曝氣槽 的英文怎麼說
中文拼音 [pùqìcáo]
曝氣槽
英文
aeration tank-
Wastewater treatment plants - part 15 : measurement of the oxygen transfer in clean water in aeration tanks of activated sludge plants ; german version en 12255 - 15 : 2003
污水處理廠.第15部分:活性污泥廠的曝氣槽清水中氧氣Commonly used preliminary treatment equipment includes bar screen, fine particle sieving, grit chamber, pre - aeration, grease well and scraping chamber, etc. domestic companies have the capability of manufacturing all equipment except fine sieves
常見的前處理設備有攔污柵、細篩機、沉砂設備、預曝氣池及除油井或油脂撇除槽等。國內前處理設備除了細篩篩網須國This thesis work has researched the fabrication technics of photonic crystal defect waveguide with air - bridge structure and collecting waveguide ; suggested using uv - lithography and wet etching to fabricate traditional waveguide, after that, using eb - lithography and dry etching to fabricate photonic crystal holes, so can reduce the fabrication cost by a big range ; designed the moulding board, which can fabricate the air - bridge structure and is convenient for recognizing position in eb - lithography ; the structure consisted of traditional waveguides and etching grooves are fabricated on soi successfully, then an successful eb - lithography is realized on the structure, the defect waveguide collected with the traditional waveguide quite well ; used the etching grooves to do the sacrificial layer etching experiment, which grounded etching sacrificial layer by photonic crystal holes in next step
提出採用紫外光刻工藝製作傳統波導結構之後,通過電子束曝光和干法刻蝕製作光子晶體小孔的工藝方案,大幅度減低了製作成本;設計出可形成空氣橋結構、並且適用於電子束曝光位置識別的光刻模板,在soi材料上成功製作出帶有空氣橋刻蝕預留槽以及接續光波導的結構,在該結構上成功實現了光子晶體帶隙波導的電子束曝光,帶隙波導與接續光波導位置接續良好;最後利用預留槽進行了刻蝕犧牲層的實驗,為下一步利用光子晶體小孔刻蝕犧牲層形成空氣橋結構打下了基礎。
分享友人