最後溶液 的英文怎麼說

中文拼音 [zuìhòuróng]
最後溶液 英文
end solution
  • : 副詞(表示某種屬性超過所有同類的人或事物) most; best; worst; first; very; least; above all; -est
  • : 動詞(溶化; 溶解) dissolve
  • : 名詞(液體) liquid; fluid; juice
  • 最後 : last; final; ultimate
  • 溶液 : solution; liquor; scald; aqua
  1. When undertaking alexipharmic to contaminative birdhouse, must clean with eradicator first with defecate, solution of accept of second chloric acid disinfects reoccupy, use formalin and potassium permanganate fumigation finally

    對污染的禽舍進行消毒時,必須先用去污劑清洗以除去污物,再用次氯酸納消毒,用福爾馬林和高錳酸鉀熏蒸消毒。
  2. Glucose biosensors were then constructed by these nanocomposites, and their electrochemical properties had been explored. secondly, the self - assembled nanocomposite was formed by mwnts and biopolymer, and was used to study the electrochemical properties of nadh. and finally, the modified electrode which was formed by immobilizing small molecular onto electrode surface, was used to detect dsdna in the solution

    本論文首先,將多壁碳納米管( mwnts )與納米顆粒相結合,制備的納米復合材料用於構建葡萄糖生物傳感器,並研究了它的電化學性質;然,將mwnts與生物聚合物自組裝制備的納米復合材料用於研究nadh的電化學性質;,本文還將小分子自組裝固定在電極表面,用於測定中的dsdna 。
  3. After the hands of the ten volunteers were contaminated with c. difficile, they washed successively with : regular soap and warm or cold water, antiseptic soap and warm water, an alcohol - based solution, and eventually with a disinfectant towel

    十位受試者的手在污染艱難梭菌用如下幾種方法洗手:普通肥皂和溫水或冷水,抗菌肥皂和溫水,酒精基用消毒手巾擦手。
  4. Finally, by studying the heat transfer coefficient and the mechanism of mass transfer through the membrane pores, a complete mathematical model was proposed for the removal of voc from dilute aqueous solutions by vmd

    根據對傳熱系數和膜孔內傳質機理的研究,得到了真空膜蒸餾脫除水中voc全過程的數學模型。
  5. Using diethanolamine as aminating agent and glacial acetic acid as neutralizing agent, aminated epoxy acrylic cationic resin was prepared. the effect of technology of aminated epoxy acrylic resin on properties of eletrodeposition was studied by conductivity meter and electrophoresis apparatus. it was shown that, conductivity firstly decreased, and then increased with aminating temperature increase. in contrast with putting polyacrylic resin into thin acetic acid solution, the more compact film could be achieved by neutralizing polyacylic resin with glacial acetic acid and then add it into water. when neutralizing temperature was enhanced, the speed of electrodepsidon was found to increase, and the film was also more compact. increasing the dn leads to enhanced conductivity and smaller particle size. when dn equaled to 80, the smoothest film could be achieved

    以二乙醇胺為胺化劑、冰醋酸為中和劑,合成了胺化環氧丙烯酸陽離子樹脂.採用電泳儀和電導率儀,研究了胺化環氧丙烯酸樹脂合成工藝對陰極電泳塗料電沉積性的影響.結果表明,隨著胺化溫度的增加,電泳電導率先下降上升.將冰醋酸加入樹脂中中和,用水稀釋,比樹脂在醋酸稀中中和,電沉積性能更好.電沉積速率隨著中和溫度的上升而增加,電沉積膜緻密性相應增加.中和度( dn )愈高,電泳電導率愈大,粒徑越小,而塗膜外觀在中和度為80時達到
  6. From the information available for the preparation to be assayed ( the “ unknown ” ), assign to it an assumed potency per unit weight or volume, and on this assumption prepare on the day of the assay a stock solution and test dilution as specified for each antibiotic but with the same final diluent as used for the usp reference standard. the assay with 5levels of the standard requires only one level of the unknown at a concentration assumed equal to the median level of the standard

    根據有效的信息制備試驗,指定一個假定的每單位重量的效價或者體積,然在假設的基礎制備當天儲備試驗和稀釋作為每一種抗生素指定的效價,但是當使用相同usp參考標準品的終稀釋時,試驗應使用平行5的標準要求僅有一份未知的做為濃度等同於中部的標準。
  7. Finally, the mutual spreading between the sample zone and the carrier solution in flow injection analysis ( fia ), would always result in the sample zone ' s widening and reducing the sensitivity

    ,流動注射分析中載流與樣品的相互擴散會導致樣品區變寬而降低靈敏度。用空氣作載流就沒有擴散,靈敏度極高。
  8. Secondly, with the demands of monitoring plant water potential in mind, the apparatus has been tested with satisfactory results thirdly, utilizing that testing apparatus and nacl solutions at 20 c, a study is preformed to investigate the on - line non - invasive automatic monitoring technique of plant water potential, with some models of monitoring plant water potential properly established. results show that the second model of monitoring plant water potential is desirable after comparing. then, comparative measurements are done with kc1 solutions, using both the testing apparatus and the commercial wescor water potential meter

    利用所設計的試驗裝置和不同濃度的氯化鈉進行在線無創傷自動監測植物水勢的試驗研究分析,並建立了一些監測植物水勢的模型,經過比較分析,確定優地能實現在線無創傷自動監測植物水勢的模型;然運用此模型對不同濃度氯化鉀的水勢進行測定,以及與美國wescor公司生產的植物及土壤水勢測定儀進行比較測試試驗,通過對這些比較驗證試驗的分析,認為此模型在植物水勢在線無創傷自動監測方面具有其可行性。
  9. The resulting brew of carbon compounds and ions is thus rather complex

    調制出的碳化合物、碳離子因而變得很復雜。
  10. The polystyrene particles with 2. 8 micrometer mean diameter were prepared by dispersion polymerization and hollow porous micro - sphere were prepared by extraction after seeding emulsion polymerization. particles with multi - hollow structure were obtained and characterized by sem, additionally the mechanism and factor about formation of porous structure were also discussed. to prepare the biodegradable nano - particles, reversed - phase micro - emulsion and ionotropic gelation methods were used

    利用分散聚合法制得了粒徑約為3 m的聚苯乙烯種子微球,再通過脹、交聯、種子乳聚合及萃取處理,得到中空多孔的聚合微球,並討論了其成孔機理和各博士論文功能型復合超微粒子的制備研究因素的影響。
  11. Furthermore, analytically the difference of the induction period of nucleation among different solutes or solvents was due to the difference of the solute clusters existing in the supersaturated solution

    結構出發探討了hhm晶體在不同劑中的成核行為,以及質的改變對成核的影響。
  12. The results showed that the reducing organic acid solution include oxalic acid which were generated in the reaction liquid caused the corrosion of the titanium pressure - relief valve, which mostly because the feed solution in the 1 ( superscript # ) desulfurizing unit were mixed with the waste water discharged by 2 ( superscript # ) desulfurizing unit right after the time when the inhibitor were stopped being used anymore

    結果表明,由於二脫硫裝置停用緩蝕劑排出的廢水混入一脫硫裝置的原料中,進而使反應中形成了草酸等還原性有機酸終造成鈦制減壓閥發生腐蝕。
  13. First, polymer - metal - solvent solution was prepared. secondly it was coated on the cathode surface. finally the electrochemical reduction was processed in a particular medium solution

    首先制的聚合物?金屬?劑三元體系,再將其均勻塗于陰極表面乾燥至一定的程度,放入電解質中進行電化學還原。
分享友人