插入損耗 的英文怎麼說

中文拼音 [chārùsǔnhào]
插入損耗 英文
il insertion loss
  • 插 : 動詞1. （把細長或薄的東西放進、擠入、刺進或穿入; 插上; 插進） stick in; insert 2. （中間加進去; 加進中間去） interpose; insert
  • 入 : Ⅰ動詞1 （進來或進去） enter 2 （參加） join; be admitted into; become a member of 3 （合乎） conf...
  • 損 : Ⅰ動詞1 （減少） decrease; lose 2 （損害） harm; damage 3 [方言] （用尖刻的話挖苦人） speak sarcas...
  • 耗 : Ⅰ動1 （減損; 消耗） consume; cost 2 [方言] （拖延） waste time; dawdle Ⅱ名詞1 （壞的音信或消息） ...
  • 插入 : insert; infix; run in; break in; patch; insertion; plug in; intercalate; intercalation; intromiss...
  • 損耗 : 1. （損失消耗） loss; wear and tear; deterioration; waste 2. [商業] wastage; spoilage
  1. Commercial building telecommunications cabling standard - part 2 : balanced twisted - pair cabling - addendum 3 - additional considerations for insertion loss and return loss pass fail determination

    商用建築電信電纜敷設標準.第2部分:對稱雙絞合線電纜敷設.補充件3 .插入損耗和回波損耗通過失效確定的附加考慮要素
  2. 3 high frequency signal low insert loss, high isolation, high flatness index inside

    3高頻信號插入損耗低隔離度高帶內平坦度指標高
  3. Method of insertion loss measurementsfor passive radio interference filter units

    無源無線電干擾濾波器插入損耗測量方法
  4. At the same length, the insertion loss of different sub - channels also undergoes changes. this effect, along with the intrinsic background noise, impulse noise and the receiving sensitivity of modem on the adsl, will limit the maximum transmission distance on one single subscriber line

    首先，銅線的插入損耗將隨著線路距離的增加而成比例地增加，並且在同一距離下各子通道的插入損耗也發生變化，這個因素和線路固有的背景噪聲、脈沖噪聲、數據機的接收靈敏度一起將限制在單用戶線上adsl所能夠傳輸的最大距離。
  5. The low insertion loss is achieved by optimizing the transistor widths and bias voltages, by minimizing the substrate resistances, and by dc biasing the transmit and receive nodes, which decreases the capacitances while increasing the p1db

    通過優化mosfet的柵寬及偏置電壓可以降低插入損耗。在版圖設計中通過增加襯底接觸降低襯底電阻，從而減小插入損耗。另外，為接收和發送端提供直流偏置可以降低p1db 。
  6. Second, the insertion loss is low. third, the attenuator range is big. at last, the device can work well in a large temperature range

    經過測試，器件的技術指標比較理想：器件能夠實現單模傳輸；插入損耗比較低；衰減范圍比較大；能在較大的溫度范圍內工作。
  7. In the paper, the transition of ka band rectangular waveguide to micro strip probe and the back - to - back structure are designed. the measurement results indicated the low insert loss and low return loss from 35 ghz to 40 ghz

    本文設計了ka波段矩形波導到微帶探針過渡結構以及背對背結構，測試結果表明，在35 40ghz頻率范圍內，其插入損耗和回波損耗都比較小。
  8. As an planar waveguide component, it has many advantages, such as its small size, lower cost per port, the relatively low insertion losses, potential for volumn production and integration with active elements

    作為一種平板光波導型波分復用器， awg具有很多優點：體積小，可批量生產；高通道數，大小可壓縮；較低的插入損耗；單個通道的成本低；還可以與其它功能整合。
  9. Fiber optics - interconnection device insertion loss test

    纖維光學.互連接裝置插入損耗試驗
  10. The loss of coplanar wave - guides ( cpws ) on ps / ops layers with thickness about 10, and 70um respectively on low - resisitivity ( o. olflcm ) si has been studied, which are expected to increase the substrate resistivity and then to reduce its effective dielectric loss under the microwave operation

    01隻cn : ） _ l生長的多孔硅/氧化多孔硅厚膜為襯底制備的共平面波導（ cpw ）的微波插入損耗特性，其介質膜的厚度分別是10腳和70腳。
  11. The tbc algorithm simulates that wave near the boundaries is plane wave, and its amplitude and direction are decided by trial and error. in this thesis, the operation principle of an awg is introduced and the structure parameters of 8x8 awg with its central wavelength 1550. 12 / 7 / n and channel spacing 3. 2nm are designed by discussing the crosstalk to neighboring waveguide, the insertion losses and losses equal, etc. this thesis employs the waveguide theories to analyze the slab waveguide and the arrayed waveguide, and offers the distributions of stable optical fields

    本文旨在設計一個中心波長為1550 . 12nm 、波長間隔為3 . 2nm的8 8awg波分復用器，通過綜合考慮相鄰波導間的最大串擾、插入損耗、通帶寬度以及各通道損耗均勻等指標來設計、優化awg的各個結構參數，如輸入、輸出波導和波導陣列中相鄰波導的間隔，平板波導的聚焦長度，波導陣列中相鄰波導的長度差等。
  12. Finally, it takes a detailed test to the processed millimeter 4 - bit digital phase shifter. the test result is better than expectant guideline : the maximum of the phase error is 10, the insertion loss is better than 10. 74db, the return loss is more than - 14. 88db in the 33. 9ghz 34. 5ghz frequency band. the whole volume of the phase shifter is 80mm 35mm 20mm

    最後，對加工出的毫米波四位數字移相器進行了測試，測試結果完全達到了預定指標要求:在所要求的33 . 9ghz 34 . 5ghz頻帶內，最大相移誤差小於10 ，插入損耗小於10 . 74db ，輸入輸出回波損耗大於- 14 . 88db ，整個電路尺寸為80mm 35mm 20mm 。
  13. Several simulations for the designed phase shifter were performed in hp - ads. various factors were considered in influencing the insertion loss and the phase shift of the phase shifter. some effective measures were put forward to improve its performance

    採用高頻電磁模擬軟體hp - ads對設計的移相器進行模擬，分別考察了移相器各組成部分對插入損耗和移相度的影響，並提出了改進移相器性能的措施。
  14. The tests of e - o applications by our flux ktp has been realized, the results showed : optical waveguides fabricated by using an ion - exchange process, which have an exchange - ion concentration depth profile and refractive - index profile, is close to a complementary error - function distribution, optical homogeneity and device thermal stability is much better. amplitude modulation switch formed by our flux ktp has the contrast ratio of 150 : 1 and insert loss is 2. 5 % at 1064 nm. high quality optical pulse with 1 ns width was cut successfully by using an e - o modulator from a laser pulse with 50 ns width, this modulator had run for three years, and the crystal did n ' t blackened, it showed our low conductivity flux ktp can endure high modulation voltage for a very long time

    Ktp晶體的電光應用試驗表明：用離子交換法製作的電光波導，其離子交換濃度、折射率變化符合餘弦誤差函數，光學均勻性以及器件的溫度穩定性較好；製作的強度調制電光開關，消光比為150 ： 1 ，對1064nm激光的插入損耗為2 . 5 ；製作的電光調制器用於激光脈沖整形試驗，從脈沖寬度50ns的激光脈沖削出脈寬1ns的高質量光脈沖，該電光開關經過長達三年多的使用，沒有出現晶體變黑現象，說明本實驗的低電導率ktp晶體能夠耐受長時間的調制電壓。
  15. This paper introduces a kind of technology, by which a new type of polarization delay structure is used to manufacture narrow - channel - interval interleavers, which arc characteristic of small in insertion loss, polarization dependent loss and polarization mode dispersion, and easy in assembly

    文章介紹了一種利用偏振延遲結構製作窄通道間隔的梳狀分波器的技術，使用該技術製作的梳狀分波器具有插入損耗低、偏振相關損耗低、偏振模色散小且組裝方便等特點。
  16. Comparing to fet phase shifter, the pin phase shifter has better performance in insertion loss and cost, so that the pin digital phase shifter is aboard applied in all kinds of phased - array radar system

    與fet移相器相比， pin管移相器插入損耗等指標通常更好、性價比也較高，因此被各種相控陣雷廣泛應用。
  17. Test items : insertion loss ; disturbance voltages ; radiated electromagnetic disturbances ; harmonic current ( emission )

    電磁兼容檢驗項目：插入損耗；騷擾電壓；輻射電磁騷擾；諧波電流。
  18. We have demonstrated a novel voa based on high birefringence fiber loop mirror, which has many advantageous characteristics such as a simple structure, high flexibility, polarization independence, low insertion loss and low price, etc. experimental proof shows that it is convenient to realize the control of optical power by using this voa

    2 .利用雙折射光纖環鏡設計並製作了一個結構簡單的可調諧光纖衰減器，具有靈敏度高，偏振無關，低插入損耗和低成本等特性。實驗證明它可以很方便的控制光功率。 3 .提出了一種由布拉格光纖光柵和高雙折射光纖環鏡共同構成波長選擇器件的摻鉺光纖激光器。
  19. Because the contact resistance between the metal contacts and the superconducting films has large impact on the performance of superconducting filters, we experimental techniques. after annealing the optimum temperature and, we got the minimum contact resisitivity. we also further studied the interaction between ag and ybco films after annealing at a certain temperature and attempted to give an explanation and discussion

    金屬接觸電極與超導薄膜之間的接觸電阻對超導濾波器的插入損耗有很大影響，因此，本文通過多種實驗方法，系統的研究了ag與ybco超導薄膜之間的接觸電阻問題，得到了最佳退火溫度，並對退火時ag與ybco超導薄膜之間相互作用的機理進行了研究和探討。
  20. Compared with the similar research results, the weighted control ic here has the following characteristics : ( 1 ) the circuit structure is simpler ; ( 2 ) the chip ' s fabrication is compatible with standard cmos process ; ( 3 ) n - mosfets with high w / l ratio and short channels are used for weighting and output to reduce the insertion loss ; ( 4 ) the weighting factor varies in a relatively wide range with the controlling signals ; ( 5 ) input and output impedance approach 50 in low frequency ( e. g. 50mhz ), while in higher frequency they slightly deviate from 50, hence the energy reflection lower than 0. 1 ; ( 6 ) it completes the functions of sampling, weighting, controlling and summing of high frequency analog signals

    它的加權控制電路與已報道的相關電路相比具有如下特點：電路結構簡單；製造工藝與普通cmos工藝兼容：短溝道，高寬長比的nmos晶體管具有低的通導電阻，將其作為加權、輸出器件可降低由電路引起的插入損耗；改變加權信號，可實現權值在較大范圍內的連續變化；輸入、輸出阻抗在低頻（如50mhz ）下接近50 ，而在高頻下略有偏離50 ，但反射系數均低於0 . 1 ；實現了對高頻信號的取樣、加權、控制、疊加功能的迭加。
分享友人
分享到 Line

分享到臉書