有效峰值速度 的英文怎麼說

中文拼音 [yǒuxiàofēngzhísùdù]
有效峰值速度 英文
effective peak velocity, epv
  • 有 : 有副詞[書面語] （表示整數之外再加零數）: 30 有 5 thirty-five; 10 有 5年 fifteen years
  • 效 : Ⅰ名詞（效果; 功用） effect; efficiency; result Ⅱ動詞1 （仿效） imitate; follow the example of 2 ...
  • 峰 : Ⅰ名詞1. （山的突出的尖頂） peak; summit 2. （形狀像山峰的事物） peak-like thing Ⅱ量詞（用於駱駝）
  • 速 : Ⅰ形容詞（迅速; 快） fast; rapid; quick; speedy Ⅱ名詞1 （速度） speed; velocity 2 （姓氏） a surna...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 有效 : effective; valid; efficacious
  • 速度 : 1. [物理學] velocity; speed; blast; bat 2. [音樂] tempo3. （快慢的程度） speed; rate; pace; tempo
  1. Due to existing signal processing technology ’ s shortage such aslow measurement, narrow measurement range precision and other poor performance, we introduced a high - precise signal processing technology : firstly, to get power spectrum with hanning windowed welch modified periodogram, search its peak value frequency ; secondly, to apply zooming analysis via goertzel algorithm ; at last, to get a highly precise doppler frequency with energy centrobaric rectifying algorithm 。 the simulating result indicated that this technology introduced could get accurate doppler frequency 。 depending on above discussed technology, we designed a signal processing scheme, and developed a signal processing system. the running result showed high performance, verified the feasibility and reliability of the highly precise signal processing technology introduced. in a word, the technology improved ldv ’ s performance such as measurement precision, measurement range, dynamic response time 。 and it will have a wide application foreground

    針對存在的缺點，本文提出了一種應用於激光多普勒測速的高精度信號處理技術，即首先利用加hanning窗的welch修正周期圖演算法得到信號功率譜，搜索其譜峰值頻率，接著利用goertzel頻譜細化演算法對搜索的譜峰進行細化分析，再引入能量重心頻譜校正演算法對細化后的譜峰進行校正分析，從而將離散頻譜分析演算法、頻譜細化演算法和頻譜校正演算法三者有機結合起來，充分發揮各自的優點:通過加hanning窗的welch修正周期圖演算法快速得到功率譜及峰值頻率，通過goertzel演算法獲得分析頻帶的高解析度頻譜，然後通過能量重心校正演算法對細化后的頻譜進行高精度校正，這樣不僅保證了演算法的高效性，而且大大提高了分析的精度。
  2. For increasing the effective material peak - value power ( empvp ), solving the contradiction between enhancing the pmsm ' s flux - weakening capability in the electromotor state and reducing the pmsm ' s connatural adjustment ratio in the dynamotor state and improving the efficiency of the pmsm, some solving method are taken as follows : the influence of length / diameter ratio to the empvp is analyzed, and the optimum size of length and diameter is chosen

    主要是從提高電機的有效材料峰值功率、解決pmsm提高電動機運行狀態時的弱磁擴速能力和減小發電機運行狀態時的電壓調整率之間的矛盾及提高電機的效率著手，分析了長徑比、氣隙長度對有效材料峰值功率的影響，並確定了它們的最佳尺寸。
  3. In order to improve the efficiency of classification based on feature matching, the method of azimuth estimation from sar image is studied. a method of target ' s azimuth estimation from sar image using peak featur e based on linear regression is proposed, besides goodish estimation accuracy and high computation efficiency, it can also provide the confidence interval of the estimation, which can meet the need of model - based sar atr system that uses feature very well

    為了提高基於特徵匹配的saratr系統的分類效率，論文進一步研究了sar圖像目標方位角估計方法，提出了一種利用峰值特徵基於線性回歸的sar目標方位角估計方法，該方法除了具有計算速度快、估計精度較高的特點之外，還能在估計方位角的同時，給出該估計的置信區間，從而能更好地滿足利用特徵基於模型saratr系統的需要。
  4. The following results were found, i. e., the water ratio affects obviously the acoustic wave velocity of rock sample ; the wave velocity is higher in saturated rock samples than in unsaturated ones ; and it decreases gradually with the strain of samples during uniaxial compression ; and also with the lengthening holding time at 160 ; when heating the samples the acoustic wave velocity increases slightly in initial stage and comes to the peak value at 60, then decreases gradually with increasing temperature ; meantime, there is a certain temperature effect on rock samples size

    實驗發現含水率對波速影響比較大，飽和巖樣的聲波傳播速度高於不飽和巖樣的聲波傳播速度；人工預制裂紋對聲波傳播速度影響不大；單軸壓縮條件下，聲波傳播速度隨應變增加逐漸降低；在同一溫度（ 160 ）下，波速隨保溫時間的增加而逐漸降低；在對巖樣逐漸加熱情況下，初始加熱階段波速略有升高，當溫度達到60時，巖樣波速達到峰值，之後隨著溫度繼續升高其波速逐漸下降；波速隨溫度變化具有一定的尺寸效應。
  5. Because ga possesses the traits of can global random search, the robustness is strong, been use briefly and broadly, it didn ’ t use path search, and use probability search, didn ’ t care inherence rule of problem itself, can search the global optimum points effectively and rapidly in great vector space of complicated, many peak values, cannot differentiable. so it can offset the shortages of nn study algorithm, can reduce the possibility that the minimum value get into local greatly, the speed of convergence can improve, interpolation time shorten greatly, the quantity of training reduce

    因為遺傳演算法具有全局隨機搜索能力，魯棒性強、使用簡單和廣泛的特點，它不採用路徑搜索，而採用概率搜索，不用關心問題本身的內在規律，能夠在復雜的、多峰值的、不可微的大矢量空間中迅速有效地尋找到全局最優解，所以可以彌補神經網路學習演算法的不足，使陷入局部最小值的可能性大大減少，使得收斂速度提高，訓練量減小。
  6. The results demonstrated that the weft tension and its amplitude can be effectively reduced and positively controlled to meet the requirements of weaving provided that suitable weft storage feed unit, weft feeding position and tension device are selected, modified trapezoid acceleration motion with smaller peak acceleration as the law of weft insertion motion is adopted, and the route of weft yarn motion is optimized

    結果表明：通過選用合適的緯紗儲緯器、張力器和緯紗供緯位置，選用加速度峰值較小的改進型梯形加速度引緯運動規律，優化緯紗運動路徑，可有效地降低緯紗的張力值和張力變化的幅度，達到對緯紗張力進行積極控制的目的，滿足織造工藝的要求。
  7. Through analyzing bed ' s response to wave, in the condition that super - stratum is more hard and second - stratum is more soft in region of interest, super static interstitial hydraulic pressure amplitude die away rapidly between stratums, before in sight of boundary between hard and soft stratum, plane effective pressure increase to max. shear stress reach peak value when bed thickness is approximately 2. 7 meters, then it will decrease to the minimum on the place where the flexible soil has a common boundary with the rigidity, so the boundary is the most destroy plane on engineering. on the basis of reconnaissance in situ, in normal situation of sea, the structure slides to the basin along the boundary

    通過對底床在波浪下的響應分析，對于研究區底床上層較硬而第二層較軟的情況，超靜孔隙水壓力幅值在層間交界處迅速衰減，在臨近硬、軟地層交界處前，水平有效應力增至最大，剪切應力在底床厚度大約2 . 7米左右達到峰值，然後減小，到硬、軟層土交界位置，達到最小，因此這個界面就是最容易發生破壞的工程軟弱面，現場勘查證明，即使在正常海況下，構築物也會沿坡以此交界面為滑動面，緩慢向「盆」底滑動。
  8. ( 3 ) the most principal factors that influence the supersonic atomization process include the flow ratio of the gas - liquid metal ( gmr ) value, the flow of atomizing of gas and the range of the inverse vortex taper. the more of the value of three factors, the more advantage they are for the atomization and the more fine the powders are. ( 4 ) the produced powders are the best in efficient atomization efficiency, particle diameter, particle shape and dispersion when the solder alloy is zhl63a, atomizing medium is n2, the protrusion h = 6. 0mm, atomizing gas pressure p = 100mpa, over - heat temperature t = 167 ( t = 350 )

    研究結果表明： （ 1 ）超音速霧化器的氣體流場在導液管下端形成一個倒渦流錐，在二維空間上呈軸對稱的雙峰分佈，負壓形成於這個倒渦流錐內； （ 2 ）修正後的霧化氣體速度公式可以滿足超音速霧化的要求； （ 3 ）影響超音速霧化工藝最根本的因素有氣液質量流率比（ gmr ）的大小、霧化氣體流量和倒渦流錐范圍，三個因素的值越大，對形成細粉越有利； （ 4 ）在焊錫合金為zhl63a ，霧化介質微n _ 2 ，導液管突出高度取h = 6 . 0mm ，霧化氣體壓力取p = 1 . 0mpa ，合金過熱度取t = 167 （ t = 350 ）時，所制得的粉末在有效霧化率、顆粒球形度、粒度及其離散度三個方面綜合性能最好。
  9. It is found that : ( 1 ) for linear slope, redistribution of incoming energy flux in modenumber space depends on both the modenumber of incident waves and the ratio of the slope of incident wave ray to slope of topography ; both the transmitted and reflected energy flux ( only for supercritical linear slope ) focus near one or two modenumbers ; for supercritical linear slope, the energy flux scattering to higher modenumbers becomes larger and the energy flux to lower modenumbers becomes smaller as the slope of incident wave ray comes near to slope of topography ; ( 2 ) for convex slope, energy flux is redistributed in wide - range modenumbers and also show peaks on lower - modenubers and higher - modenumbers ; ( 3 ) for concave slope, energy flux is also redistributed in wide - range modenumbers, but does not show peaks on higher - modenumbers as supercritical linear slope and convex slope do ; ( 4 ) the total energy flux scattering to higher modenumbers is approximately equal to the total energy flux to lower modenumbers for internal waves propagating over both convex slope and concave slope, which means the concave slope is the same efficient to convex slope in scattering energy flux to higher modenumbers ; ( 5 ) for convex slope, the wave ray reflected from near - critical topography can extend to deep ocean and shallow shelf, while for concave slope, the wave ray reflected from near - critical topography can only extend to limited distance, then meet the topography and be reflected again ; generally the shear of the internal waves reflected twice from concave slope is not enhanced while the enhanced shear does also appear before second reflection takes place, the enhanced shear can bring about intense mixing, so internal waves reflected from concave slope can also produce marked mixing near critical slope

    3 、內波在凹地形上傳播時，能通量在模態上的分佈范圍也比較寬，但與凸地形和超臨界線性斜坡地形相比，能通量在高模態上的分佈沒有明顯的峰值。 4 、從總的能通量來講，內波在凸地形和凹地形上傳播時，向高模態散射的能通量與向低模態散射的能通若十地形下內波傳播及內潮生成問題的理論解量近似相等，這意味著二者在向高模態散射能通量方面具有同等效率。 5 、凸地形上臨界點附近的反射，反射波的波射線能夠延伸到深海和陸架，凹地形上臨界點附近的反射，反射波的波射線很快遇到地形發生二次反射，一般來講二次反射后回到深海的波動其速度剪切並不很強，但是在進行二次反射之前的區域，速度剪切仍然很強，因而內波在凹地形上的反射依然能夠在地形附近區域，產生強的速度剪切區，誘發混合。
分享友人
分享到 Line

分享到臉書