晶粒間區 的英文怎麼說

中文拼音 [jīngjiān]
晶粒間區 英文
intergranular region
  • : Ⅰ形容詞(光亮) brilliant; glittering Ⅱ名詞1. (水晶) quartz; (rock) crystal 2. (晶體) any crystalline substance
  • : Ⅰ名 (小圓珠形或小碎塊形物) small particles; grain; granule; pellet Ⅱ量詞(用於粒狀物)
  • : 間Ⅰ名詞1 (中間) between; among 2 (一定的空間或時間里) with a definite time or space 3 (一間...
  • : 區名詞(姓氏) a surname
  1. The variations in trace element contents and ratios may hold up a mirror to the lake - level fluctuations and climatic changes, which, in turn, have exerted a direct and important effect on the sequence stratigraphic development. collectively, the reservoir rocks from the yanchang formation consist dominantly of the delta front subfacies subaqueous distributary channel and channel - mouth bar microfacies and delta plain subfacies subaerial distributary channel microfacies fine - grained feldspar sandstones and siltstones. the reservoir rocks have been subjected to three stages of diagenetic and porosity evolution : ( 1 ) the porosity reduction by the mechanical compaction and chemical pressure solution during the early diagenetic stage ; ( 2 ) the porosity increase by the dissolution during the a substage of the late diagenetic stage, and ( 3 ) the porosity reduction by the cementation and filling during the b substage of the late diagenetic stage

    系統的儲層特徵研究表明,該延長組儲層成因類型主要為三角洲前緣水下分流河道、河口砂壩及三角洲平原水上分流河道微相細長石砂巖、粉砂巖;儲層巖石經歷了壓實,膠結,溶蝕等成巖作用,歷經早成巖機械壓實和化學壓溶孔隙縮小期、晚成巖a亞期溶蝕作用孔隙擴大期及晚成巖a亞期( b亞期)膠結充填孔隙縮小期三個成巖-孔隙演化階段;儲層物性總體上具有較低孔滲、低孔滲的特點,孔隙類型主要為溶孔、殘余孔隙、內溶孔、孔及溶孔,裂縫不發育,儲集巖排驅壓力和中值壓力較高,孔隙結構類型以細小孔-微孔隙,微細喉-微喉型為主。
  2. The crystalline structure changes of pp induced by pan - milling were characterized by x - ray diffraction and raman spectroscopy. xrd analyses show that when pp was co - milled with uhmwpe, crystal transformation of pp occurred, its crystallinity and crystallite size decreased, whereas, only slight reduction of crystallinity and crystallite size were observed and no crystal transformation was found when pp was co - milled with wtr chips, and amorphization of pp was strongly enhanced by co - milling pp with iron

    採用x -射線衍射研究了聚丙烯碾磨粉碎過程微觀結構變化, uhmwpe存在下pp發生型轉變、結度降低和尺寸減小;彈性材料wtr抑制pp塑性變形,碾磨導致分子堆積有序域膨脹,距增大,結度下降;剛性材料金屬鐵與pp產生強烈摩擦,加快細化,格破裂導致非化。
  3. At the same time because of the insolubility of calcium phosphate, topical extortionate concentration of calcium ions and phosphate ions, the vary of ph value and the effect of osteoblasts and proteins in oregano - bone matrix, the calcium ions and phosphate ions gave birth to crystal nucleus and came into being osteo - salt deposition, furthermore to form mineralized bone. finally, at the host osseous lamella far away the implanting area we found some material granules

    藉助于掃描電鏡等測試手段,實驗發現隨著植入時的延長,材料域的面積不斷縮小,體顆的頸部連接斷開,顆的結構和形貌發生了較大的變化,且材料的內部出現了生命元素碳和硫等。
  4. Relation between size - uniformity of si nanoparticles and oscillating stabilization time of the mixed region during laser ablation

    激光燒蝕過程中密度交疊振蕩穩定時尺寸均勻性的關系
  5. Tem was used to consecutively investigate the size and appearance of dibasic lead phosphite in the reaction process. it found that nanocrystal grain of lead oxide phosphite hydrate had favorite direction in the mlps method, many nanocrystal grain in near area would aggregate and assembled as nanowire, the diameter of the nanowire was about a crystal grain size and the length of nanowire could reach hundreds of nanometers, then they would gather to needle or bar like particles

    利用tem對二鹽基亞磷酸鉛在反應過程中子的大小、形貌進行跟蹤觀察,並記錄下三個時下的微照片,發現用微液相合成法制備的二鹽基亞磷酸鉛在生長團聚時存在取向規律,同一域的會長成一條納米線,直徑有一個的大小,長度可以達到幾百nm 。
  6. From an examination of the tensile behavior of cz ly12 alloys under different temperature and strain rate, two kinds of deformation and intergranular fracture behaviors were observed that were opposite to the characteristic strain rate range in fine - grained superplasticity. the mechanisms are described as follows. the high ductility achieved at high strain rate is generally attributed to the dominant role of gbs accommodating mechanisms, which is considered as dislocation creep within grains controlled by subgrains

    研究選用自然時效淬火態的ly12鋁合金,進行了一系列不同溫度和應變速率下的單軸拉伸試驗, 480下,觀察到與傳統細超塑性特徵相反的行為:較高應變速率下,動態再結使細化,促進了界滑移,亞界控制的內位錯蠕變是界滑移的主要協調機制。
  7. The multilayer composites ( cof3 # ) were prepared at 900 c by cofiring jd ferroelectrics and ty ferrite using tape casting processes

    7h時,差別因子小於1 ,繼續增加保溫時時,界面處尺寸將小於遠離界面域的尺寸。
  8. The laws between the composition, structure, quality of materials of lc - hpc is studied by means of sem, mip, and so on testing measures. the reaction of hydration and filling effect of mineral admixture not only reduces the proportion of pore of structure and sizes and odds directional crystal of the unfavorable crystal phases such as ch but also leads to the mining of pore size, so it the effect improves the weak structure of interface transition area

    應用sem 、 mip等測試手段,研究lc - hpc組分、結構與性能之的影響規律,礦物摻合料的活性、填充等效應,降低了混凝土結構孔隙率,細化了孔徑,減小了ch尺寸及定向結幾率,從而改善界面薄弱過渡結構。
  9. Different element in some interface change in evidence, but different element in other interface change gradually. the interface often have some hole and a mass of one element. in w - mo fgm, because the different rime temperature, the size of mo grain differ from the size of w. in w - mo - ti fgm, mo - ti layer rich in ti, there are more polygonal a

    顯微組織特徵研究表明, w - mo系和w - mo - ti系梯度功能材料整體緻密,有的宏觀層界面明顯,在界面處成分發生突變,而且還有氣孔、顆偏聚等缺陷,有的宏觀層界面處成分變化平緩; w - mo系梯度功能材料由於w 、 mo的再結溫度不同,梯度層顆徑有顯著差異; w - mo - ti系梯度功能材料中,以ti為主的mo - ti混合,主要以多角形固溶體存在,富ti主要以多角形相存在。
分享友人