擰緊力矩 的英文怎麼說

中文拼音 [nǐngjǐnlìjǔ]
擰緊力矩 英文
anziehdrehmoment
  • 擰 : 擰形容詞[方言] （倔強） pigheaded; stubborn
  • 緊 : Ⅰ形容詞1 （物體受到幾方面的拉力或壓力以後呈現的緊張狀態） taut; tight 2 （物體受外力作用變得固定...
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 矩 : 名詞1. （畫直角或正方形、矩形用的曲尺） carpenter's square; square2. （法度; 規則） rules; regulations 3. [物理學] moment
  • 擰緊 : screw home; screw up; tighten; buck-up
  1. Using the optimum calculating method, some important technical parameters could be determined, that is, optimum supporting force, allowable deformation of rock mass, cross section area of u - shape set, pre - tight force and diameter of the bolt as well as torque to provide optimum supporting force

    用這一計算方法能求出巖石恆阻支護的重要技術參數，即最優（小）恆阻支護力、圍巖最大允許變形量、恆阻u型鋼支架的截面積、聯接螺栓的預緊力和直徑及最優支護力的擰緊力矩。
  2. Combines with a concrete subject, this paper, composed of seven chapers, makes a deep analysis on theory and experiment of key bolt fastening of engine. the first chapter presents the theory of tightening technology of the available bolt the second chapter gives a narrating about tighten technology availably in survey. pointing that the nature of torque control is axis preload

    本文結合一具體課題，第一章敘述了可控螺栓擰緊技術的理論，第二章綜述了可控擰緊技術，提出了扭矩控制研究的實質是控制螺栓的軸向預緊力。
  3. Chapter three makes clear the importance of preload, and deals with the theories on the relationship between preload and torque, angle and extension of the bolt from various aspects

    第三章由扭矩控制的實質? ?預緊力，點明了預緊力的重要性，預緊力與擰緊力矩、螺母轉角、螺栓伸長的關系，對其進行了理論方面的研究和探討。
  4. A series of static and fatigue experiments which include lots of specimens are performed on bolted composite laminates that include different sizes, different lay orientations and different torques. dye - enhanced x - radiography is used to check the progressive damage process as evaluation techniques, which can be made nondestructively. finally, the ultimate strength and fatigue life of composite bolted joints in static tension and

    層合板接頭的試驗研究考慮了多種幾何尺寸、多種鋪層及不同擰緊力矩對其靜強度及疲勞性能的影響，同時使用滲透劑增強的x射線圖象技術對靜載和疲勞損傷擴展及累積過程進行了無損檢測，並對其進行了分析探討。
分享友人
分享到 Line

分享到臉書