控制通氣 的英文怎麼說

中文拼音 [kòngzhìtōngqì]
控制通氣 英文
cv controlled ventilation
  • 控 : 動詞1 （告發;控告） accuse; charge 2 （控制） control; dominate 3 （使容器口兒朝下 讓裏面的液體慢...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 通 : 通量詞（用於動作）
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 控制 : control; dominate; regulate; govern; manage; check; cybernate; manipulate; encraty; rule; rein; c...
  1. This paper discusses the designing and making of the dynamic testing systems of engine electronic control system. base on the construction and operation principle of santana 2000gsi m3. 8. 2 engine electronic control systems, design and manufacture led circuit of dynamic testing and fault imitating electronic control unit. on the inspect board, design and equip with motronic 3. 8. 2 ecu i / o measuring joints, design and set up obd - ii diagnostic communication link, design and install fuel pressure inspecting meter. depend on the obd - ii diagnostic communication link and ecu i / o measuring joints, this dynamic testing system can inspect engine electronic fuel injection system, distributorless ignition system, idle speed control system and evaporative emission control system, and can inspect m3. 8. 2 sensors, ecu and actuators, and can interrogate fault memory and erase fault memory ; and can analyse data stream ; and can carry out fault imitating. besides, this paper analyses sensors and actuators typical fault w aves

    2電控單元電路連接器設計製成輸入輸出電子控制檢測端子，並在檢測面板上布置了obd -診斷插座和燃油壓力表。使該動態測試系統能實現對電噴發動機的燃油系統、直接點火系統、怠速控制系統和燃油蒸氣排放控制系統的動態檢測；並通過obd -診斷座、 ecu輸入輸出檢測端子和故障模擬處理單元實現對電噴發動機電控系統各傳感器、電控單元、執行器進行故障碼讀取與清除；動態數據讀取和波形測試和故障模擬等。此外，本論文還分析了傳感器和執行器典型故障波形。
  2. The research status of the world diesel exhaust aftertreatment technology is summarized systemicallyo at the same time, the development status and problems about oxygenation catalysis converter and particulate filter are analyzed on the basis of mentioned informations, we bring up a diesel exhaust cleanse system, that adopts the technique course of catalysis conversion combining particulate collection and regeneration the system collects exhaust particulate by means of efficacious filtering material it can oxidize ho co and macromolecule solvable organic via catalyst and diesel oil additive enhanced temperature will partly oxidize collected particulate and ultimately achieve the aim of exhaust reduction, after processing system frame design and trial matching, it ' s detected that the system can surely cleanse gas exhaust and particulate in addition, gas - ejected combustion - supporting regeneration for diesel particulate filter is also researched, we have rudimentarily designed the software and hardware of the g as - ejected combustion - supporting system having processed a series of trials, we discover the rules of the system credibly working these rules demonstrate the right direction for researching gas - ejected combustion - supporting regeneration technology

    本文系統地介紹了國內外柴油機排氣后處理技術的研究現狀，分析了氧化催化轉化器和微粒捕集器的發展現狀及存在的問題，以此為基礎，提出了一種柴油機排氣凈化系統，該系統採用催化轉化與微粒捕集及再生相結合的技術路線，通過過濾材料的有效過濾，將排氣中的微粒進行收集，藉助于催化劑和柴油添加劑使排氣中hc 、 co及高分子可溶性有機物氧化，產生的高溫使得收集到的微粒部分氧化，從而達到降低排放的效果。通過系統結構設計和試驗匹配，實現了對氣體排放物和微粒的凈化。同時，論文中還進行了柴油機微粒捕集器噴氣助燃再生的研究，初步設計了噴氣助燃系統，進行了控制系統軟、硬體的開發，通過正交試驗，摸索出了噴氣助燃系統可靠工作的一般規律，為噴氣助燃再生技術的開發提供了方向。
  3. The total volume of gas accumulator can be controlled by changing the number of gas accumulators, and the stiffness of hydropneumatic spring can be controlled furthermore

    通過改變連通儲氣室數目的方法實現對儲氣室總容積的控制，油氣彈簧的剛度特性也因此得到控制。
  4. By arrangement of the control channels through which the hydraulic fluid flows from the discharge chamber into the oil reservoir, this allows any gas bubbles being released from the hydraulic fluid during the suction stroke to be expelled into the oil reservoir

    通過液壓油經控制通道由排出腔流入油槽的這種布置，使得任何在吸入沖程從液壓油中釋放出來的氣泡都被排到油槽中。
  5. Second, on account of the block of gas channel we designed a gas channel system, through which the hydrogen can flush the gas channel after the reaction by the control of valves

    針對以前氣路堵塞的問題設計並製作了氣路系統，使氫氣在反應后能夠通過閥門控制對氣路進行沖洗。
  6. A pid controller based on artificial neural network was designed to control the flow - rate of oxygen and the recycled exhaust gas. good control effects were obtained through simulation

    設計了基於單神經元的pid控制器對閉式循環柴油機的氧氣流量和廢氣再循環量進行了控制，通過模擬得出了較好的控制效果。
  7. In 1970, american motors was granted special permission to purchase emission control technology from gm.

    1970年，美國汽車公司獲得許可從通用汽車公司那裡購買控制排氣的技術。
  8. Automatic control : the machine is programmable to run subject to the technique requirements and controlled by a set of equipment like plc, touch - screen monitor, frequency converter, dynamic braking, air - powered or hydraulic system programs are modifiable with individualized interface

    自動化人機界面控制：通過plc ，觸摸屏、變頻器控制、能耗制動、氣動或液動系統，機器可按工藝要求設計相應的工作程序，並按所設定的程序自動運行，採用先進的應用程序，可以更方便的修改程序。
  9. According to the physical model, a mathematical model and computational method were proposed. an axially symmetric transient thermal conduction equation was put forward, which included material pyrolysis, pyrolysis gas flow and chemical reaction in charred layer. chemical reaction was controlled by chemical dynamics, and the reaction rate was computed using arrhenious equation

    針對物理模型提出了相應的數學模型和數值計算方法，在材料內部建立了二維軸對稱的非穩態導熱控制方程，其中加入了材料熱解、熱解氣體流動以及炭化層內的化學反應等因素的影響，化學反應由化學動力學控制，通過arrhenius公式確定其反應速率。
  10. Scvnt speed control vent

    速度控制通氣口
  11. Through the analysis of factors that affect the gas - project construction costs and the gas - construction market, it finds out the several important approaches to control and reduce the gas - project construction costs

    通過對燃氣工程建設費用構成中影響工程造價的各個因素進行剖析以及對燃氣工程建築市場的分析，找出降低和控制燃氣工程建設成本的幾個重要途徑。
  12. So the pressure signal of control air holds the single - acting cylinder at the stop position through the pipe named “ supply ”, the 3 - way valve ( pos. no. 22, upper frame ), the double check valve ( pos. no. 72 - 1 ) and the quick release valve ( pos. no. 41, right frame )

    因此控制空氣的壓力信號保持單作用氣缸在停止位置通過管路supply ，三通閥22 ，上位，雙向止回閥72 - 1和快速泄放閥41 ，右位。
  13. The 3 - way magnet valve ( pos. no. 77 ) is never energized again ( upper frame ), but if the cause of deenergizing is eliminated and the electric circuits of the engine protecting system are reset, the 3 - way magnet valve ( pos. no. 77 ) is energized ( upper frame ), then the control air which has actuated the single - acting cylinder ( pos. no. 21 ) being rapidly blown off through the quick release valve ( pos. no. 41 )

    三通電磁閥77決不會再次通電上位，但如果斷電的原因被消除而且主機安保系統電氣迴路被復位，三通電磁閥77被通電上位，作用在單作用汽缸21的控制空氣已被迅速放出通過快速泄放閥41 。
  14. By deenergizing of coil, control air moves the single - acting cylinder to the stop position through the pipe named “ supply ”, the double check valve ( pos. no. 72 - 2 ), the 3 - way magnet valve ( pos. no. 77, lower frame ) and the 3 - way valve ( pos. no. 78, lower frame )

    通過其線圈斷電，控制空氣移動單作用汽缸到停止位置通過supply管路，雙向截止閥72 - 2 ，三通電磁閥77下位和三通閥78 ，下位。
  15. Measurement and control ; electrical measuring instruments ; printing devices for multi - channel strip chart recording instruments

    測量和控制.電氣測量儀.多通道帶狀紙記錄儀的列印裝
  16. By deenergizing of coil, the control air actuates the 3 - way valve ( pos. no. 29 through the pipe named “ supply ” and the 3 - way magnet valve ( pos. no. 73, right frame )

    由線圈的斷電，控制空氣促動三通閥29通過supply管路和三通電磁閥73右位。
  17. Characters including : fuel atomization device replaced by gas sprayer, gas supply controlled by gas flux valve ; separate fuel supply from combustion - supporting air, regulate air supply through changing the electioneering voltage to make the fully burning and improve efficiency and reduce fuel consume ; arts and crafts are simple, the modification of the oil heater ' s configuration is little and the heating power is not below the oil heater ' s level ; because of falling the voltage of electioneering, greatly descend the noise of the sample machine compared with the original

    其特點是：以燃氣噴頭替代原機燃油霧化裝置；以燃氣流量控制閥控制燃氣的供給；燃氣的供給與助燃空氣的供給相分離；通過改變主電機的電壓，調整空氣的供給量，使燃燒更加充分完全，並進一步提高了熱效率，降低了燃料消耗；工藝簡單，對原機型改動較小；樣機的加熱功率不小於原機型水平；此外，由於主電機電壓的降低，使樣機的整機噪聲比原機大大下降。
  18. We use the full - distributed control technology as the basic control mode, and distributed the control system of the pneumatic servo sub - system and the electrical servo sub - system. also, we coordinate them through can - bus. the experiment results have proved that it is a good solution for the mixed - driven system

    論文採用完全分散式控制技術，將氣動伺服與電動伺服分散控制，通過can總線實現氣動伺服與電動伺服之間的協調，很好解決了混合驅動問題。
  19. Taking beijing metro line 4 as an example, this paper discusses three important questions in view of system design and operation management, that is, how to select heating ventilation and air conditioning system and its parameters, how to choose the type of standby equipment and its energy - saving running mode, and how to control the fume effectively without causing any negative effects during the fire

    摘要以北京地鐵4號線工程為例，對通風空調系統的選配與參數確定、兼用設備的選型及節能運行、火災發生后如何有效地控制煙氣並避免產生負效應的三個關鍵問題進行探索，旨在為系統設計、運行管理提供有益的啟示。
  20. The control air is supplied to the p. g. governor at the proper rate reduced by the pressure reducing valve ( pos. no. 35 )

    如果你打開此開關，三通電磁閥34動作，控制空氣通過三通電磁閥被傳送到p 。 g 。調速器代替掃氣空氣。
分享友人
分享到 Line

分享到臉書