接觸面積壓力 的英文怎麼說

中文拼音 [jiēchùmiànjīyālì]
接觸面積壓力 英文
contact area pressure
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 觸 : Ⅰ動詞1 （接觸） touch; contact 2 （碰; 撞） strike; hit 3 （觸動） touch 4 （感動） move sb ; sti...
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  • 積 : Ⅰ動詞（積累） amass; store up; accumulate Ⅱ形容詞（長時間積累下來的） long standing; long pending...
  • 壓 : 壓構詞成分。
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 接觸 : 1. （交往） come into contact with; get in touch with 2. （沖突） engage 3. （挨上; 碰著） contact; touch
  • 面積 : [數學] area
  1. This paper establishes a model simulating dam actual placing process and considering the non - continuity of initial temperature on the boundary of new and old concrete, daily air temperature change, concrete - placing temperature, hydration heat, heat insulation on boundary, water - storing process, placing intermission and curing with water. the calculation of stress field considers the concrete weight, static water pressure, thermal stress, different autogenous volume change between rcc and normal concrete, change of elastic modulus of concrete with age and creep action

    考慮了乞今最為全面的初始條件和邊界條件，包括模擬壩體的實際升程過程，考慮了新老混凝土接觸面上的初始溫度不連續，逐日的氣溫變化，混凝土的入倉溫度，水化熱溫升，邊界保溫，水庫蓄水過程，澆築間歇以及灑水養生等因素；應力場的計算考慮了混凝土的自重，靜水壓力，溫度應力，常態混凝土與碾壓混凝土不同的自生體積變形，混凝土的彈性模量隨齡期的變化以及徐變的作用。
  2. The interface behavior between essence and ethylene - vinyl acetate copolymer pallets was studied so that necessary data were obtained to guide the preparation of fragrant masterbatch. the adsorption type and wettability between essence and the copolymer pallets were analysed by measurements of fourier transform infrared spectrum, surface tension, contact angle and specific surface area. the technical factors affecting absorptivity such as the charge ratio, temperature, pressure and stirring speed were studied by series of adsorption experiments. the results showed that the adsorption of essence on the surface of ethylene - vinyl acetate copolymer pallets is physical in nature. essence couldn ' t moisten the surface of ethylene - vinyl acetate copolymer pallets absolutely, but it could be soaked into the surface of the pallets partly. adsorptivity could be increased by enhancing the temperature, pressure and stirring speed, but the extension of adsorption time had little influence on adsorptivity

    研究了香精與乙烯/醋酸乙烯共聚物粒子之間的界面行為，以便為香型母粒的制備提供必要的理論依據.利用傅立葉變換紅外光譜、表面張力、接觸角及比表面面積等測定手段，分析了香精與載體之間的吸附類型和潤濕作用.並通過一系列吸附實驗，討論了配料比、溫度、壓力、攪拌等工藝條件對吸附量的影響.結果表明，香精在乙烯/醋酸乙烯共聚物粒子表面的吸附為物理吸附；香精無法完全潤濕載體粒子表面，但可以對其形成部分浸潤；提高溫度、壓力、攪拌速度可以增加吸附量，而延長吸附時間對增加吸附量貢獻不大
  3. Abstract : the interface behavior between essence and ethylene - vinyl acetate copolymer pallets was studied so that necessary data were obtained to guide the preparation of fragrant masterbatch. the adsorption type and wettability between essence and the copolymer pallets were analysed by measurements of fourier transform infrared spectrum, surface tension, contact angle and specific surface area. the technical factors affecting absorptivity such as the charge ratio, temperature, pressure and stirring speed were studied by series of adsorption experiments. the results showed that the adsorption of essence on the surface of ethylene - vinyl acetate copolymer pallets is physical in nature. essence couldn ' t moisten the surface of ethylene - vinyl acetate copolymer pallets absolutely, but it could be soaked into the surface of the pallets partly. adsorptivity could be increased by enhancing the temperature, pressure and stirring speed, but the extension of adsorption time had little influence on adsorptivity

    文摘:研究了香精與乙烯/醋酸乙烯共聚物粒子之間的界面行為，以便為香型母粒的制備提供必要的理論依據.利用傅立葉變換紅外光譜、表面張力、接觸角及比表面面積等測定手段，分析了香精與載體之間的吸附類型和潤濕作用.並通過一系列吸附實驗，討論了配料比、溫度、壓力、攪拌等工藝條件對吸附量的影響.結果表明，香精在乙烯/醋酸乙烯共聚物粒子表面的吸附為物理吸附；香精無法完全潤濕載體粒子表面，但可以對其形成部分浸潤；提高溫度、壓力、攪拌速度可以增加吸附量，而延長吸附時間對增加吸附量貢獻不大
  4. As compared with the conventional straight well, the horizontal well can greatly increase the contact area between well and reservoir, change the filtrational mode in the vicinity of wellbore in the reservoir and reduce filtrational resistance, thus obtaining higher oil and gas production by a relatively low producing pressure difference

    摘要同常規的垂直井相對比，採用水平井開采能夠大幅度增加油氣井與油氣藏的接觸面積，改變油氣藏中井筒附近區域的滲流方式，降低滲流阻力，進而可以利用較低的生產壓差來實現更高的油氣產量。
  5. One has to hit in the direction that the edge is pointing at, so that the contact area would be as small as possible to ensure the generation of a large pressure. hence, the target s surface is penetrated and a cut is made

    要斬進的話，刀劍必須向著鋒口所指的方向直線走，與目標物的接觸面積越小越好，以確保產生出最大的壓力，足夠穿過目標物的表面，造成一次成功的斬擊。
  6. Considering the water spraying can effectively increase the contact area between gas and water and promote the hydrate production rate, a batch reactor with water spraying was built in order to experimentally investigate the forming performance of natural gas hydrate, the system ' s state parameters ' variation and its effect on induced time of initial pressure and water temperature

    摘要考慮到水的霧化可以有效提高氣水接觸面積，有助於提高水合物生產速率，設計和建造了一個半間歇式霧流強化水合物實驗裝置，用於探索和揭示噴霧強化天然氣水合物制備過程的基本特性，包括制備水合物的形態特徵，形成過程中參數的變化規律，以及系統初始壓力和初始水溫度對形成過程誘導時間的影響。
  7. By comparing the numerical results of water infiltration with air and without air, it is shown that the method in this paper is more effective for solving problems of water infiltration in unsaturated soil. in this paper the forming process of oil - bearing basin is the main research object and the mathematic model of geology is built, in order to simulate the dynamic forming process of stratums especially oil - bearing stratum in geology history in the time and space concept, further to investigate the history of petroleum forming, transmitting, accumulating and predict the distributing rule and scope of petroleum, and offer an rapid, quantitative, exact, general choice for the researcher of petroleum geology. with denudation, poor - compactness and sedimentation hiatus, the stratum relations of sedimentation section is judged, and the ancient thickness and pressure of stratum layer are recovered by the inversion method of back stripping. the numerical simulation algorithm of recovery of geological history is also given

    為了利用現代化的計算技術再現含油氣盆地的地史演化發育過程，以便進一步定量化研究油氣的生成、運移和聚集的歷史以及預測油氣分佈規律、分佈范圍，為石油地質學家提供一個快速、準確、定量、綜合的研究手段，本文就含油氣盆地的地史演化發育過程為主要研究對象，建立了數學地質模型，運用優化理論與演算法，在考慮了剝蝕、欠壓實、沉積間斷等地質現象的情況下，採用回剝反演法，應用鉆井、測井、地震等方法獲得的地層物性資料，判別沉積剖面中地層的接觸關系，恢復地層的古厚度、古壓力，構造了地史恢復的數值模擬方法。
  8. The fem results indicated that as to the rough surfaces in sliding contact, the value of the contact pressure was very high which coursed a high value of the heat flow rate, meanwhile the sliding time was not enough for the frictional heat to transfer, thus the highest value of the body temperature occurred just on the sliding surfaces, which possessed a sharp thermal gradient in direction perpendicular to the sliding surface. so the great thermal stress was caused just by the sharp gradient and the thermal elastic distortion with which the contact pressure changed occurred simultaneously, thus this change of the contact pressure would affect the temperature distribution in return

    對于相對滑動的粗糙表面，因實際接觸面積小而導致接觸壓力很大，這樣使得熱流密度會很大，同時由於滑動時間很短，熱來不及傳導，最高溫度發生在摩擦表面，在垂直於摩擦面的方向有很大的溫度梯度，使得熱應力很大，且最大應力發生在表面，同時產生熱彈性變形，這種變形使得接觸區域內的壓力分佈發生變化，這種變化又反過來影響了接觸區域的溫度分佈。
  9. It also simulated the influence and relationship in the transfiguration resisting force, coefficient of he transfiguration resisting force, rolling area, rolling temperature, rolling pressure, loop length, the transition between loop length and loop high

    模擬模擬出了變形抗力、接觸面積、溫度、軋制壓力、活套套量、活套套量與套高轉換等各個模型之間的相互影響。
  10. As a main product of our company, spraying drying set is a kind of centrifugal or pressurized, which atomizes liquid materials such as solution, suspension, emulsion or paste into timy droplet ( surface area increased ) and dry them into powder product an once ( several to dozens of seconds ) by contacying hot air

    噴霧乾燥機組是一種用離心式或壓力式霧化器，將溶液、懸浮液，乳濁液或漿料等料液霧化成細微液滴（表面積顯著增大） ，經與熱風接觸得以急速乾燥（幾秒到幾十秒） ，從而直接得到粉末產品的裝置。
  11. Simple and effective coping strategies to alleviate negative emotions associated with the disease outbreak include : stress management to reduce psychological discomfort, accepting that emotional stress in reaction to the occurrence of sudden critical events is normal and allowing the expression of these negative emotions, and sharing these emotions with people having similar experiences or other caring individuals to facilitate mutual support and active management of the situation

    （ 2 ）經常提醒個人因突發性事件而引致的情緒壓力大多是正常的，應讓情緒自然流露，不要過份抑壓自己的感受；及（ 3 ）嘗試接受別人的關心，向一些願意聆聽的人傾訴，或與有類似經歷的人接觸，互相關懷扶持，及互相鼓勵積極面對有關事件。
分享友人
分享到 Line

分享到臉書