接觸電 的英文怎麼說

中文拼音 [jiēchùdiàn]
接觸電 英文
contact electricity
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 觸 : Ⅰ動詞1 （接觸） touch; contact 2 （碰; 撞） strike; hit 3 （觸動） touch 4 （感動） move sb ; sti...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 觸電 : get an electric shock; electric shock
  1. On the contact resistance between graphite polypropylene composite plate and carbon paper

    聚丙烯復合板與碳紙間的接觸電阻
  2. An electric arc is struck by contacting the electrodes

    接觸電極便擊出電弧。
  3. Tensile properties and impact properties measurements were done at room temperature. the volume resistivity of rectangular samples was measured using a zc36 electrometer and a high 240a voltage supply, for samples with a low resistivity level a dt - 9205b digital multimeter was used, silver paint was applied to ensure complete contact between sample and electrodes, namely, to eliminate the contact resistance. the phase morphology of blends was also studied using a jeol jsm - 5900lv scanning electron microscope ( sem )

    體積電阻率的測定：當r _ v 10 ~ 8時，製成100 100 4mm板材，用zc36型高阻儀測量；當r _ v 10 ~ 8時，用dt - 9205b型數字式萬用表測試試樣的體積電阻，為了減小接觸電阻對測試的影響，採用銀導電膠將銅片粘接在試樣的兩個端面上，靜置24小時，待銀導電膠凝固，試謝長瓊:熱拉仲對pet / pe / cb復合導電體系形態和性能的影響樣的電阻穩定后再測量。
  4. This paper selects dc double - arm bridge, uses the four - port connection to remove the contact and connection resistances and reduce the electromagnetism interfere. grounding grid conductors fault levels are established during a lot of emulational computations, simulative experiments

    使用直流雙臂電橋，採用四端鈕連接法，可大大降低現場中電磁干擾及引線電阻和接觸電阻的誤差影響。
  5. Connectors for electronic equipment - tests and measurements - electrical continuity and contact resistance tests - test 2a - contact resistance - millivolt level method

    電子設備用連接器.試驗和測量.電氣連續性和接觸電阻試驗.試驗2a .接觸電阻.毫伏電壓級方法
  6. Connectors for electronic equipment - tests and measurements - part 2 - 1 : electrical continuity and contact resistance tests ; test 2a : contact resistance - millivolt level method

    電子設備連接器.試驗和測量.第2 - 1部分:電連續性和接觸電阻試驗.試驗2a :接觸電阻.毫伏法
  7. Based on the special load of the contactless system, this paper analyses and contrasts the principle and feature of the series and parallel resonance circuit. design the high frequency full - bridge series resonance converter and make the main circuit apply to the contactless electrical power deliver system and analyses the process of the main circuit in detail

    根據無接觸電能傳輸系統特殊的負載特性，詳細分析並對比了並聯和串聯逆變器的工作原理及電路特點，設計出應用於無接觸系統中的高頻全橋串聯諧振逆變器的拓撲結構，進而設計並製作了系統的主電路，詳細的分析了主電路的工作過程。
  8. In the end, by studying the load character of contactless electrical power deliver system, this paper designs the high frequency full - bridge series resonance converter

    最後，文中詳細分析了無接觸電能傳輸系統的負載特性，進而設計出用於無接觸電能傳輸系統的高頻全橋串聯諧振逆變器的拓撲結構。
  9. Wire clip features easy installation, compact connection, small contact resistance, low temperature and good insulation with outstanding anti - electricity - theft function, which ensures safely and reliability

    線夾安裝方便、連接緊密、接觸電阻小、溫升低、且有絕緣性能良好的防竊電護罩，使用安全可靠。
  10. With four and out, wire clip features easy installation, compact connection, small contact resistance, low temperature and good insulation with outstanding anti - electricity - function, which ensures safety and reliability

    線夾四進四齣、安裝方便、連接緊密、接觸電阻小、溫升低、且有絕緣性能良好的防竊電護罩，使用安全可靠。
  11. In order to improve process quality and increase probability, we optimize ohm contact resistance and breakdown voltage of devices by adjusting process conditions. finally, dc - 500mhz midf switch is fabricated, in which some important conclusions and suggestions are introduced

    工藝研究的重點是改進工藝質量，提高成品率，為此我們通過調整工藝條件來優化歐姆接觸電阻和提高器件的擊穿電壓。
  12. A model of the interface state density distribution near by valence band is presented, and the dependence of the threshold voltage on temperature, the c - v characteristics and the subthreshold characteristics are predicted exactly with this model ; the effects of s / d series resistance on the output characteristics, transfer characteristics and effective mobility of sic pmosfets are analyzed. thirdly, the output characteristics and the drain breakdown characteristics are modeled with the procedure medici. the output characteristics in the room temperature and 300 ? are simulated, and the effects of gate voltage. contact resistance, interface state and other factors on sic pmos drain breakdown characteristics are analyzed

    提出了一個價帶附近的界面態分佈模型，用該模型較好地描述了sicpmos器件閾值電壓隨溫度的變化關系、 c - v特性曲線以及亞閾特性曲線；分析了源漏寄生電阻對sicpmos器件輸出特性、轉移特性以及有效遷移率的影響；論文中用模擬軟體medici模擬了sicpmos器件的輸出特性和漏擊穿特性，分別模擬了室溫下和300時sicpmos器件的輸出特性，分析了柵電壓、接觸電阻、界面態以及其他因素對sicpmos擊穿特性的影響。
  13. The sort, material composite, structure properties and conduction mechanisms of eca ( electrical conductive adhesive ) were discussed in this paper. then three types of ega specimens were designed and made, on which temperature cycles test from - 55 ? to + 125 ? and thermal aging at + 125 ? were carried out. changes of the adhesive strength, eca ' s bulk resistance and contact resistance under the environment stress were summarized and a detailed evaluation on these specimens was given

    本文在全面闡述導電膠的分類組成、物理結構、導電機理的基礎上，設計並製作了三批導電膠樣品，通過對樣品進行長時間的- 55 ? ? + 125溫度循環和125高溫存儲試驗，總結了導電膠粘接強度、體電阻和接觸電阻在環境應力下的變化規律，對三類樣品的長期可靠性做出了全面的評價，並結合導電膠電阻率和「穿流閾值」的計算機模擬，給出了提高導電膠可靠性和電導率的建議，介紹了國內外在高電導率高可靠性導電膠研製方面的一些最新進展。
  14. The influences of vertical grounding electrodes on grounding resistance, step and touch voltages were analyzed numerically

    採用數值計算方法分析了垂直接地極對接地系統的接地電阻、接觸電壓及跨步電壓等的影響。
  15. Always keep hands dry when touching the socket to prevent electric shock

    接觸電掣時，應保持手部乾爽，以免觸電。
  16. It creates the model of layer soil by using the cdegs software, analyses the resistance error which is measured by traditional three - poles way, measures the grounding grids resistance and soil resistance rate of hejin power plant, creates the electromagnetic model of layer soil and grounding grids model of hejin power plant, calculates the step voltage > touch voltage n voltage distribution of earth surface in fault of hejin power plant. in the end, it compares the measuring value and calculating value of grounding grids resistance in hejin power plant

    本文利用cdegs軟體建立分層土壤接地模型，對傳統三極法測量接地電阻誤差進行分析；對河津電廠接地網接地電阻和土壤電阻率進行測量；建立河津電廠分層土壤電磁模型和接地網模型；計算河津電廠接地網電阻和事故狀態下跨步電壓、接觸電壓和地表電位分佈；最後對河津電廠接地網電阻實測值與計算值進行比較分析。
  17. The main work includes three contents as followings : 1, the situation of ohmic contact about al electrode, ti / al electrode on n - gan in different annealing conditions are investigated

    主要工作如下： 1 、研究了al單層及ti al雙層電極與n型gan在不同退火條件下的歐姆接觸情況，並用挖補圓盤法計算出接觸電阻率。
  18. Application of pc104 in untouched electronic measurement

    104在不接觸電法測量中的應用
  19. An experimental system of electro - spray with two different charging methods - inducted by ring electrode and polarized by contacted needle electrode is established. an effective charging equipment for fuel is designed. water and kerosene ' s characteristics of charging and atomization in the electro - spray are measured and analyzed

    2 、建立了環狀感應電極充電和閉式接觸電暈充電的荷電噴霧實驗系統，對煤油和水兩種不同物性介質的荷電特性與荷電霧化特性進行了測量及分析。
  20. The results show that the vertical grounding electrodes can effectively decrease grounding resistance, step and touch voltages of the grounding system and reduce the influence of seasonal factors on the grounding system

    分析表明，增設垂直接地極能有效減低接地系統的接地電阻、減小發變電站的接觸電壓和跨步電壓、減小季節因素對地網安全性的影響。
分享友人
分享到 Line

分享到臉書