散熱器導管 的英文怎麼說

中文拼音 [sǎnrèqìdǎoguǎn]
散熱器導管 英文
radiator duct
  • 散 : 散動詞1. （由聚集而分離） break up; disperse 2. （散布） distribute; disseminate; give out 3. （排除） dispel; let out
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 導 : 動詞1. （引導） lead; guide 2. （傳導） transmit; conduct 3. （開導） instruct; teach; give guidance to
  • 管 : Ⅰ名詞1 （管子） pipe; tube 2 （吹奏的樂器） wind musical instrument 3 （形狀似管的電器件） valve;...
  • 散熱器 : radiator; radiation; cooler; heat sink
  • 散熱 : heat radiation; radiating; thermolysis; abstract heat; heat dissipation; cooling散熱風門 throttle...
  1. Our leading products are : ball mill, superfine agitating mill, vacuum plaster agitator, slip agitator, pressure - glazing tank, shower - dedust glazing booth, vibration sieve, leakage tester for water - closet, blast heater, rapid dispersion machine, magnetic separator, base - wipe machine, electric diaphragm pump and the vertical casting unit for medium and top grade of one - piece water - closet and close - coupled water closet, wash basin, pedestal, low level cistern and sink

    公司主導產品有球磨機、超細攪拌磨、真空石膏攪拌機、泥釉漿攪拌機、釉漿壓力罐、水浴噴釉廚、旋振篩、座便器漏水檢驗機、熱風爐、座便器彎管施釉機、高速分散機、磁選機、擦坯機、電動隔膜泵及生產中高檔衛生潔具的洗面器、分體座便、聯體座便、面具柱、低水箱洗滌槽等立澆成型機。
  2. In the paper, with system energy balance method and heat conductive equations ， on tne basis of short time heat transfer modeling established the long time modeling, considering heat interference in thermal well group. this paper used the finit element method for element division and computer analysis, and provided the operation temperature figure. acquired computation values agreed well with experimental results, the most difference between them was 5. 13 %

    本文採用系統能量平衡結合熱傳導方程，在淺埋套管式換熱器短期傳熱模型基礎上建立了長期傳熱模型，並考慮了管群熱干擾對模型的影響。並運用有限單元法軟體編程進行離散和計算機分析，得出模擬溫度場，其模擬值與實測的均值基本相符，兩者最大誤差小於5 . 13 % ，表明該模型具有一定的合理性和實用意義。
  3. At the initial stage of planar technique, b was employed as ideal diffusion impurity in base - region of npn si planar devices because of the match of its solid - solubility and diffusion coefficient in si with those of p in emission - region, and the good shield effect of sio2 film to b. but because of the relatively large solubility ( 5 1020 / cm3 at 1000 ) and the small diffusion coefficient, the linear slowly - changed distribution of acceptor b in pn junction can not be formed, which could not cater to the requirement of high - reversal - voltage devics. thereafter b - a1 paste - layer diffusion technology and close - tube ga - diffusion technology had been developed, while the former can lead to relatively large the base - region deviation and abruptly varied region in si, which caused severe decentralization of current amplification parameter, bad thermal stability and high tr ; the latter needed the relatively difficult pack technique, with poor repeatability, high rejection ratio, and poor diffusion quality and productio n efficiency

    在平面工藝初期，由於b在硅中的固溶度、擴散系數與n型發射區的磷相匹配， sio _ 2對其又有良好的掩蔽作用，早被選為npn硅平面器件的理想基區擴散源，但b在硅中的固溶度大（ 1000時達到5 10 ~ （ 20 ） ，擴散系數小， b在硅中的雜質分佈不易形成pn結中雜質的線性緩變分佈，導致器件不能滿足高反壓的要求，隨之又出現了硼鋁塗層擴散工藝和閉管擴鎵工藝，前者會引起較大的基區偏差，雜質在硅內存在突變區域，導致放大系數分散嚴重，下降時間t _ f值較高，熱穩定性差；後者需要難度較大的真空封管技術，工藝重復性差，報廢率高，在擴散質量、生產效率諸方面均不能令人滿意。
  4. The main products includes various steam and electric heating reaction vessel, conduction oil, outer coil reaction vessel, polyester and resin completed equipments, vacuum reducing concentration tank, methanol and ethanol recovery tower, various corrugated stuffing, high effective membrane evaporator, new - type centrifugal drag membrane evaporator, vacuum rake dryer, condensing drum cut - off machine, shell - and - tube condenser,

    本廠主要產品有各類蒸氣電加熱反應鍋，導熱油外盤管反應鍋，聚脂樹脂全套設備，真空減壓濃縮罐，甲醇乙醇回收塔，各類波紋填料，高效薄膜蒸發器，新型離心刮板式薄膜蒸發器，真空耙式乾燥機，冷凝滾筒切片機，列管式冷凝器，螺旋板式換熱器，外循環蒸發器，鋁制槽車貯罐，乳化設備，高速剪切分散機，種子罐，發酵罐，多功能提取罐，並承接各類非標設備。
  5. Motor heat dissipation shall be accomplished by circulating a heat transfer fluid from an integral reservoir through channels that are internally cast into the motor stator housing

    電機散熱應該通過熱傳導流體的循環流動來完成，這些流體從一體式貯存器流經內鑄管道，進入電機定子外殼。
  6. ( 3 ) the most principal factors that influence the supersonic atomization process include the flow ratio of the gas - liquid metal ( gmr ) value, the flow of atomizing of gas and the range of the inverse vortex taper. the more of the value of three factors, the more advantage they are for the atomization and the more fine the powders are. ( 4 ) the produced powders are the best in efficient atomization efficiency, particle diameter, particle shape and dispersion when the solder alloy is zhl63a, atomizing medium is n2, the protrusion h = 6. 0mm, atomizing gas pressure p = 100mpa, over - heat temperature t = 167 ( t = 350 )

    研究結果表明： （ 1 ）超音速霧化器的氣體流場在導液管下端形成一個倒渦流錐，在二維空間上呈軸對稱的雙峰分佈，負壓形成於這個倒渦流錐內； （ 2 ）修正後的霧化氣體速度公式可以滿足超音速霧化的要求； （ 3 ）影響超音速霧化工藝最根本的因素有氣液質量流率比（ gmr ）的大小、霧化氣體流量和倒渦流錐范圍，三個因素的值越大，對形成細粉越有利； （ 4 ）在焊錫合金為zhl63a ，霧化介質微n _ 2 ，導液管突出高度取h = 6 . 0mm ，霧化氣體壓力取p = 1 . 0mpa ，合金過熱度取t = 167 （ t = 350 ）時，所制得的粉末在有效霧化率、顆粒球形度、粒度及其離散度三個方面綜合性能最好。
  7. Since the analysis of the inverter and its control system is very complex, the frequency analysis, time domain analysis and control system is made in capacitance operated conditions limited to pressure of time and paper length. the research content can be summed up as follows : ( 1 ) a new equivalent circuit of dbd circuit ( dielectric barrier discharge ) that consider the consume of transformer, the on - off switching loses and so on is presented based on the ozonier powered by sine current source. as compared with the former equivalent, the new equivalent circuit can be depicted the actual ozone circuit accurately

    本文主要針對容性狀態下的臭氧發生器電源進行相關研究，研究內容包括以下幾部分: （ 1 ）在正弦電流源供電的dbd型發生器的基波等效電路基礎上，提出了一種考慮電路雜散損耗（變壓器勵磁損耗、開關管開關和導通損耗以及其他元件的熱損耗）的改進型基波等效電路，並採用該等效電路得出了適用的臭氧發生器電源設計方法，實驗驗證了該基波等效電路具有工程設計精度高的優點。
  8. Under the guidance of erp theory and considering the physical circumstance of fengyang radiator plant, an integrated enterprise information management system was developed. in this paper, the principle and implement of this enterprise information management system was expatiated. the system consisted of several modules as follows : basic data module, storage management module, sales management module, planned management module, purchasing management module

    作者以erp思想為指導，根據鳳陽散熱器廠的具體情況，開發了該企業的erp系統。本文闡述了集成化的「鳳陽散熱器廠企業信息管理系統」的原理及實現，系統包括：基礎數據模塊、倉儲管理模塊、銷售管理模塊、計劃管理模塊、采購管理模塊。
分享友人
分享到 Line

分享到臉書