曲率測量 的英文怎麼說

中文拼音 [qūlǜcèliáng]
曲率測量 英文
curvature measurement
  • 曲 : 曲名詞1 （一種韻文形式） qu a type of verse for singing which emerged in the southern song and ji...
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 測量 : measure; survey; gauge; meter; measurement; measuring; surveying; mensuration; metering; gauging;...
  1. The study of comparison of corneal diopter measured by corneal keratometer and corneal topographer

    角膜曲率計與角膜地形圖儀測量角膜屈光度的對比研究
  2. In chapter 5, based on the measured refractive index distribution curve, according as the theoretical model of light transmission in the grin medium, using quadrivalent runger - kutta method to carry out the light tracking, we studied retro - reflection of grin polymer micro - sphere and its application and concluded the best conditions to get good results. in chapter 6 we analyzed the two ways to improve the retro - reflection effect of grin polymer micro - sphere using the light tracking and discuss the pleasant results we got

    第五章從上一章測量所得折射率分佈曲線出發，根據梯度介質球內光線傳輸的理論模型，用光線追跡的方法分析了327 #微球透鏡的反光性能，並對最佳性能條件進行了總結分析，發現效果提高並不明顯，進而在第六章中提出了提高grin聚合物微球回歸反射性能的兩個基本途徑，並用光線追跡方法進行了詳細的分析，最終得到了良好的效果，並對結果進行了一定的分析解釋。
  3. Chapter 5. based on the measured refractive index distribution curve, according as the theoretical model of light transmission in the grin medium, using quadrivalent runger - kutta method to carry out the light tracking, by this means the mainly imaging character index of the micro - lens such as foci, longitudinal and transverse spherical aberrations aberration etc is calculated. i

    第五章從測量所得折射率分佈曲線出發，根據梯度介質球內光線傳輸的理論模型，用四階runger - kutta方法進行光線追跡，計算了此種梯度球的縱橫向球差等光學特性，給出所製作梯度折射率微球透鏡成像性能的評價。
  4. Analysis of measuring corneal refractive power by corneal topographer compared with by keratometer

    角膜地形圖儀和角膜曲率計測量角膜屈光力的差異分析
  5. This method of diesel engine fault diagnosis is feasible theoretically. while the fault diagnosis system using this method is rare, just because the crankshaft instantaneous angular acceleration measurement is demanding, such as, good frequency response, high precision

    這種柴油機故障診斷的方法在理論上是可行的，但目前這種成型的系統不多，究其原因是測量曲軸的瞬時角加速度需要系統具有良好的頻率響應特性與高精度。
  6. Around 40 ; the neutral curve obtained by the growth rates of the temperature fluctuation has a ringlike curve separated from the main branch of nachtsheim s calculation by velocity fluctuation at the lower grashof number side ; and its phase velocity is close to the maximum mean velocity where the critical layer of the eigenmode locates. the thermal fluctuation decays rapidly as the nondimensional frequency above 0. 4, so that it means that the coupling effect between instability wave generated by buoyancy fluctuation and velocity waves by invicid instability seems weak enough for their critical layers in the range of the nondimensional frequency

    詳細研究了自然對流邊界層中最早失穩的浮力振型的功率譜波長波速與臨界層位置等基本特徵和它為主導其他振型尚未失穩時按線性理論得到的3種相互獨立振型的振幅分佈。系統地測量了它所對應的溫度和速度漲落的振幅增長規律和中性曲線，實驗結果表明，溫度漲落的中性曲線在低格拉斯霍夫grashof數
  7. Then the measured frequency characteristic can be converted to high accurate transfer function with curve fit method, rational initial parameters choice and fitting in different frequency range method

    使用曲線擬合方法，輔助以合理的初始參數選取及分段擬合方法，將測量得到的控制對象頻率特性轉化為高精度的傳遞函數。
  8. The position and size of the monochromator, focusing curvature radii and tilting angles of the germanium focusing monochromator under different different take - off angle, size and divergency of the second collimator and intensity loss due to the use of it were determined. the neutron flux at different wavelength, under different reflection and take - off angle of the monochromator and divergency of the first collimator, were given. the simulation on the aperture used for limiting beam size in front of the sample showed that, smaller the size of the aperture and further the distance from the aperture to the sample, greater the loss of the intensity and more serious the spread of the beam along vertical direction at the sample position which makes the practical sampling volume greater than expected

    用蒙特卡羅模擬方法對中子應力衍射譜儀的設計方案進行了優化研究，提出了一系列可供參考的數據：確定了單色器的位置、尺寸、垂直聚焦單色器在不同起飛角下的聚焦曲率半徑和傾角；討論了第二準直器的尺寸和發散，以及使用第二準直器造成的強度損失；給出了在不同單色器反射面、起飛角、中子波長和第一準直器發散度的情況下樣品處的中子注量率，以及多種組合情況下譜儀的解析度曲線；對限束方孔的尺寸、距離樣品遠近對強度損失和測量中的影響做了深入研究。
  9. The microstructure morphology, the concentration, the infrared transmittance, and the x - ray rocking curves measured showed that a long single crystal part and axial steadily distributed zone of the concentration existed in the as - grown crystals. the radial concentration distribution has relatively high uniformity

    通過觀察生長態晶體中的微觀組織形貌，並測量晶體軸向和徑向上不同位置處的成分、紅外透過率和x射線回擺曲線，發現晶內有較長的單晶段和軸向成分穩定區。
  10. To avoid the serious electromagnetic interferer, the analog signals are transformed to frequency pulses which are transferred to the kernel of the system. in the measure of the groove voltage, the method of float - ground is adopted to avoid the high common signal and the range switch circuit is designed to solve the conflict of the wide dynamic range and the high precision. least square curvefit is adopted to reduce the system error

    鋁電解生產現場電磁干擾非常嚴重，為此我們將需要測量的模擬信號就近轉換為頻率脈沖后再傳送到控制核心；採用浮地接入方式消除槽電壓信號中的共模成分；設計了量程自動切換電路以解決槽電壓的動態范圍寬和測量精度高的矛盾；用最小二乘法進行曲線擬和以降低測量的系統誤差。
  11. Introduce the measurement of the common optics parameter of the medium lens, for example, light passing index, no - sphericity and so on, emphasize on the way and result of using shearing interferometric technique to measure the refractive index distribution curve of the micro - lens

    第四章介紹對所制備的此種介質球透鏡的透過率、不圓度等重要光學參數的測量。重點闡述利用剪切干涉技術測量微球透鏡的折射率分佈曲線的方法和測量結果。
  12. Comparison of keratometric readings of orbscan to eyesys corneal topography and keratometer

    角膜曲率計測量角膜曲率的比較
  13. Based on many references form civil and abroad, the author mainly studies the measurment theory and method for flux, raising height, axial power and rotational velocity. avoiding many complicated and intermediate courses for power wastage analysis, introduces the electric measurement and using efficiency curve of motor in measureing axial power, and satisfies the automatization of the device. the paper also provides a new method, inductive winding, in measuring rotational velocity of electromotor, supplys limitations of other method in measuring rotational velocity of electromotor in water, and meet practical needs in developing diving electric pump for corporation

    作者在參閱大量國內外有關文獻，著重探討了水泵流量、揚程、軸功率、轉速的測試原理和測試方法，提出了採用電測法並結合電機效率特性曲線測量水泵軸功率，從而避免了損耗分析法中大量復雜的中間過程，滿足了試驗裝置的自動化測量要求；採用漏磁感應線圈法測量電機轉速，彌補了其它轉速測量方法對水下電機測試的局限性，適應了萊恩公司開發潛水電泵的實際需要。
  14. The calculation program using the matlab has been worked out to get the numerical solutions of the proposed models. the experiment has first been conducted in the laboratory to get the fundamentals thermal and moisture properties ( such as materials density, specific heat capacity and thermal conductivity ) and also the material moisture absorption isotherms of adobe building materials. the methods of measuring the surface mass transfer coefficient and material moisture content have been proposed

    首次對生土建築材料物性參數進行了實驗測試，得到了常用生土建築材料的密度、比熱和導熱系數等參數值，得到了生土建築圍護結構的等溫吸濕平衡曲線的擬合函數關系式；此外，研究了生土建築圍護結構表面質交換系數實驗測定方法，探索了利用電阻率測量生土建築圍護的安窪築科技人學博十學位論文結構內部含濕量的測試方法。
  15. Curvature measuring apparatus of arbitrary shape curved surface

    任意曲面曲率測量儀
  16. According to the authors ' authorized and accepted patents for invention, the working principle, structure, measuring method and accuracy analysis of the curvature measuring apparatus of the arbitrary shape curved surface were introduced

    摘要以作者的授權發明專利和受理發明專利為主要依據，介紹了「任意曲面曲率測量儀」的設計原理、結構、測量方法和精度分析。
  17. But the implementation of traditional wfcs in an optical system is difficulty, so the applications is limited. in 2000, a novel wfcs comprising a distorted diffraction grating ( dgwfs ), simple optics and a single camera has been described by blanchard

    2000年， blanchard等提出了一種新型的波前曲率傳感器，它利用二次扭曲光柵和短焦距透鏡密接使用，來實現波前曲率測量。
  18. As a new bus standard in computer peripheral hardware, usb is adopted and widely used in virtual instruments for its ease of use, true plug and play, power supply from bus, high transmission speed, etc. the purpose of this project is to design and develop a virtual instrument that can test and display semiconductor transistor output characteristics curve, instead of tradition instrument which has being used in labs by now

    而usb總線作為一種新興的計算機外設總線標準，由於易用、支持熱插拔、總線供電、傳輸速率高等特點，已經在虛擬儀器當中得到采納與普及。本文介紹了一種實現晶體管特性曲線測量的虛擬測試儀器的設計和製作方案，其可用來取代目前在實驗室中使用的老式的晶體管特性圖示儀。
  19. According to propagation equation of gaussian beam and matrix of misadjust resonator, as well as principle of cavity ring - down method and data processing of fitting, a physical model of reflectivity measuring is set up for misadjustment of cavity length or angle of titled cavity mirrors

    根據光束傳輸規律和失調腔矩陣方法，以及光腔衰蕩法測量原理和曲線擬合方法，建立了腔長、腔鏡角度失調下光腔衰蕩法的反射率測量模型。
  20. Using the wavefront aberration map and the mtf, interaction between aberrations to improve or reduce visual performance is discussed. 2. a model for wavefront reconstruction from slopes of reflected wave is presented

    2 .從理論上建立了由眼底發出的測試波前斜率測量值重建波前曲面（數值上等於波前像差）的模型。
分享友人
分享到 Line

分享到臉書