最小檢測范圍 的英文怎麼說

中文拼音 [zuìxiǎojiǎncèfànwéi]
最小檢測范圍 英文
minimum detection limits
  • 最 : 副詞（表示某種屬性超過所有同類的人或事物） most; best; worst; first; very; least; above all; -est
  • 小 : Ⅰ形容詞1 （體積、面積、數量、強度等不大） small; little; petty; minor 2 （年紀小的; 年幼的） youn...
  • 檢 : Ⅰ動詞1 （查） check up; inspect; examine 2 （約束; 檢點） restrain oneself; be careful in one s c...
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 范 : 名詞1 [書面語] （模子） pattern; mould; matrix 2 （模範; 榜樣） model; example 3 （范圍） boundar...
  • 圍 : Ⅰ動詞1 （四周攔擋起來 使裡外不通; 環繞） enclose; surround; corral 2 （繞; 裹） wrap Ⅱ名詞1 （四...
  • 檢測 : check; detection; test; gauging; detecting; sensing; [工業] checkout; measuring
  • 范圍 : scope; limits; extent; boundary; confines; range; range dimension; spectrum
  1. This text completely and systematically studies the status and the development of the pyrolysis and the fluidization of biomass, which distill the bio - oil in the domestic and international area, as well as the existing problems. this thesis primarily include following aspects : ( l ), by experimenting and measuring the energy ( heat value ) and the content of c, h, n chemical element of right 20 kinds of common biomass, on the base of the experimental result, and respectively established the biomass energy predict experiment formula with the element of h and c is from change, and passed the ro. os examination, which provides the basis and convenience for flash pyrolysis fluidization device energy to convert the rate to compute with biomass energy utilization calculation ; ( 2 ), proceeded the tg and dtg experimentation equal velocity ( 10 ? / min, 20 ? / min, 40 ? / min, 60 ? / min ) heating and constant temperature heating by studying on eight kinds of biomass samples, according to the experimental data and arrhenius formula, we established the dynamics model of pyrolysis of, then, using the goast - redfern and p function, we also solved the dynamics parameters and analyze out every kind of biomass ' s frequency factor and parameters of activation energy, and established the every kind of dynamics model of pyrolysis of biomass, all of these provide the theories and basis to make sure the reactor ' s flash pyrolysis work temperature scope design and the describing of pyrolysis reactor dynamics ; ( 3 ), in order to study and ascertain the process of heat completely getting to pyrolysis time of varied size biomass particles, we observed and measured the ratio of length and diameter ( l / d ) with the varied biomass through electron microscope, we concluded the l / d ratios usually is from 5. 0 to 6. 0, the average is 5. 3 ; ( 4 ), we studied the process of biomass transiting and the theory of complete pyrolysis time with the theory of complicated heat field, we got the time ( t ) of the varied size biomass particles arriving to complete pyrolysis, and we knew that the complete pyrolysis time and the time which get to the biggest production ratio are identical, all of these studies provide the theory base for design and forecasting the flash pyrolysis reactor solid state resort time ; ( 5 ), according to the above experiment result, synthesize to make use of the engineering the mechanics, engineering the material, machine the design to learn the principle, deduce, establish the theory of rotation cone flash pyrolysis reactor material resort time ( t ) and reasonable rotation velocity ( or frequency ) relation theory ; and ( 6 ), we gave the reactor ' s smallest cone angle certain, reactor cone wall strength design theory, the reactor production ability theory, the power design method and the critical rotation velocity theory

    本文較全面、系統地綜述了國內外生物質熱解液化制取生物燃油技術研究發展現狀及存在的問題，主要研究內容有： （ 1 ）實驗、測定了20種常見生物質的能量（發熱量）和c 、 h 、 n元素含量，根據實驗結果分別建立了以h和c為自變量的生物質能量預測經驗公式，並通過r _ （ 0 . 05 ）檢驗；為閃速熱解液化裝置能量轉化率計算和生物質能量利用率計算提供了依據和方便； （ 2 ）選擇了8種生物質試樣作了等加熱速率（ 10 min 、 20 min 、 40 min 、 60 min ）和恆溫加熱的tg和dtg實驗，根據實驗數據和阿倫尼烏斯公式建立了生物質熱解反應動力學微分方程，並採用goast - redfem積分法和p函數對其動力學參數進行了求解，解析出各種生物質的頻率因子和活化能參數，進而建立了各種生物質的熱解動力學模型，為科學確定反應器的閃速熱解工作溫度范圍及熱解反應動力學描述，提供了理論和依據； （ 3 ）為研究和確定不同尺度的生物質顆粒中心達到全熱解的時間，在體視顯微鏡下對不同粒度的生物質顆粒的長徑比進行了實驗觀察和測定，得出生物質的長徑比（ l d ）一般在5 . 0 6 . 0之間，平均為5 . 3的結果； （ 4 ）採用復雜溫度場傳熱學理論對生物質傳熱過程及充分熱解時間理論進行了研究，解析推導出了不同尺寸生物質顆粒中心溫度達到充分熱解溫度的時間（ t ） ，得出了理論推導的充分熱解時間與最大產油率的熱解時間相一致的結果，為閃速熱解反應器固相滯留時間設計和預測提供了理論依據； （ 5 ）根據上述實驗結果，綜合運用工程力學、工程材料、機械設計學原理，推導、建立了轉錐式閃速熱解反應器物料滯留時間（ ）與轉速（或頻率）合理匹配理論； （ 6 ）提出了轉錐式閃速熱解反應器的最小錐角設計、錐壁強度設計、生產能力設計理論和功率計算方法及臨界轉速理論等。
  2. In order to compare the retention time ( rt ) and limits of detection of 20 organophosphorous insecticides in different conditions the experiments were carried out using a medium polar capillary column ( db - 1701 ) and a no polar capillary column ( db - 1 ) with two detectors ( gc - fpd and npd ). the rt of 20 organophosphorous insecticides in two different polar capillary columns was a retention qualitative method for 20 organophosphorous insecticides. db - 1701 capillary column coupled with gc - fpd detector was used in the following study, the limits of detection were in range of 5x10 - 11 ~ 2x 10 - 12 g, the linear range was 2x 10 - 9 ~ 1 x 10 - 11g

    本研究用兩種檢測器（氮磷檢測器和火焰光度檢測器儀器）和兩種不同極性色譜梓（中極性毛細管色譜柱db - 1701 、非極性毛細管色譜柱db - 1 ）作為研究手段，比較了20種有機磷殺蟲劑在兩種色譜柱（ db - 1 、 db - 1701 ） 、兩種檢測器（ fpd 、 npd ）上的保留時間及最小檢測量，建立了用不同極性色譜柱上有機磷農藥的保留時間可作為有機磷農藥雙柱定性確證的的方法；建立了db - 1701 ， gc - fpd測定蔬菜中20種有機磷殺蟲劑的氣相色譜法，該方法的最小檢測量為5 10 ~ （ - 11 ） 2 10 ~ （ - 12 ） g ，線性范圍在2 10 ~ （ - 9 ） 1 10 ~ （ - 11 ） g時，相關性良好。
  3. The bias voltage in the circuit is supplied by the bgr, which reduces the power consumption and the area of the chip. this paper takes polygon interpolation as non - linear calibration method, adopts hdl verilog to design the digital duty cycle measuring circuit, from which we have obtained a group of

    選擇了臺積電0 . 25 mcmos工藝庫，利用hspice模擬工具對整個溫度傳感電路進行模擬測試，結果顯示所設計體溫計在30 c 50 c的溫度范圍內具有0 . 01 c以上的檢測精度、 0 . 1 c的顯示精度和180 w的最小功耗。
  4. The main work of the thesis is as follows : we design a novel omni - mirror more applicable in robocup, which is made up of an isomeric horizontal mirror and an isomeric vertical mirror and can make the resolution of the imaging of the objects near the robot on the field constant and make the distortion of the imaging of the objects far from the robot small in vertical direction ; we select a 1394 digital color camera and complete the development of its software program for data acquisition ; we design a image processing algorithm for the panoramic image, which can segment the image by color, extract the features of image fast and effectively and complete the recognization of target ; according the character of the imaging, we design a new fast hough transform algorithm for line detection, which can detect the white mark lines of the field realtimely, and then design a robot ’ s self - localization method based the mark lines, which only uses the information of omni - vision system ; finally we design a monte carlo localization method based on the information of omni - vision system and odometry, and present the localization results of two localization methods and analyze the experiment results and get the conclusions

    本論文的主要工作如下:設計了一種新的更適用於機器人足球賽的全向反射鏡面，該鏡面由水平等比鏡面和垂直等比鏡面組合而成，能夠使機器人近處一定范圍內水平場地上的物體成像解析度不變，遠處物體成像高度上變形較小;選擇了一款基於1394介面的數字攝像機，並完成其數據採集程序開發;針對全景圖像設計了圖像處理演算法，能夠快速有效的實現圖像顏色分割和圖像特徵提取，完成目標識別;根據全景圖像的成像特性，設計了一種新的用於直線檢測的快速hough變換演算法，能夠實時的提取出場地的白色標志線，並在此基礎上設計了完全利用全向視覺信息的基於標志線的機器人自定位方法;最後設計了一種基於全向視覺信息和里程計信息的montecarlo定位方法，給出兩種方法的定位結果，並分析實驗結果，給出結論。
  5. That extremely promotes the development of the receiver. also the requirement of receiver becomes more rigorous. as the name implies, receiver need to improve the linearity, to reduce the distortions rate and bit error rate, and to expend the dynamic range, of course should ensure the signal detect capability precondition

    這些要求同樣也促進了中頻接收機的不斷進步，要求其在保證信號檢測能力（即極高的靈敏度）的前提下:盡可能的提高接收機的線性度，使信號失真最小、誤碼率最低;盡可能的展寬接收機的動態范圍，使接收機的適應度更大、抗干擾能力更強。
  6. The macrostructure gives a space restriction to remote controlling welding robot and gives a virtual guide to structured laser sensor. the scanning and constructing of welding seam will finally determine the quality and reliability of tele - robot welding

    宏觀環境模型是遙控焊接機器人運動控制的一種空間約束，並為結構光傳感器的運動提供向導，小范圍焊縫模型的檢測與精確定義將最終決定遙控焊接的質量和可靠程度。
分享友人
分享到 Line

分享到臉書