收發器 的英文怎麼說

中文拼音 [shōu]
收發器 英文
transceiver
  • : Ⅰ動詞1 (把攤開的或分散的事物聚集、合攏) put away; take in 2 (收取) collect 3 (收割) harvest...
  • : 名詞(頭發) hair
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • 收發 : 1 (收進和發出公文) receive and dispatch2 (擔任收發工作的人) dispatcher3 [電學] transmit recei...
  1. It is the transceiver - the soul of the lidar

    這是一個收發器,亦是激光雷達的靈魂。
  2. Interface design of dtmf modem and single chip computer

    收發器與單片機的介面設計
  3. The development of fieldbus technology made lonworks field bus outstanding in all kinds of fieldbus. this paper simply introduces some kinds of common using fieldbus and the important position and influence of lonworks fieldbus in all kinds of fieldbus, carefully describes the technology core of lonworks technology, puts great emphasis on the introduction of the development and design of public security node of intelligent district which adopts computer, communication and control technology, carefully designs the interfaces of hardware circuits. the public security node of intelligent adopts 8031 single chip as its main processor to complete the application program of user, which mainly collects, process and control all kinds of field signal, and neuron chip 3150 as its slave processor to communicate with other nodes on field network, which works under parrel slave a mode

    現場總線技術的展使得lonworks技術脫穎而出,本文簡要介紹了常用的幾種現場總線的概況以及lonworks技術在現場總線技術中的地位和影響,對lonworks技術的技術核心:神經元晶元、 lontalk協議、 lonworks收發器、 lonbuilder及nodebuilder進行詳盡的描述;重點介紹了集先進的計算機技術、通信技術、控制技術為一體的智能小區安防節點的開與研製,對節點硬體電路的各種介面進行了詳盡的設計。本文設計的智能小區安防節點採用單片機8031作為主處理來完成用戶的應用程序,主要負責對各種現場信號進行採集、處理及控制,工作在并行從a方式下的神經元晶元mc3150作為從處理,主要完成與現場網路上的各節點及中心控制室之間的通信工作。
  4. He ' s either disabled or shut down the transceiver

    他可能破壞,或者關掉了收發器
  5. A design and implementation of 32 - way mfc dtmf transceiver

    信號收發器的設計與實現
  6. Design of transceiver with wireless usb interface based on pdiusbd

    介面收發器的設計
  7. Cmos serial transceiver with half - rate architecture

    串列數據收發器的設計
  8. I want you to be ready to fit that chip with a transponder

    你去準備利用雷達收發器和晶元適配
  9. The analog signals are regulated to satisfy the system and analog - to - digital converter ( adc ) ; dsp is the core part and is connected with adcs, a controller of ethernet, a rs - 485 bus transceiver, a can bus transceiver and a clock. the real - time data is disposed by dsp and is transferred to the upper computer when the alarm is happened

    模擬信號調理模塊對輸入的信號進行調理,以達到系統和模數轉換( adc )采樣的要求; dsp作為系統的核心部件,外擴了adc 、以太網控制、 rs - 485總線收發器、 can總線收發器和時鐘晶元, dsp對實時數據進行處理,當報警生時將實時數據通過以太網上傳給上位機。
  10. Inside the equipment shelter, the most eye - catching device is a blue cylinder

    這是一個收發器,亦是激光雷達的靈魂。
  11. The clock recovery block of usb2. 0 transceiver macrocell consists of phase locked circuit, such as pll and dll ( delay locked loop ). this block use external crystal 12mhz sin signal to produce 60mhz, 120mhz, 480mhz clock signal, and can recover colock signal form date wave. it can support 480mbps ( hs ) and 12mbps ( fs ) word speeds as defined in usb2. 0 specification.

    目的是用鎖相環電路? pll和dll (延遲鎖相環)實現usb2 . 0收發器宏單元utm的時鐘恢復模塊。其中pll環路構成的時鐘將外部晶振的12mhz正弦信號生成60mhz 、 120mhz 、 480mhz等本地時鐘信號。 dll環路依據本地時鐘信號對外部數據信號進行時鐘恢復。
  12. And i finished the layout design, chip test of line driver and equalizer in 2. 5gbps baseband copper cable transceiver and equalizer in the 1. 5gbps sata transceiver respectively. the main improvements and innovations in this thesis are as follows : 1 、 to design an analog equalizer tuned on - chip for 2. 5gbps baseband copper cable transceiver ; 2 、 to present an adaptive equalizer for 1000base - cx transceiver ; 3 、 to present an auto - gain control amplifier used in the adaptive equalizer for the 1000base - cx transceiver ; 4 、 to present an adaptive continuous - time gm - c filter in very high frequency for the adaptive equalizer for the 1000base - cx transceiver

    論文主要的改進和創新有: 1 、設計了適用於2 . 5gbps基帶銅纜收發器系統片上可調的模擬均衡電路; 2 、提出了一種新的適用於千兆以太網基帶銅纜收發器系統的自適應均衡結構; 3 、設計了甚高頻自動增益控制放大; 4 、設計了一種適用於千兆以太網基帶銅纜接均衡的自適應甚高頻連續時間gm - c二階帶通濾波
  13. The 4 - layer printed circuit board, which proposes good electro magnetic compatibility, electrical trait and heat elimination ;. full / half duplex auto - negotiation support ; diagnostic monitoring for malfunction indication and troubleshooting ;. supporting hot - pluggable ; good compatibility ; good at heat elimination. 1. 25gbit / s sfp optic transceiver has been deployed in various broadband applications will be used in backbone networks of ring or daisy - chain topologies

    我們設計的光纖收發器有良好的電磁兼容性,並保證了電路板的供電特性和散熱特性、支持全半雙工自適應、具有數據診斷功能、準確方便的判斷網路故障、支持熱插拔操作、兼容性良好。
  14. Because of its competitive properties fiber comes to be the top choice and becomes the major form of networking. the key technique of optical network is optical & electronic media converters. with the advent of the new phase of full - optical communication, the terms " g bit / s " " hot - pluggable " and " diagnostic monitoring " have already begun to creep into the popular vocabulary

    光通信的核心技術在於光件和光電件技術,具有小型化、熱插拔功能和自診斷功能等三大特點的千兆sfp收發器將代替sip和gbic成為千兆收發器市場的主流,是通信用光電展的必然趨勢。
  15. The transceivers, which relay lowpower radio waves above the heads of unsuspecting pedestrians, are part of a highspeed wireless network called ricochet

    那些收發器是彈跳高速無線網路的組件,紐約市路燈桿與電線桿上一共裝了3000個,它們在行人頭上傳遞低功率無線電波,沒有人察覺過。
  16. After analyzing the noise in the high frequency carrier channel and computing the parameter of channel, we solved the kernel problems of coupling and matched impedance. separate designing the power, power amplification, port, transceiver and other circuits, we fitted together all circuits become the whole lonworks node circuit, and then triumphantly debugged it

    經過對高頻載波通道的干擾特性分析和線路參數的計算,解決了耦合和阻抗匹配等核心問題,並對電源、功放、介面、收發器等部分電路分別設計,最後形成了完整的lonworks節點硬體電路,並調試成功。
  17. The application of power line communication technology based on pl3150 pl

    一種新型電力線收發器在電力線載波通信中的應用
  18. It is the transceiver - the soul of the lidar. it generates infrared light and receives reflections collected by the scanner

    它除了產生紅外光外,亦接掃描集回來的信號,並將信號轉送到收發器旁的電腦
  19. It generates infrared light and receives reflections collected by the scanner. the received signals go into a computer next to the transceiver

    它除了產生紅外光外,亦接掃描集回來的信號,並將信號轉送到收發器旁的電腦
  20. Communicating one bit of data through the radio transceiver costs as much energy as executing roughly 1, 000 processor instructions

    與無線電收發器交換一位元數據所耗損的能量,大約可讓處理執行1000次指令。
分享友人