斷裂原因 的英文怎麼說

中文拼音 [duànlièyuányīn]
斷裂原因 英文
destruction
  • 斷 : Ⅰ動詞1 （分成段） break; snap 2 （斷絕;隔斷） break off; cut off; stop 3 （戒除） give up; abstai...
  • 裂 : 裂動詞[方言] （東西的兩部分向兩旁分開） open
  • 原 : Ⅰ形容詞1 （最初的; 原來的） primary; original; former 2 （沒有加工的） unprocessed; raw Ⅱ動詞（原...
  • 因 : Ⅰ動詞[書面語] （沿襲） follow; carry on Ⅱ介詞1 [書面語] （憑借; 根據） on the basis of; in accord...
  • 斷裂 : break; disrupt; flying off; fracture; fragmentation; out break; rift;crack;bursting;rupture;rendi...
  1. Fracture analysis for rotor turbine blade in aero - engine

    某發動機渦輪轉子葉片斷裂原因分析
  2. Analysis and improvement on the reason of the rive ' s fracture at the rivet connection of the coaming and the upper deck on the 100t landing craft

    100噸登陸艇上建圍壁與主甲板鉚接處鉚釘斷裂原因分析與改進
  3. The reason of rupture of driven shaft of idler wheel for some factory is analyzed

    摘要文章分析了某單位移動工位滾輪架從動軸的斷裂原因。
  4. Fracture analysis of two - head bolt with zinized surface

    表面滲鋅雙頭螺栓斷裂原因分析
  5. A study on the cause of premature rupture of heavy dump truck frame

    重型自卸車車架早期斷裂原因的研究
  6. The reason for crankshaft fracture in an mwmtbd234v6 diesel was analyzed. the results show that overheating and overburning is the direct reason for fracture. the heat treatment of the crankshaft is not perfect or consistent with the standard. the lubrication is not good in service. all these accelerate the fracture

    分析mwmtbd234v6型柴油機的曲軸斷裂原因，結果表明鍛件過熱過燒是導致斷裂的直接原因；曲軸熱處理工藝不規范、不完善，曲軸工作潤滑條件不良加速了曲軸斷裂
  7. Causes and analysis for 6082 - t651 aluminium alloy streched plate of the crack

    651鋁合金厚板拉伸斷裂原因分析
  8. The analysis of fracture of gong nong - 12 walking tractor driving wheel axle and its structure improveraent

    12手扶拖拉機驅動輪軸斷裂原因及結構改進
  9. The relation between heating - up and being broken for resistanse wire heater is analysed, and the cause of two kands of resistanse wire to be broken is discussed in theory, so the better method of maintaining and repairing this kand of electric heater is found

    摘要分析了電熱絲加熱器發熱原理與溫升和熔斷的關系，並對兩種電熱絲斷裂原因進行了理論上的分析，從而找出對這一類電加熱器維護修理的較好方法。
  10. The fracture of a steel rail was analyzed by means of metallographic microscope, sem and eds

    摘要用金相顯微鏡、掃描電鏡、能譜儀分析了鋼軌斷裂原因。
  11. Abstract : the drawing breakage of hard wire are classed from materials and technology. its causes are analyzed, and some typical examples are put forward

    文摘:從原料和加工工藝方面對拉拔斷裂原因進行分類；介紹了根據拉拔工藝、宏觀斷口分類分析來判斷硬線拉拔斷裂原因的方法和部分典型事例。
  12. Cause analysis of flange plate shear fracture and reinforcement plan selection of a t beam bridge

    梁橋翼緣剪切斷裂原因分析與加固方案選擇
  13. Analysis of fracture of compressor crank shaft

    活塞壓縮機曲軸斷裂原因分析
  14. Analysis of the causes of the fracture of conveyer belt button and improving schemes

    輸送帶扣斷裂原因分析及改進方案
  15. Breaking causes and repair technology of east mine ventilation shaft in sihe mine

    寺河礦東風井筒斷裂原因及治理技術
  16. Analysis was performed on the crack zone by macroscopical, microscopical and hardness testing

    採用宏、微觀分析方法對斷裂原因進行了分析。
  17. Analysis and prevention of concrete pavement crack reason

    水泥混凝土路面斷裂原因分析及預防措施
  18. Analyses for the fracture of tricycle transporter half shaft are presented. an improved design has been put into use for two years and the effect has been proved wonderful

    摘要分析了半浮式農用三輪運輸車半軸的斷裂情況，並對斷裂原因進行了探討，提出了改進方案，經過兩年多的實際生產應用，效果良好。
  19. Failure analysis on surfacing exhaust valve of 6cr21mn10movnbn steel

    鋼制堆焊排氣閥斷裂原因分析
  20. Initial analysis on causes of failure for shoulder of cylinder sleeve with dummy club

    帶擋焰臺氣缸套支承肩斷裂原因淺析
分享友人
分享到 Line

分享到臉書