控制的結構 的英文怎麼說

中文拼音 [kòngzhìdejiēgòu]
控制的結構 英文
changing of the control
  • : 動詞1 (告發;控告) accuse; charge 2 (控制) control; dominate 3 (使容器口兒朝下 讓裏面的液體慢...
  • : Ⅰ動詞1 (製造) make; manufacture 2 (擬訂; 規定) draw up; establish 3 (用強力約束; 限定; 管束...
  • : 4次方是 The fourth power of 2 is direction
  • : 結動詞(長出果實或種子) bear (fruit); form (seed)
  • : Ⅰ動詞1 (構造; 組合) construct; form; compose 2 (結成) fabricate; make up 3 (建造; 架屋) bui...
  • 控制 : control; dominate; regulate; govern; manage; check; cybernate; manipulate; encraty; rule; rein; c...
  • 結構 : 1 (各組成部分的搭配形式) structure; composition; construction; formation; constitution; fabric;...
  1. A novel control structure model based on cloud model is proposed for the first time

    摘要首先提出一種新型雲模型模型。
  2. Combining with the performances of danshan bridge, discussing the methods on the construction controlling and calculation of cable - stayed bridge, this paper raises an efficient construction controlling system, and realizes collecting construction data of the real bridge and technical information. by analyzing on the difference of theoretical calculation and real construction state, the author determines to take self - adapting construction controlling method which uses kalman filter method to identify and adjust construction parameters. by getting rational construction state from forward iteration method, this paper, taking concrete creep effect in consideration, raises a rational scheme to pre - remain deformation and adjust cable force

    合丹山橋特點,通過對斜拉橋施工計算方法探討,提出了有效施工系統,實現了對實橋施工數據和技術信息採集;通過分析理論計算與實際施工狀態差異,確定了以卡爾曼濾波法作為施工參數識別與調整自適應施工方法;通過正裝迭代法確定其合理施工狀態,並考慮混凝土徐變效應,提出了合理預留拱度和索力調整方案。
  3. After establishing induction motor simulation model with iron loss, this paper has investigated effect of iron loss and proposed two schemes to compensate estimated error due to iron : one modified the structure of controller, the other modified the structure of observer, both schemes eliminated the detuning effect of iron

    對于鐵耗影響,本文建立了考慮鐵耗感應電機模擬模型后,研究了鐵耗造成估計誤差,並利用兩種方法對誤差進行補償,一種是修改方法,另一種是修改觀測器方法,最終都較好地消除鐵耗對速度估計影響。
  4. Firstly, according to the natural geology study of the quarry, the control structure planes are determined, which are cut to be building blocks by two sets of main joints. failure can occur due to the intensity weaken of the joint planes caused by excavation relief and rain immersion

    首先研究了采場自然地質條件,確定了影響邊坡穩定面,即塊體主要由兩組節理切割而成楔形體,由於開挖卸荷及雨水浸泡,致使節理面強度減弱而發生破壞。
  5. It is necessary to perfect the laws and regulations about mbo and make it legislatorial. part is about the qualitative analysis of the management buy - out. mbo is one of the a & m measures that manager who loans money to buy stock shares of his own corporation so as to change the ownership structure of the corporation and gain anticipated interests

    本文首先對管理層收購進行定性分析,認為管理層收購是管理層利用自有資金或外部融資來購買其所經營公司股份,以此完成由單純公司管理者到股東法律地位轉變並進而改變公司所有權商事行為。
  6. The half analytic formula is reasoned out, which is applied to the sensitivity analysis on design parameters. through the sensitivity analysis of design parameters in constructing phase of nanpu bridge, the main design parameters are confirmed. based on this, the real value of parameters are identified by least square method, by this token, the error of design parameters can be eliminated in the process of construction control

    為了減小鋼管混凝土拱橋施工過程中施工誤差,本文推導出了用於設計參數敏感性分析半解析公式,並對南浦大橋各施工階段參數進行了敏感性分析,從而確定出該橋主要設計參數,在此基礎上,利用最小二乘法對這些參數進行識別,估計出各參數真實值,以消除施工設計參數誤差。
  7. The thermal crack problem of the mass concrete is very complicated, and correlative with structure, building material, construction, rock, circumstance, and so on. now, in the construction field, the research on the mass concrete used during hydraulic construction is more frequent than the others, white the research on the comparatively small mass concrete used in the normal buildings is not deep enough and comprehensive, the covering area in the related codes are limited and narrow. many problems in construction practice have to be solved by the experience, rather than by theory. this phenomenon leads to much unnecessary waste of labor, material and financial resources, also the quality is unsatisfactory

    建設領域目前對水工建築中所使用大體積混凝土(巨型混凝土)研究較多,而對普通建築中所使用體積相對要小很多大體積混凝土(相當于中體積混凝土)研究卻還不夠深入、全面,相關規范條文覆蓋面還不夠完善,對很多工程實踐中問題只能依靠經驗處理,缺乏適當理論依據,這使得在工程實踐中造成許多不必要人力、物力、財力浪費,大體積混凝土施工質量果也不很理想。
  8. And then the paper processes all - around analysis of dnc system and brings forward three hierarchies control body of operation mode of workshop in dnc system. at the same time, the paper processes designing of all - around project by this mode

    然後對dnc系統進行了總體分析,提出了三層dnc系統企業車間運行模式,並依據該運行模式對dnc系統進行了總體方案設計。
  9. Then on the basis of calculating result from the prefigurative deviation control structure calculation, " rational data forecast processing about error adjust in prefigurative deviation control was made by the prefigurative theory of bp neural network and corresponding program and software matlab6. 1. at last via the data comparison with the practical survey data draw a conclusion : it is feasible for the construction prefigurative deviation control and error adjust used in pc rigid frame bridges to use the calculation model and program brought forward in this paper

    同時,在對預應力混凝土剛橋施工過程線形預拱度控制的結構計算分析基礎上,利用bp神經網路預測理論和相應程序及軟體包matlab6 . 1對預拱度誤差調整進行了較好預測處理,通過與實際施工數據及成橋后測量果作分析比較,得到論:運用本論文計算模型和程序對預應力混凝土剛橋預拱度過程進武漢理工大學碩士學位論文行分析和誤差調整處理是可行。
  10. In this essay the technique of the structure calculation and error adjustment measures used in bridge construction prefigurative deviation control was researched based on the construction control and monitor project of wuhan caidian han river bridge

    本文主要合蔡甸漢江公路大橋施工監測監項目,研究施工預拱度控制的結構計算和誤差調整方法。
  11. After that, the paper makes a relatively profound study analysis of the structure calculation and error adjust forecast technique used in pc rigid frame bridges construction monitor and control, and comprehensive analyzes of the influence factors in building the bridges, based on the engineering practice

    本論文其後部分主要是從工程實際出發,對預應力混凝土剛橋施工過程線形預拱度控制的結構計算分析和誤差調整預測方面作了較為深入研究,對預應力混凝土剛橋施工過程影響因素作了全面分析。
  12. The new fnn controller not only has the fuzzy controller ' s characters of simple structure and easily - used, but also has the self - study ability of the elman network. thus it is valuable for research for non - linear system. in this paper, it summarizes the development of dc - dc converter firstly, and presents a new idea which is using fuzzy - neural network in dc - dc converter

    這種串聯型模糊神經網路具有模糊控制的結構簡單、設計簡便及使用方便特點,同時又利用了人工神經網路聚類功能,使整個器又具備人工神經網路自學習能力,因此這種串聯型模糊神經網路具有了良好智能功能,特別適合於在非線性系統中應用。
  13. In the control scheme using neural network, the control of flexible manipulator is separated into angle - following control of slow subsystem and vibration - suppressing control of fast subsystem based on singular perturbation and time decomposition. moreover, the paper discusses the structure and the algorithm of neural network plus fuzzy pd control of tip vibration. finally the performance of designed methods is validated by simulation

    對于神經網路,首先根據奇異攝動和兩時標分解,將柔性連桿機械臂分解成等效剛性臂慢子系統角跟隨運動和快子系統消振,論文給出了神經網路+末端振動模糊pd控制的結構和計演算法,並通過實驗研究驗證了提出設計方法性能。
  14. 2. an introduction of the basic principles of the neuron model - free control and the basic design methods of the fuzzy controller is given

    介紹了神經元非模型控制的結構和基本原理及模糊設計兩種基本方法。
  15. The design theory of neural networks is discussed, including the basis principles of neuron control and the design of back - propagation network. 4

    探討了面向神經元網路設計理論,包括單神經元控制的結構和基本理論及bp神經網路設計; 4
  16. It backups more of user, more stronger data engine, more cheaper maintenance cost especially for internet / intranet mechanism which make network management for material current and e - commerce be possible

    其主要特點是具有多層控制的結構,能支持更多用戶,有更強大數字引擎,特別對于internet機有著更為廉價系統維護成本。
  17. Therefore, combining single - variable dmc with cascade control can form dmc - pid cascade control, which can retain structure characteristic of cascade control as well as performance virtue of predictive control

    因此,把單變量dmc和串級合,形成dmc - pid串級,既能保持串級控制的結構特點,又能保持預測性能優點。
  18. In this thesis, in order to improve the performances of fuzzy controller, a hybrid structure of fuzzy pid controller is proposed and a systemic parameter optimal method based on the pso ( particle swarm optimization ) is introduced

    本文對如何提高模糊性能以及系統化參數設計問題進行研究,提出了一種模糊pid控制的結構,並且首次將微粒群優化演算法( pso )應用於模糊參數優化設計。
  19. We discuss structure of the end - to - end congestion control schemes with active queue management ( aqm ) in ip network from the control theoretic point of view. and propose a fuzzy logic based aqm which can improve the robustness of the control algorithms. give out the detailed simulations

    本文從擁塞角度出發,強調路由器隊列管理在系統地位,並從閉環角度出發,描述擁塞控制的結構,研究主動隊列系統模型,設計了一種用於主動隊列管理( aqm )模糊器,模擬證明了這種aqm演算法有效性。
  20. This dissertation has studied the structural model and model predictive control ( mpc ) algorithm that was first implemented for the structural vibration control of the tall building under earthquake excitation. based on analyzing structural motion equation and the state space form equation of the earthquake - excited structural model of the tall building, predictive model and control objective functions are defined and the mpc system of the tall building is set up

    本文主要研究高層建築振動控制的結構模型和預測演算法,首次將預測應用到高層建築地震反應中,在分析受地震波激勵高層建築模型運動方程及其狀態空間形式方程基礎上,確定預測模型和目標函數,建立高層建築預測系統,從理論上對預測在高層建築振動應用進行研究。
分享友人