average reading removes some of the effect of contact resistance.

    平均讀數法去除了接觸電阻的某些影響。
  13. Electric connectors - contact resistance test procedure

    器.接觸電阻試驗程序
  14. Contact resistance equalizer

    接觸電阻均衡器
  15. Low level contact resistance test procedure for electrical connectors and sockets

    器和插座的低層接觸電阻試驗程序
  16. The sheetary contact resistance is smaller ; the ohm contact resistance is smaller

    接觸電阻越小,歐姆接觸電阻越小。
  17. Measuring method for contact resistance of precious metal electrical contact materials

    貴金屬點材料接觸電阻的測量方法
  18. Test method for dc contact resistance, drop cable to f - connectors and f81 barrels

    F連器和f81筒的分纜的直流接觸電阻的試驗方法
  19. Elements of electrical and optical connection - test methods - contact resistance - low level

    氣和光學連元器件.試驗方法.第201部分:接觸電阻.低等級
  20. Elements of electrical and optical connection - test methods - contact resistance at rated current

    氣和光學連元器件.試驗方法.第202部分:在額定流時的接觸電阻
分享友人