效率損失試驗 的英文怎麼說

中文拼音 [xiàolǜsǔnshīshìyàn]
效率損失試驗 英文
fade test
  • 效 : Ⅰ名詞（效果; 功用） effect; efficiency; result Ⅱ動詞1 （仿效） imitate; follow the example of 2 ...
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 損 : Ⅰ動詞1 （減少） decrease; lose 2 （損害） harm; damage 3 [方言] （用尖刻的話挖苦人） speak sarcas...
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 效率 : productiveness; efficiency; productivity; workpiece ratio
  • 損失 : 1. （失去） lose 2. （失去的東西） loss; wastage
  • 試驗 : trial; experiment; test
  1. Want to have consideration to findings, circumstance of fall victim of density of the mouth that be like bug, crop ( index of be murdered rate, be murdered, loss late ), computation of result of test of field drug effect

    對調查結果要進行計算，如蟲口密度、作物受害情況（被害率、被害指數、損失率） 、田間藥效試驗結果計算等。
  2. In order to improve the prediction accuracy, the sensitivities of pipe friction coefficients, pressure loss coefficients in bents, wall temperatures and heat transfer coefficients in pipes and cylinders on the volume efficiency are investigated

    為提高充氣效率的計算精度，由模擬計算和相關試驗，分析了管道的摩擦系數、彎管的壓力損失系數、進氣管壁和氣缸壁溫度及其傳熱系數對充氣效率的影響程度。
  3. This paper has analyzed and synthesized the problems of burning heavy viscosity petroleum about injecting steam boilers in liaohe oil field. the heat balance experiments on injecting steam boilers burning heavy viscosity petroleum is made first. the main causes of low thermal efficiency and heat lose of flue gas are the poor effect of atomization and burning with old - fashioned oil nozzles, worse ash gathered on. heat exchange surface and high temperature of flue gas

    本論文在分析綜述了遼河油田注汽鍋爐燃用高粘度稠油時存在的問題的基礎上，首先對燃用稠油的注汽鍋爐進行了正、反熱平衡試驗，分析了注汽爐熱效率偏低、排煙熱損失偏高的主要原因是原噴油嘴改燒高粘度稠油時霧化和燃燒效果差、換熱面積灰嚴重、排煙溫度太高。
  4. By compared with the simulation results and the experiment results, we come to the conclusions that : ( 1 ) circuit with assistant network can widen soft - switching extent in lagging arm, reduces duty - cycle loss on the secondary, diminishes switching dissipation of inverter spot - welding power source. ( 2 ) the range of resonant capacitor, the important factor to soft - switching process, not only affects zero - voltage turn - off of power switches, but also affects the range of zero - voltage turn - on of power switches. so resonant capacitors must be considered according to many aspects ; ( 3 ) it easily fulfils soft - switching condition in lagging arm as leakage inductance of power transformer increases, but bigger leakage inductance of power transformer increases opening dissipation of transformer and decreases efficiency of soft - switching inverter power source

    通過模擬結果與軟開關點焊逆變器試驗結果的對比分析，得到了如下主要結論：採用輔助網路可以完全拓寬全橋軟開關逆變器的滯后橋臂軟開關范圍，減小了次級占空比丟失，降低了逆變電阻點焊電源的開關損耗；諧振電容是影響軟開關工作狀態的重要因素，其大小不僅影響開關管的零電壓關斷，同時也影響開關管的零電壓開通范圍，因此，諧振電容應該綜合考慮；功率變壓器漏感越大，越容易滿足滯后橋臂的軟開關條件，但是大的漏感也使變壓器的通態損耗增加，降低了軟開關逆變器的效率。
  5. Aminobenzenesulfonic acid super - plasticizer is selected though cement paste test, which be provided with high water - reducing property, low slump loss and good compatibility with cement. according to the request of super high early strength, admixture rf is obtained though tests to compare performances of different accelerators and admixtures. experimental research and analysis are carried out on coarse aggregate ' s grain - size effect and composite aggregate ' s bulk - density to take sensitivity of coarse aggregate into account

    通過水泥凈漿試驗比較選擇了減水率高、坍落度損失小、與水泥適應性好的氨基苯磺酸鹽高效減水劑；針對超早強的性能要求，試驗比較了不同早強劑及早強性摻合料的性能表現，研製了早強性能顯著、與高效減水劑和水泥相容性較好的rf摻合料；考慮到修補混凝土對粗集料粒徑的敏感性，對粗集料粒徑效應及混合集料堆積密度進行試驗研究與分析；並對修補混凝土的抗折、抗壓、新老界面粘結強度以及抗凍性等進行了試驗研究。
  6. Parameter estimation of the weibull distribution tampered failure rate model under a normal stress

    分佈步進應力加速壽命試驗損傷失效率模型參數的近似極大似然估計和逆矩估計
  7. The statistical analysis of geometric distribution based on type - tampered failure rate model under simple step - stress accelerated life testing

    對步進應力加速壽命試驗提出損傷失效率模型
  8. For example, the weakness in metals etc. caused by repeated stress. this article gives the point estimation of parameters based on tampered failure rate model for weibull distribution under step - stress accelerated life testing

    本文是針對損傷失效率模型（ tfr ）模型就weibull分佈產品在步進應力加速壽命試驗下研究了參數的點估計。
  9. In the forth chapter, the pressure lose and conversion efficiency of catalytic converters with various configurations have been measured on a steady flow rig and analyzed in theory

    第四章詳述了在穩流試驗臺上對不同結構催化器壓力損失和轉化效率的測量，並進行了理論分析。
  10. The experimental and simulation results show that using the improved structure of inlet header can greatly improve flow uniformity, decrease pressure loss, enhance the efficiency of twc, attribute to prolonging the service life of the machine, and lessen the power decrease caused by twc, but the light - off time of twc is retarded

    通過模擬與試驗表明，與常規結構催化轉化器相比，組合型入口管可明顯改善流動均勻性，降低壓力損失約1 / 4 ，提高催化轉化器效率，延長使用壽命，減小對發動機動力性的影響，但起燃變慢。
  11. A new aerodynamic design system developed by authors for draft fan with enhanced efficiency, suppressed noise, enlarged flux and high load. the new design system features : a twist regulation for vortex control is employed in designing to lessen the secondary flow loss in the blade tip and hub ; the feasibility and high efficiency of this procedure has been verified by the tests of the prototype fan ; a new computer - aided 3d blading is used to optimize the blade ; numerical inverse checking is adopted to enhance accuracy in designing and cut down the period of the designing and production. this design system can make the optimized blade with " forward inclination ", " inclining sweep ", " bending sweep ", to minimize the various secondary flow losses, to expand the steady working range of the fan, and to suppress the aerodynamic noise source

    本文通過對一種新型高性能礦用局部通風機的設計、製造及試驗全過程的綜述，展現了新的先進設計體系在民用通風機上的成功運用，其研製特點是： （ 1 ）在葉片氣動設計中為了降低葉根及葉尖區二次流損失，採用可控渦扭向規律設計，樣機實測的高性能驗證了這種方法的可行性和高效性； （ 2 ）在設計方法中採用較精確的數值反驗算，獲取最優設計方案，大大提高設計的準確性和成功率，並縮短了設計試制周期； （ 3 ）在設計過程中發展了計算機輔助三維葉片造型新方法，可以根據設計需要簡便快捷地對葉片進行「前傾」 、 「傾掠」或「彎掠」造型，這些造型對減小各種二次流損失、擴大穩定工況范圍和控制葉輪機氣動噪聲源起到了非常好的作用。
  12. Abstract : a new aerodynamic design system developed by authors for draft fan with enhanced efficiency, suppressed noise, enlarged flux and high load. the new design system features : a twist regulation for vortex control is employed in designing to lessen the secondary flow loss in the blade tip and hub ; the feasibility and high efficiency of this procedure has been verified by the tests of the prototype fan ; a new computer - aided 3d blading is used to optimize the blade ; numerical inverse checking is adopted to enhance accuracy in designing and cut down the period of the designing and production. this design system can make the optimized blade with " forward inclination ", " inclining sweep ", " bending sweep ", to minimize the various secondary flow losses, to expand the steady working range of the fan, and to suppress the aerodynamic noise source

    文摘:本文通過對一種新型高性能礦用局部通風機的設計、製造及試驗全過程的綜述，展現了新的先進設計體系在民用通風機上的成功運用，其研製特點是： （ 1 ）在葉片氣動設計中為了降低葉根及葉尖區二次流損失，採用可控渦扭向規律設計，樣機實測的高性能驗證了這種方法的可行性和高效性； （ 2 ）在設計方法中採用較精確的數值反驗算，獲取最優設計方案，大大提高設計的準確性和成功率，並縮短了設計試制周期； （ 3 ）在設計過程中發展了計算機輔助三維葉片造型新方法，可以根據設計需要簡便快捷地對葉片進行「前傾」 、 「傾掠」或「彎掠」造型，這些造型對減小各種二次流損失、擴大穩定工況范圍和控制葉輪機氣動噪聲源起到了非常好的作用。
  13. The step stress alt and data processing of the radio fuze under the condition of three - parameter weibull distribution

    分佈序進應力加速壽命試驗損傷失效率模型下的統計分析
分享友人
分享到 Line

分享到臉書