最大發射角 的英文怎麼說

中文拼音 [zuìshèjiǎo]
最大發射角 英文
maximum emission angle
  • : 副詞(表示某種屬性超過所有同類的人或事物) most; best; worst; first; very; least; above all; -est
  • : 名詞(頭發) hair
  • : Ⅰ動詞1 (用推力或彈力送出) shoot; fire 2 (液體受到壓力迅速擠出) discharge in a jet 3 (放出) ...
  • : 角Ⅰ名詞1 (牛、羊、 鹿等頭上長出的堅硬的東西) horn 2 (古時軍中吹的樂器) bugle; horn 3 (形狀像...
  1. Do some necessary calculations and decide on the general scheme of compton back - scattering imaging scanner to the real wall inspection. include the selection of radioactive source, the calculation of compton back - scattering beam, the calculation of the basic condition of finding out the different materials and the determination of some important parameters as well. 3

    其主要內容包括入源的選擇,散粒子的理論計算,現異物的低條件計算以及系統的一些重要參數的確定,主要包括:放源的選擇,散的確定,后準直器的形狀與尺寸,前準直器的尺寸,前準直孔的小,檢測器的種類與型號,檢測器的效率等。
  2. Vertical angle of maximum candlepower emission

    光線的垂直
  3. A reasonable position of driving nozzle helps to achieve the maximum material flow that also depends on other parameters such as backpressure, properties of conveyed material and driving gas. it is observed that, an increase of convergent section angle is harmful to the pneumatic conveying system, and also influences on the mass flow rate of conveyed material, the distribution of static pressures in injector and the pressure drops of conveying pipe. in addition, within a reasonable scope of air mass rate, increasing the driving jet velocity is more advantageous than enlarging the dimension of driving nozzle

    試驗研究現,氣體噴嘴位置對氣固噴器的輸送能力影響,氣體噴嘴存在某一佳位置,而這一佳位置與背壓、輸送物料特性和輸送風特性相關聯;氣固噴器的收縮對其輸送能力、內部靜壓分佈和輸送管阻力特性均有適量影響,收縮對整個輸送系統均不利;在適當的輸送風范圍內,提高氣體噴嘴出口速度比擴氣體噴嘴尺寸更為有利,但氣體噴嘴出口速度過高會增加氣固噴器和輸送管內的能量損耗,給輸送帶來不利的影響;系統背壓與氣固噴器的氣體噴嘴出口速度的選取有關。
  4. Thus the maximum horizontal range is attained when the departure angle is 45°.

    因此,當為45時,有水平程。
  5. For many given initial velocity, there is one particular angle of departure for which the horizontal range is a maximum.

    對于任一給定的初速度,有一特殊的,以此,水平
  6. The ratio f / c decreases with the increase of power, but increases when pressure increase. the power has more marked effect on f / c than that of pressure. contact angle of fluorocarbon films obtained at different of power, pressure and treating time

    後研究了不同功率、壓力、濺時間對氟碳膜憎水性能的影響,並測量了氟碳膜的接觸現接觸隨功率的增加而減小,隨壓力的增加而增
  7. Energy distribution involves many radar ' s parameters, such as peak power of transmitter, maximum pulse width, antenna gain, rotating speed of antenna, beam width, covering range of elevation, maximum height and range and so on

    能量分配牽涉到雷達系統的各種重要參數如機峰值功率、脈寬、天線增益、天線轉速、波束寬度、仰覆蓋范圍、高度覆蓋、作用距離等。
  8. The bigger the diameter, the high the heat efficiency, but the weak the temperature increasing ability, length has less effect on the heat efficiency, tilt angle has less effect on the flow field and temperature field while it is larger than 30 degree, vacuum degree and emissivity have great effect on the flow field and temperature field while there is a great temperature difference between the liquid in the tube and the surroundings, the furring has less effect on the heat transfer but should be cleaned up in 3 - 5 years because of poor water quality, the higher the solar flux or the more the temperature difference between the liquid and the surrounding, the more the heat loss and the lower the heat efficiency

    分析了各種因素對太陽能真空集熱管流場和溫度場的影響。直徑越,熱效率越高,但升溫能力弱;長度對熱效率影響不;傾斜於30后,自然對流已經能夠充分進行,考慮以能夠吸收到太陽輻為主;真空度和率對熱效率和溫度場影響很,尤其是在介質溫度與環境溫度差異比較時;水垢對傳熱影響較小但由於水質的問題應該被3 5年清洗一次;太陽輻強度越,介質溫度與環境溫度差異越,熱損失越,效率越低; 4
  9. The tuning curve of type - i phase matching of bbo opo are measured with accuracy ; the maximum conversation in total of the system is about 31 % at 615. 6 nm, and it is fitted well with the gtp formula ; in the end we compared the output linewidth and unstable cavity far field beam qua lity of the bbo opo under the condition of type - i phase matching and type - ii phase matching, it is proved that we can obtain the parametric output of linewidth less than 0. 3 nm and the beam divergence angle approaching diffraction limits by take the advantages of type - ii phase matching and unstable cavity designs

    測量了該系統的轉換效率為31 ,並能與理論公式極好地吻合,後比較了在類相位匹配條件下和類相位匹配條件下的bbo - opo的輸出線寬,以及非穩腔的遠場光束質量,實驗結果表明,利用類相位匹配以及非摘要穩腔設計可以獲得線寬小於0 3nlm 、光束接近衍極限的參量光輸出。
  10. Single - layer model is convenient to apply but the unclear relationship between radiative and aerodynamic temperatures is still a bottleneck in this field. a new method was developed to derive reliable surface heat fluxes from radiative temperature viewed from arbitrary zenith angle. aerodynamic and radiative temperatures are connected through a so - called optimum component fraction ( ocf ) parameter - the fraction of vegetation in the field of view when the two temperatures are equivalent in oblique viewing

    該方法利用表面熱輻方向性和顯熱通量都是源於土壤和植被溫度的貢獻這一共同點,現在一定傾斜度的觀測下,視場中植被與土壤的比例可以較好地反映植被和土壤與氣進行湍流熱交換的貢獻率,所以稱該方法為佳組分面積比法,用佳組分面積比可以將任意度下觀測到的輻溫度訂正為空氣動力學溫度,經過地面和遙感數據驗證表明,用該方法計算的通量精度高於普通的單層模型。
  11. During flight of a solar powered aircraft, latitude and direction are changing at all times, therefore the optimal latitude and the optimal direction at different period is developed

    太陽能飛機在飛行時,飛行緯度和太陽方位都在隨時生變化,所以本文著重討論了每個時段使太陽能飛機獲得量的緯度和方向(太陽方位) 。
  12. With the disturbance of random wave the ship will inevitably roll and result in the ship ' s incline, especially, for small ships which the most obliquity of the ship is likely to reach above degree 15. in the actual combat the rolling movement of the ship will result in difficult control of the artillery for the artillerymen on the ship, reduce the artillery ' s probability of shots, and affect the power of the artillery by direct control of the object ( artillery ) fixed on the ship it can be kept horizontal state all the time

    尤其是對量的小型艦船,船體的甚至可達到15以上。在實戰中,船舶的搖蕩將造成炮手對船載火炮的操縱性能降低,降低火炮的命中率,影響到船載火炮威力的揮。通過直接控制固連于船體的火炮,使其始終保持在水平狀態,可以提高實戰中火炮的操縱性能,提高火炮的命中率。
分享友人