撓曲裂縫 的英文怎麼說

中文拼音 [náoqūlièféng]
撓曲裂縫 英文
flex-crack
  • 撓 : 動詞1. （輕輕地抓） scratch 2. （擾亂;阻止） hinder 3. （彎曲,比喻屈服）yield;flinch:不屈不撓indomitable; unyielding
  • 曲 : 曲名詞1 （一種韻文形式） qu a type of verse for singing which emerged in the southern song and ji...
  • 裂 : 裂動詞[方言] （東西的兩部分向兩旁分開） open
  • 縫 : 縫名詞1. （接合處） seam 2. （縫隙） crack; crevice; fissure; slit
  • 裂縫 : 1. （裂開的縫兒） rent; rip; hiatus; tear; rift; crevice; crack; fissure 2. [地質學] fracture; rupture
  1. First, using strip - partitoning method and programming in matlab language, the numerical caculations of the relation curve between moment and curvature are done for the beams strengthened with non - prestressed and pretressed cfrp sheets, base on the assumption of plane section, non - bonding slip and non - peeled destroy. secondly, nolinear finite elemeant analysis by ansys are done for the beams strengthened with prestressed cfrp sheets base on the three assumptions before mentioned, the analysis are all done for the relation curve between load and displacement, the distribution of material stress, the distribution of cracks. lastly, calculation formula of flexural capacity and deflection are proposed

    ）的全過程關系曲線。其次基於上面的三個假定，選擇合理的本構關系，利用ansys通用有限元分析程序對預應力碳纖維布加固梁進行非線性有限元分析，分析了加固梁的荷載-撓度關系、材料的應力情況、裂縫的分佈情況等。最後提出了承載力計算公式和正常使用狀態下撓度計算公式。
  2. As soon as the normal section cracks, the crack firstly appears in the flexural region. at this moment, the load - deflection curve has a turning point. with the increase of the load, the rigidity of the beam decreases compared with that before cracking because of the development of cracks in flexural region, and the formation and development of diagonal cracks toward the loading point, the load - deflection curve is basically linear till the beam fails

    正截面開裂前，荷載撓度曲線基本為線性，截面剛度較大；正截面開裂時，裂縫先在純彎段出現，荷載撓度曲線出現轉折點，隨著荷載的增加，純彎段正裂縫的發展以及剪跨段斜裂縫的產生並向梁的受壓區加荷點發展，使梁的剛度較截面開裂前減少，荷載撓度曲線也基本為線性直到梁破壞。
  3. Nonlinear constitutive relations are discussed for analyzing the stress distribution, the appearance and development of the cracks, as well as the behavior of the boundary conditions of the two way slabs respectively. in the light of the experimental research on r. c. two way slabs under static loading, the behavior of yield line, the load deformation curves and the crack yield, plastic limit loads of slabs with different supporting conditions are studied

    根據反映雙向板混凝土材料非勻質性的本構關系，分析了雙向板在荷載作用下的變形、屈服、裂縫和破壞的形態特性，並對鋼筋混凝土雙向板在不同支承條件下的塑性極限荷載、正常使用撓度（曲線）和截面設計作了進一步研究。
  4. Through the experimental and theoretical analyzing results, the conclusion can be summarized as follows. 1 ) the yielding load and ultimate bearing capacity of the beam are not affected by the value of the load under that load the cfrp sheets were retrofitted, but the value will affect the stiffness of the beam, especially the average tangent stiffness after rebar yielding. 2 ) the stiffness of cracked beams retrofitted with cfrp sheets is larger than that of the normal rc beams

    通過試驗結果分析發現，採用cfrp加固的鋼筋混凝土梁的剛度較普通鋼筋混凝土梁的剛度有明顯提高，纖維布對承受以抗彎為主的構件具有增強剛度、控制撓度的作用；纖維加固時梁所承受的荷載大小，即加固時梁內已存在的彎曲裂縫的寬度對梁的屈服荷載及極限承載力影響不是很大，但對梁的剛度有較大影響，特別是對縱筋屈服后的剛度影響較大。
分享友人
分享到 Line

分享到臉書