散度運算元 的英文怎麼說

中文拼音 [sǎndùyùnsuànyuán]
散度運算元 英文
divergence operator
  • 散 : 散動詞1. （由聚集而分離） break up; disperse 2. （散布） distribute; disseminate; give out 3. （排除） dispel; let out
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 運 : Ⅰ動詞1 （物體位置不斷變化） move; revolve 2 （搬運; 運輸） carry; transport 3 （運用） use; wield...
  • 算 : Ⅰ動詞1 （計算數目） calculate; reckon; compute; figure 2 （計算進去） include; count 3 （謀劃;計...
  • 運算 : [數學] operation; arithmetic; operating
  1. But when the wind - speed becomes above 1m / s hereafter, wind - speed increase for the cpu thermal siphon of transmit heat the ability ' s gain result the deceleration. so it is considered perfect when the wind - speed is 1m / s. through this experimentation we found that when the cpu thermal syphon cooling machine used acetone as working fluid, wind - speed 1m / s, cpu chip caloricty 60w, its volumetric heat release rate came to 1. 3 104w / ( m3k )

    通過本次實驗測出所使用的cpu重力熱管散熱器在使用丙酮為工質，風速1m / s ， cpu晶元發熱量為60w時，其體積散熱率達到1 . 3 104w / （ m3k ） ，能保證晶元溫度與環境溫度之差小於40 ，能很好的適應pentium -計算機長期運行的要求。
  2. In the paper, with system energy balance method and heat conductive equations ， on tne basis of short time heat transfer modeling established the long time modeling, considering heat interference in thermal well group. this paper used the finit element method for element division and computer analysis, and provided the operation temperature figure. acquired computation values agreed well with experimental results, the most difference between them was 5. 13 %

    本文採用系統能量平衡結合熱傳導方程，在淺埋套管式換熱器短期傳熱模型基礎上建立了長期傳熱模型，並考慮了管群熱干擾對模型的影響。並運用有限單元法軟體編程進行離散和計算機分析，得出模擬溫度場，其模擬值與實測的均值基本相符，兩者最大誤差小於5 . 13 % ，表明該模型具有一定的合理性和實用意義。
  3. The higher the processing speed of computer, the more heat generating from cpu chip. if the heat ca n ' t be dissipatied effectively, the processing stability and speed will be decreased dramatically

    計算機運行速度越高其晶元cpu發熱量越大，如果這些熱量得不到有效散逸，會制約晶元速度的進一步提高。
  4. At present greco is regarded as one of the most valuable methods of radar cross section ( rcs ) computation in the high - frequency region. depending on these conditions, several researches have been completed in this paper : firstly, calculating rcs of complex conducting targets has been accomplished by greco method. the high - frequency rcs of targets are obtained through physical optics ( po ) and incremental length diffraction coefficients ( ildc ) respectively

    本論文做了以下研究工作：首先，實現了運用greco方法計算了高頻區理想導體復雜目標的雷達散射截面（ rcs ） ，分別應用了物理光學法（ po ）和增量長度繞射系數法（ ildc ）計算了目標的面元和棱邊的電磁散射，最後綜合面元與棱邊的散射效應得到目標的總rcs 。
  5. During the 3d finite element calculation, try to simulate different procedure of the construction ( like sunk well in - filling, main cable erection, box girder hoist, bridge flooring and opening to traffic ). and then, reveal the regulation of deformation and displacement on the foundation and soil during different period. after got these, this thesis put great attention on the analysis of the reason which cause the horizontal displacement of the cable saddle, as well as the regulation of the pressure ' s changing in the soil located on the front side of the sunk well foundation

    在三維有限元計算中，對不同工況（沉井充填、錨體澆築、主纜架設、箱梁吊裝、橋面鋪裝以及通車運營）下的施工過程作了模擬，全面揭示了各工況下錨碇沉井基礎與地基土的變形變位規律，著重分析了影響散索鞍水平位移的因素以及不同工況下沉井前測地基土水平向抗力變化規律，並提出了不同深度地基土水平向抗力與水平位移間的擬合關系。
  6. Abstract : in this paper, the distinct element method is adopted to study the force and the motion of granular burden from a kinematic view point. the numerical model of bell - less top charging is established. the charging process and burden surface profile have been imitated

    文摘:從動力學角度，採用離散單元法研究爐料顆粒的受力和運動，建立高爐無鐘爐頂布料數值計算模型，模擬無鐘爐頂布料過程和料面形狀。
  7. In this paper, we discusse the stability of perturtation of m - p inverses of closed operator function and then the stability of least square solution of elliptic partial differential equations of second order with unbounded coefficients

    本文討論了閉運算元的m - p廣義逆的擾動，並由此討論首項系數本質無界的二階散度型橢圓型微分方程的最小范數極小二乘解的穩定性
  8. Aim at the dtc ' s blemish mentioned above and the direction of dtc technique development, the dissertation put great emphasis on the work as follows, with an eye to exalt dtc system function : ( 1 ) a new speed - flux observer of an induction motor is proposed to enhance the accuracy of flux observing, which is an adaptive closed - loop flux observer and different from the traditions. a new adaptive speed - observation - way is deduced out according to the popov ' s stability theories ; ( 2 ) to improve the performance of dtc at low speed operation, we have to exalt the accuracy of the stator flux estimation and a new way of bp neural network based on extended pidbp algorithm is given to estimate and tune the stator resistance of an induction motor to increase the accuracy of the stator flux estimation ; ( 3 ) digital signal processor is adopted to realize digital control. an device of direct torque control system is designed for experiment using tms320lf2407 chip produced by ti company ; ( 4 ) bring up a distributed direct torque control system based on sercos bus, sercos stand for serial real time communication system agreement which is most in keeping with synchronous with moderate motor control ; ( 5 ) the basic design frame of the hardware and software of the whole control system is given here and some concrete problem in the experiments is described here in detail

    針對上面提到的直接轉矩控制的缺陷和未來直接轉矩控制技術發展方向，本論文重點做了以下幾個方面的工作，目的在於提高dtc系統的綜合性能： （ 1 ）提出一種新型的速度磁鏈觀測器，新型的速度磁鏈觀測器採用自適應閉環磁鏈觀測器代替傳統的積分器從而提高磁鏈觀測的精度，並且根據popov超穩定性理論推導出轉速的新型自適應收斂律； （ 2 ）改善系統的低速運行性能，主要從提高低速時對定子磁鏈的估計精度入手，提出了一種提高定子磁鏈觀測精度的新思路? ?利用基於bp網路增廣pidbp學習演算法來實時在線地修正定子電阻參數； （ 3 ）採用數字信號處理器dsp實現系統全數字化硬體控制，結合ti公司生產的tms320lf2407晶元，設計了直接轉矩控制系統的實驗裝置； （ 4 ）提出了基於sercos總線網路化分散式的直接轉矩控制系統， sercos （ serialrealtimecommunicationsystem ）是目前最適合同步和協調控制的串列實時通信協議； （ 5 ）基本勾勒出整個控制系統的硬體和軟體設計基本框架，詳細描述一些實驗中的具體的細節問題。
  9. In this paper we establish math modal of transient temperature and stress fields of the turbine " rotor with finite element method, develop rotor ' s thermal status online monitor system by distribute computer and visual software, realize online show and analyst of temperature and stress fields when all kinds of transient condition, and finally provide reasonable and optimized operation suggestions, improve safety and economic level of unit sets " operation

    本文採用有限元建立汽輪機轉子的暫態溫度場、應力場的數學模型，藉助計算機分散式計算、可視化等技術開發轉子的熱狀態在線監測系統，實現汽輪機在各種過渡工況下轉子溫度場、應力場的在線顯示與分析，提供合理的操作建議，提高機組運行的安全性與經濟性。
  10. Incremental length diffraction coefficients ( ildc ) is adopted to calculate the contribution of edge diffraction. in order to improve the accuracy of calculation, multi - scattering is discussed, based on the two former contributions and ray - tracing method. geometrical optics ( go ) and physical optics ( po ) are used to calculate the multi - reflection between facets and facets

    對于鏡面反射採用物理光學法計算其散射貢獻，結合基於面元的目標模型的表示，採用離散的積分形式，將面電流積分化簡為線積分，簡化計算復雜度；對于邊緣繞射，運用增量長度繞射系數理論計算目標邊緣繞射場；在多次反射中，則以光線跟蹤方法為基礎，採用幾何光學、物理光學相結合的方法分析考慮多次散射場。
  11. The change of energy in wall rock is tracked in the whole process and the amount of energy transferred to linings is also evaluated. 5 ) based on the principal of energy invariance and the energy properties of sfrc, a practical design equation that related the thickness of projecting sfrc to the energy related properties of tunnel is given in the end. this equation is then used to design a single - track railway tunnel in iii grade rock condition

    並進一步推導了不同形式的構件間的能量耗散關系，為將標準試驗的能量統計結果運用於實際結構中打下了基礎； 4 ）利用有限元軟體對隧道開挖過程進行了三維模擬，得到了隧道圍巖在開挖掘進過程中的能量轉化趨勢和規律，得到了鋼纖維噴射混凝土襯砌在支護過程中的能量變化； 5 ）利用能量守恆原理和已經推導出的構件能量耗散關系，建立了鋼纖維噴射混凝土襯砌厚度與圍巖開挖能量變化間的關系，並運用此方法對級圍巖條件中的鐵路單線隧道的鋼纖維噴射混凝土襯砌進行了設計計算；
  12. This system has function dispersion and can deal with parameter checking, calculation, control strategy, information output and process parameters time - control. these functions will auto - run effectually and reliably that make control dispersion. fieldbus intelligential model layer in this system is made of a few intelligential models in the fields

    該系統實現了功能分散控制，對過程參數檢測及運算處理、控制策略的實現、控制信息的輸出以及過程參數的實時控制等都在現場的過程式控制制單元中有效地、長期可靠地、無人干預地自動進行，從而實現控制功能的高度分散。
  13. In the two - substance attenuate consistency problem, by means of constituting the compulsive convection function of diffusion process, as well as integrating adjoint function, the adjoint variational principle and its finite element method of two - substance attenuate consistency are deduced, and all kinds of dynamic conditions and their variational expressions are discussed

    在二組元稀薄濃度問題中，通過構造擴散過程的強制對流項並結合伴隨運算元的有關理論推導了二組元稀薄濃度問題的伴隨變分原理及其有限元方法，同時討論了擴散問題的各類動力條件及其變分表達式。
分享友人
分享到 Line

分享到臉書