晶界斷裂 的英文怎麼說

中文拼音 [jīngjièduànliè]
晶界斷裂 英文
grain boundary fracture
  • 晶 : Ⅰ形容詞（光亮） brilliant; glittering Ⅱ名詞1. （水晶） quartz; （rock） crystal 2. （晶體） any crystalline substance
  • 界 : 名詞1 （相交的地方; 劃分的界限） boundary 2 （一定的范圍） scope; extent 3 （按職業、工作或性別等...
  • 斷 : Ⅰ動詞1 （分成段） break; snap 2 （斷絕;隔斷） break off; cut off; stop 3 （戒除） give up; abstai...
  • 裂 : 裂動詞[方言] （東西的兩部分向兩旁分開） open
  • 斷裂 : break; disrupt; flying off; fracture; fragmentation; out break; rift;crack;bursting;rupture;rendi...
  1. The cracking with these two types of underfill might become unstable and lead to catastrophic failure at the end. the critical length was about 12m for the assembly with no - flow underfill and 20m for the package with capillary - flow underfill at 20 ?

    模擬表明，山固化溫度冷卻到室溫時，所研究的倒裝焊封裝在填充不流動膠時晶元斷裂臨界裂紋長度為12pm ，而填充傳統底充膠時為20hm 。
  2. There are a series of lead - zinc polymetallic deposits, such as fozichong, dongtao, xiashui, wenlongjing and jilongding distributed along the fault zone. these deposits have some similiar features : ? ll of them are bounded in the strata of lower palaeozoic group ; ? ain orebodies occur as stratiform or stratoid form with occurrence consistent with that of host strata ; ? tratiform skam or baritic rock are the direct country rock of orebodies ; ? ypical syngenetic sedimentary fabric preserved in the ore. these deposits may be included in the same metallogenic series

    佛子沖、東桃、下水、文龍徑、雞籠頂等一系列鉛鋅多金屬礦床沿該斷裂帶分佈，這些礦床雖然在成礦規模、賦礦層位和礦石礦物組成等方面存在一些差異，但均產于下古生界地層中；主要礦體呈層狀、似層狀產出，與地層產狀大體一致；直接賦礦圍巖為層狀綠色巖或重晶石巖；礦石中保留有典型的同生沉積組構。
  3. The grain boundary fracture behavior in ni - base bicrystals

    鎳基雙晶體晶界斷裂特性研究
  4. The electric field strengthens the laminate boundary of 2090 alloy. the laminate strengthening mechanism translates into boundary strengthening and grain inner toughening with more ductility fracture and less intergranular fracture. the ductility property is enhanced with no change of intensity

    對鋁理合金sem實驗發現，電場固溶和時效強化了晶界，和晶內塑性的改善，斷裂特徵出現由分層沿晶斷裂向塑性斷裂轉變，斷麵塑性變形特徵增加。
  5. With carbon content increasing, the carbide network on the fertile grain boundary sprouting and propagating. the fracture mode has been changed from cleavage to along boundary and the intergranular corrosion induced by solution chromium decreasing

    隨碳含量提高，晶界上碳化物萌發、擴展呈網狀，鑄件脆斷由解理斷裂發展為沿晶斷裂，同時鐵素體不銹鋼晶間腐蝕傾向增大。
  6. The presence of small amount of liquid at grain boundaries tends to form thin viscous layer which surrounds the finer grains. intergranular fracture may occur at the grain boundaries between two fine grains not covered by viscous phases. the high ductility achieved at low strain rates is generally attributed to dislocation glide - creep accommodation mechanisms

    原始晶界上產生少量液相，形成薄的固液共存粘性層並包圍細化的晶粒，沿晶斷裂主要發生在無粘性層的細晶粒間；而在較低應變速率下，三叉晶界位錯攀援?蠕變協調機制鬆弛晶界滑移產生的應力集中，晶界上產生較多液相，有利於晶界滑移進行。
  7. Above analysis can provide instructions for grain boundary design and controlling in grain boundary engineering. dynamics intergranular fracture process is modeled with considerations of grain boundaries damage

    通過考慮晶界損傷，進一步對拉伸試樣破壞單元的動態沿晶斷裂過程進行了數值模擬分析。
  8. The fractorgraphy analysis show that in the layer rich in w and mo, the feature of fracture is brittle fracture which follow the bordline of crystal. in sections rich in the felt metal, the feature of fracture is ductile fracture. in w - mo layer, the feature of fracture are brittle fracture and some ductile fracture

    斷口形貌特徵研究表明，富w區、富mo區主要為沿粒界脆性斷裂；粘結金屬發生韌性斷裂； w - mo混合區為顆粒的沿粒界脆性斷裂和粘結相的韌性斷裂的混合型斷裂；富ti區為典型的穿晶解理斷裂； mo - ti混合區以穿晶解理斷裂為主，顆粒邊界表現出準解理斷裂特徵。
  9. The microprocesses of deformation and fracture in 18 - 8 stainless steel were observed by in - situ tension in tem. it was found that the dislocations were emitted from the grainboundary and dislocation source inside a grain and slip along their slip system respectively. partial dislocation could also be emitted from the grainboundary, and moved into the grain, and that leaving behind a stacking fault

    摘要浙江人學博1 ：學位論文採用透射電鏡動態拉伸、原位觀察icrlsnigti不銹鋼形變與斷裂過程，發現不銹鋼變形時，晶界和晶內位錯源均可產生位錯，並沿各自的滑移系運動。
  10. The flexural strength and fracture toughness of ti3sic2 material obtained by hot - pressing is 223mpa and 5. 1 mpa m1 / 2 respectively ; the mechanisms of grain bending, grain delamination, crack deflection inside the layered grain, crack deflection and branch, pull out grain are main energy absorbing mechanisms

    ~ 1ti _ 3sic _ 2材料的彎曲強度和斷裂韌性分別為223mpa和5 . 1mpa ? m ~ （ 1 / 2 ） 。主要能量吸收機制為：晶粒的彎曲、層間滑移，裂紋在層間擴展與偏轉，裂紋在晶粒間沿晶界擴展、分叉和晶粒的拔出。
  11. As a result 4 the rising annealing temperature induces si02 phase to form, also ivolves the formation of a si phase. in high - temperature - annealed sio ~, films the excess silicon atoms are present as si - si4 tetrahedra, randomly dispersed in the amorphous si02 matrix. photoluminescent spectra were observed for the samples excided by the laser whose wavelength is 365nm. the pl peak is located at about 445nm, which dose n ' t shift as the annealing temperature changes. as the annealing temperature is raised, the luminescent intensity increases. the phenomena suggest that the si - o - si bond as a defect center which is broken down by the stress at the si nc / si02 interface is the primary source of blue luminescence

    這個陡的界面由於明顯的晶格結構的差別而有較大的應力。界面的形成伴隨著界面發光中心的增加，同時pl強度在l戶800有一個大的增強。這個結果提示我們，界面上h 0 s工鍵斷裂形成的nbohc應是藍光發射的主要原因。
  12. Polarization microscope had observed that the size of sphere crystal of pp after adding organic rigid particles became smaller, the excellent compatibility of interphase between matrix and organic rigid particles in composite has been proved, and the organic rigid particles were drew out into cavities from matrix in the photograph of the impact breaking section by sem. the reason of enhanced toughness of the composite is that the material absorbed amount of energy at forming cavities, which is the mechanism of the pp composite toughened with the organic rigid particles

    偏光顯微鏡顯示加入有機剛性粒子可使pp的球晶尺寸減小， sem觀察到復合材料中基體材料和剛性粒子的界面相容性較好，在沖擊破壞的材料斷面上，剛性粒子明顯被拔出形成「空穴」 ，這些微小空穴較易產生而吸收能量，從而提高了材料的斷裂韌性，這是剛性粒子復合聚丙烯的增韌機理。
分享友人
分享到 Line

分享到臉書