放大器補償 的英文怎麼說

中文拼音 [fàngdàqìbǔcháng]
放大器補償 英文
amplifier offset
  • 放 : releaseset freelet go
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 補 : Ⅰ動詞1 （修理; 修補） repair; mend; patch 2 （補充; 補足;填補） fill up; add supplement; supply; ...
  • 償 : 動詞1. （歸還; 抵補） repay; compensate for 2. （滿足） meet; fulfil
  • 放大器 : amplifier; pantograph; lawnmower; enlarger; magnifier
  • 放大 : amplify; magnify; boost; enlarge; blow up; gain; amplification; enhancement; multiplication; magn...
  • 補償 : compensate; make up; make up for; make it up to sb. ; make sth. good; compensation; offset
  1. The error of hall element is analysed and the compensative method is provided ; this paper makes the theoretical analysis of errors producing by the instrument amplifier and a / d converter. we adopt the technology of digital filter and linearization implementing by the neural network method

    對霍爾元件的誤差進行分析並給出補償方法；對儀表放大器和a d轉換器引起的誤差進行了理論分析；採用了數字濾波技術和採用神經網路方法實現的非線性校正技術進行軟體補償。
  2. Second, the results of theory analysis and simulation research show that the output of one cycle controlled bridge switching power amplifier have dc offset because of the nonideal characteristic of reset signal. the magnitude of output dc offset voltage is proportional to width of reset pulse. a voltage compensation technique is used to solve this question, and the computation formula of compensation voltage is gived. the circuit compensated and not are researched through simulation and experiment, which results show that compensated circuit solve the output dc offset effectively

    其次，理論分析和模擬研究結果表明，由於復位脈沖的非理想特性，單周控制的全橋開關功率放大器輸出端存在直流偏置問題，其大小與復位脈沖的寬度成正比。針對輸出直流偏置問題，提出了電壓補償的改進方案，給出了補償電壓的具體計算公式。對補償前和補償后的方案進行了對比模擬研究和實驗研究。
  3. At last, control circuit of one cycle controlled bridge switching power amplifier is improved with the basic idea of one cycle control. the simulation results show that the amplifier of improved control circuit not only solve the question of output dc offset, but also keep the voltage gain lowered by voltage compensation technique

    最後，根據單周控制的基本思路，改進了單周控制的全橋開關功率放大器的控制電路。模擬結果表明，改進控制電路后的系統不但解決了輸出直流偏置問題，而且解決了電壓補償方法所造成的放大器增益下降問題。
  4. In the part of the transmitter, the pre - amplifier logarithmic amplifier, temperature complement circuit, anti - disturbing circuit, and v / i circuit, are discussed. the transmitter outputs 4 - 20ma. in the part of the displayer hardware design, the i / v convert circuit and the flame intensity signal processing circuit are introduced

    在探頭的設計中，詳細介紹了前置對數放大器電路設計，在對數放大器加入了溫度補償電路和抗干擾電路，以保證測量精度和較大的量程，最後信號經電壓電流的轉換，得到4 - 20ma的標準信號作為探頭的輸出信號，進行遠傳。
  5. Topics covered include : properties and advantages of feedback systems, time - domain and frequency - domain performance measures, stability and degree of stability, root locus method, nyquist criterion, frequency - domain design, compensation techniques, application to a wide variety of physical systems, internal and external compensation of operational amplifiers, modelling and compensation of power coverter systems and phase lock loops

    所涉及的主題包括：反饋系統的特性和優勢，時域和頻域性能度量，穩定和穩定度，根軌跡法，奈魁斯特準則，頻域設計，補償技術，種類繁多的物理系統應用，運算放大器的內部和外部補償，能量轉換系統的建模和補償，以及鎖相環。
  6. The synchronous rectifying and low power sampling technology is used to reduce the power consumption, flexible external loop compensation, error amplifier output clamp are adopted for better system large signal response. the piecewise slope compensation technology is employed to minimize the consequence of over compensation. the sensor resistor is externally connected, which realize output voltage programmable. the overheat protection and under voltage protection modules are integrated in the die to allow the reliable operation of the system

    同時，電路設計採用同步整流技術、低功耗電流采樣技術降低功耗，提高轉換效率;採用靈活的外部環路補償技術、誤差放大器輸出嵌位技術以實現良好大信號特性;採用分段斜坡補償技術，消除不穩定因素，並最大程度地減小過補償帶來的問題;採用外接輸出采樣電阻的方式，實現輸出電壓的可編程。
  7. The predistortion, which aims at compensating for the nonlinear distortion caused by the power amplifier, has a good performance in eliminating the nonlinear distortion of am / am & am / pm, improving the aci and spectrum efficiency

    預失真技術是針對射頻功率放大器非線性而提出的一種補償技術，可以有效消除由非線性造成的傳輸信號的幅度和相位失真，降低信號鄰道干擾（ aci ） ，提高頻譜利用效率。
  8. The results indicate that the soliton amplitude slightly decreases in the border between the single - mode fiber ( smf ) and the dispersion compensation fiber ( dcf ), but and its shape remains unchanged, while its signal amplitude is amplified when it passes an amplifier and its shape automatically restored

    研究表明，在普通光纖與色散補償光纖的交界處，孤波的幅度有所降低，但其形狀保持不變；光孤子通過放大器后其幅度得到放大，其形狀將自動得到恢復。
  9. The thesis has done the widespread investigation and study to the domestic and foreign ’ s technologies of analogy low voltage and low power, and analyzes the principles of work, merts and shortcomings of these technologies, based on the absorption of these technologies, it designs a 1. 5v low power rail - to - rail cmos operational amplifier. when designing input stage, in order to enable the input common mode voltage range to achieve rail - to - rail, it does not use the traditional differential input pair, but use the nmos tube and the pmos tube parallel supplementary differential input pair to the structure, and uses the proportional current mirror technology to realize the constant transconductance of input stage. in the middle gain stage design, the current mirror load does not use the traditional standard cascode structure, but uses the low voltage, wide - swing casecode structure which is suitable to work in low voltage. when designing output stage, in order to enhance the efficiency, it uses the push - pull common source stage amplifier as the output stage, the output voltage swing basically reached rail - to - rail. the thesis changes the design of the traditional normal source based on the operational amplifier, uses the differential amplifier with current mirror load to design a normal current source. the normal current source provides the stable bias current and the bias voltage to the operational amplifier, so the stability of operational amplifier is guaranteed. the thesis uses the miller compensate technology with a adjusting zero resistance to compensate the operational amplifier

    本論文對國內外的模擬低電壓低功耗技術做了廣泛的調查研究，分析了這些技術的工作原理和優缺點，在吸收這些技術成果基礎上設計了一個1 . 5v低功耗軌至軌cmos運算放大器。在設計輸入級時，為了使輸入共模電壓范圍達到軌至軌，不是採用傳統的差動輸入結構，而是採用了nmos管和pmos管並聯的互補差動輸入對結構，並採用成比例的電流鏡技術實現了輸入級跨導的恆定;在中間增益級設計中，電流鏡負載並不是採用傳統的標準共源共柵結構，而是採用了適合在低壓工作的低壓寬擺幅共源共柵結構;在輸出級設計時，為了提高效率，採用了推挽共源級放大器作為輸出級，輸出電壓擺幅基本上達到了軌至軌;本論文改變傳統基準源基於運放的設計，採用了帶電流鏡負載的差分放大器設計了一個基準電流源，給運放提供穩定的偏置電流和偏置電壓，保證了運放的穩定性;並採用了帶調零電阻的密勒補償技術對運放進行頻率補償。
  10. In addition, we designed the sensor to cancel out noise that might be generated by different components, from the pixel amplifier, which strengthens the signals, to the memory and switches

    我再補充一點，我們的設計使得傳感器可以補償其它部分可能產生的噪音，從放大信號的像素放大器到內存和轉換器等。
  11. Experimental research of dispersion compensation distributed fiber raman amplifier

    色散補償型光纖拉曼放大器的增益和噪聲指數的實驗研究
  12. According to the principle of correlation detection, an automatic measurement system for extinction ratio of polarizer consisted of monochromator and dsp lock - in amplifier and compurer is designed not only to eliminate the influence on measurement accuracy caused by drift of intensity of light source but also to obatain approximate extinction spectrum

    摘要基於相干檢測原理設計了一套由單色儀、數字鎖相放大器和計算機聯合使用的透射式偏光鏡消光比智能化測試實驗系統，採用雙頻雙光路分光單探測器接收鎖相放大器分離信號比對法進行源補償測量，克服了光源光強漂移所帶來的影響；實現了可見光區消光比的精確自動測量，而且可以測得近似的消光光譜。
  13. In order to design the parameter of error amplifier, the small signal model is derived for arc welding inverter using state - space averaging, and frequency - domain analysis is performed to complete the parameter design

    為了設計控制系統中誤差放大器的參數，利用狀態空間平均法建立了電源系統的低頻小信號數學模型，進而利用控制理論中的頻域分析法設計了系統的補償網路，即誤差放大器的參數。
  14. Battery is the only power source for portable equipment. in order to prolong the service time of these battery - operated equipments, ultra - low - power consumption is demanded. the main method that decreases the power losses is to higher the conversion efficiency and to lower the operating voltage

    開關變換器內包含了帶隙參考電壓源、誤差放大器、頻率補償電路、三角波產生電路、 pwm比較器以及數字邏輯控制電路，此晶元採用聯華電子公司0 . 6微米cmos工藝。
  15. The combined motor vibration sensor which is held manually with double charge amplifier placed inside and with frequency compensating circuit is designed based on the existed press - electricity accelerator of vibration and the measuring vibration system of charge amplifier in the paper

    本文在現有振動壓電式加速度計、電荷放大器測振系統的基礎上，設計了手持式內置微型雙電荷放大器和頻率補償電路的一體化發動機振動傳感器。
  16. Which include magnetic - field probe, wide - band amplifier, transmission cable and its compensator

    該系統包括磁場測量探頭、寬帶信號放大器、信號傳輸電纜和補償器等。
  17. Automatic slope control. a device which automatically changes the slope of an amplifier ' s curve to compensate for temperature changes

    自動斜率控制。自動改變放大器曲線斜率以補償溫度變化的一種設備。
  18. The second is that sensor is compensated and amplifier is improved

    2 ）補償加放大器改進綜合法。
  19. The 2 - stage differential transconductance amplifier is used in the design to achieve high gain. in the design of amplifier, a resister and a miller capacitor is used to deal with the stability and frequency compensation

    系統中採用差分跨導運算放大器的設計，為了保證其具備高增益與高穩定性，選用二級結構，並且增加了補償電容和電阻。
  20. The design method of the double charge amplifier are worked out based on the requirement of the sensor for testing circuit and the effect of sensor for work environment, the method of compensation of the frequency being extended is studied, and the butterworth filter of five order which is adapted itself is designed creatively by the isppac in chapter three

    第三章從敏感元件對測量電路的要求和工作環境的影響出發，提出了雙電荷放大器的設計方案，研究了頻率拓寬補償的方法，使用isppac創新設計了自適應butterworth5階低通濾波器。
分享友人
分享到 Line

分享到臉書