未燒結的 的英文怎麼說

中文拼音 [wèishāojiēde]
未燒結的 英文
unsintered
  • 未 : Ⅰ副詞1 （沒） did not; have not 2 （不） not Ⅱ名詞1 （地支的第八位） the eighth of the twelve ear...
  • 燒 : Ⅰ動詞1 （使東西著火） burn 2 （加熱或接觸某些化學藥品、放射性物質等使物體起變化） cook; bake; hea...
  • 結 : 結動詞（長出果實或種子） bear （fruit）; form （seed）
  • 的 : 4次方是 The fourth power of 2 is direction
  1. Heat convected, a mode of motion developed by such combustion, was constantly and increasingly conveyed from the source of calorification to the liquid contained in the vessel, being radiated through the uneven unpolished dark surface of the metal iron, in part reflected, in part absorbed, in part transmitted, gradually raising the temperature of the water from normal to boiling point, a rise in temperature expressible as the result of an expenditure of 72 thermal units needed to raise i pound of water from 50 to 212 fahrenheit

    燃燒所引起的運動形式之一-熱對流傳熱，不斷地加速度地從熱源體傳導給容器中的液體，由那凹凸不平未經打磨的黑色鑄鐵面把熱向周圍發散出去一部分反射回來，一部分被吸收，另一部分被傳導，使水的溫度從常溫逐漸升到沸點。這種溫度的上升可作為消費結果標志如下：將一磅水從華氏五十度加熱到二百十二度，需耗七十二熱量單位。
  2. The result is that unburned gasoline or carbon monoxide come out the tail pipe.

    結果，排氣尾管即排出了尚未燃燒的汽油及一氧化碳。
  3. From simulations and data of fire site, most air preheater fire often appear when boiler is started in cool state and standby which fuels of insufficient combustion coagulate and congregate on the parts of air preheater. when the temperature of smoke inpouring air preheater increases, aggregate fuels and sediments will combust in stated temperature conditions. it is called the second combustion of air preheater

    這些起火起因於燃料油的不充分燃燒，其結果是未充分燃燒的燃料油凝結和聚集在空氣預熱器的部件上，當進入空氣預器的煙氣溫度增高時，沉積的燃料油被烘烤，當達到一定溫度條件時，則可點燃這些燃料油污沉積物，造成火災發生，這通常被稱為空氣預熱器的二次燃燒。
  4. The results showed that : there were five stages in the rising process of the internal temperature of untreated, fire - retardant solution soaked, and fire - proof paint coated wood during the fire ; the carbonization rate of wood decreased by 21. 1 % ~ 35. 6 % and the rising speed of internal temperature also declined greatly when wood was soaked in fire - retardant solution or coated with fireproof paint ; the carbonization rate of white pine was 8. 5 % ~ 17. 4 % higher than that of the northeast china ash ; for untreated wood, the carbonization rate in tangential direction was 5. 8 % ~ 10. 5 % higher than that in radial direction ; the internal temperature of wood varies with the developing direction of combustion

    結果表明：火災發生過程中未處理木材、阻燃浸漬處理和塗刷防火徐料木材內部溫度上升過程出現5個階段；經過阻燃浸漬處理和塗刷防火塗料后，木材的燃燒炭化速度降低了21 . 1 % ~ 35 . 6 % ，內部溫度上升速度大幅度下降；白皮松木材的燃燒炭化速度比水曲柳木材的燃燒炭化速度快8 . 5 % ~ 17 . 4 % ；未處理木材沿弦向的燃燒炭化速度比徑向快5 . 8 % ~ 10 . 5 % ；木材內部的溫度變化沿燃燒推進方向不同而不同。
  5. In sintering process, for melted mineral fines bind unmelted core ores when cooled, the self - intensity of binding phase in iron ores is one of the basic indexes to estimate sintered binding status

    摘要在鐵礦粉燒結過程中，熔化的礦粉在冷卻過程中起著粘結周圍未熔礦粉的作用，因此這一粘結相的自身強度是衡量燒結礦固結狀況的重要指標之一。
  6. The density of the al bulk nanomaterials is only 75 percent of mat of normal ordinary coarse crystallized counterparts, which means there are a lot of holes or loosen structure in the nano - bulk al

    通過模壓成形的納米金屬鋁和銅的塊體的密度只有普通體材料密度的75左右，表明得到的未經燒結的納米鋁塊體內部可能還存在很多孔隙或很多疏鬆的組織。
  7. In order to solve the problems effectively, under the auspices of 863 plan in china, the synthesis diagnosis has been carried by means of measuring and numerical imitating the combustion chamber of refining column, and some conclusions is such as : ( 1 ) through measuring the temperature and combustion in the burning chamber of the refining column, the result shows the temperature difference on the same level is more than that in height direction, and there is a few of co in bottom of burning chamber. ( 2 ) in order to ensure normal work of flue system in lead column in the course of zinc refining, theoretic calculation and measure about the flow resistance of exhaust gas are carried through. the results of study reveal that drawing out force of chimney is inadequate, which is mainly caused by illogicality of flue construction

    在研究過程中，採取了現場實測和數值模擬手段對韶關冶煉廠鋅精餾鉛塔燃燒室及排煙系統進行了綜合診斷，具體結果包括如下： （ 1 ）完成鋅精餾鉛塔燃燒室內溫度測試以及燃燒狀況的測試，結果發現：鉛塔燃燒室內水平方向的煙氣溫度並非均勻，而且其溫差比上下方向的溫差更大，以及鉛塔燃燒室尾部存在co未燃燼問題； （ 2 ）為了保證鉛塔煙氣系統的正常工作，對煙道系統的阻力進行了理論計算及測試分析，結果發現：鋅精餾鉛塔煙氣系統中煙囪抽力不夠，這主要是煙道結構不合理所造成的。
  8. The x - ray diffraction, scanning electronic microscope and the squid were used to characterize the properties of the mgb2 core in mgb2 / fe tapes and wires. the effect of the proportion of mg, b and sic as well as the sintering parameters on the phase formation, microstructure and the critical current densities of mgb2 / fe tapes and wires was discussed in details. the results showed that the high purity of mgb2 core could be synthesized by both the traditional vacuum sintering and the sparking plasma sintering and the vacuum sintering environment restrained the oxidation of mg effectively

    相對于傳統真空燒結， sps燒結方式成相速度快、樣品晶粒細小均勻、 mgb2超導芯緻密性好、晶間連接優良，因而sps燒結樣品的臨界電流密度明顯高於傳統真空燒結樣品，其中未摻雜的帶材樣品經過sps800 ， 15分鐘燒結后，自場下的臨界電流密度jc值在10k時達到8 . 64 105a / cm2 ，而且隨著測量溫度和外加磁場的增加， sps燒結樣品的臨界電流密度下降率比傳統真空燒結樣品緩慢，在20k ，自場時為5 . 97 105a / cm2 ， 20k ， 3t時，臨界電流密度值仍大於104a / cm2 。
  9. Standard test method for green strength for compacted metal powder specimens

    金屬粉末密壓試樣未燒結強度的標準試驗方法
  10. However, with the demand for environmental prelection inhancing, the emission which had not been taken into account is noticed now. in order to improve heater emission and performance and to meet the full needs of users and the development of futurel automobile environment pretection, the paper which uses qn700 air oil - heater as the research objective, theoretically analyzes, experimentally do researches, searches for the main emission source, and brings up efficient improving methods based on the process of combustion x the characteristics of exhaust. the principle of operation

    為了使加熱器的燃燒排放性能更加完善，充分滿足用戶的使用要求和未來汽車環保要求發展的需要，本論文以國產大型客車廣泛使用的qn700型空氣燃油加熱器為研究對象（其燃燒結構和工作原理具有一定的典型性） ，針對這一典型的國產空氣燃油加熱器的燃燒過程、排放特性以及工作原理進行理論分析和試驗研究，找出主要污染源及其產生機理，並在此基礎上根據現有的結構提出有效的改進方案。
  11. Finally, the paper summarized all research conclusions, and proposed some reformative advices on such techniques of the rbcc secondary combustion organization, including the necessity, the feasibility and the practical value of hardware and software being migrated to a single chip in the future were also referred, so that some theoretic provisions and tech supports are offered to the investigations of rbcc

    最後，本文總結了將模糊控制方法應用於rbcc二次燃燒組織方面的研究結論，並提出改進建議，包括未來將有關軟、硬體系統移植到單片機上的必要性、可行性和實際價值等等。論文的工作將為rbcc燃燒組織的進一步縱深研究提供一定的理論準備和技術支持。
  12. 5 percent additional between the mo - cu sinter with ni nh4cl activator and the mo - cu sinter without n nh4cl activator, and the ni activator had the better influence than the nh1

    添加活化劑的mo - cu燒結體比未加活化劑的燒結體相對密度一般高0 . 5 1 . 5個百分點。
  13. The results of the experiments show that the soot emission decreased greatly and the nox emission was improved, while co and hc emission increased but still lowered than gasoline engine, the power output and torque of the engine have not been influenced and the specific energy consumption was improved

    試驗結果顯示，這種新型的燃燒模式不僅改善了發動機的碳煙排放，而且no排放也得到了改善，而hc 、 co排放則較原機嚴重，但還是低於汽油機的排放水平；發動機的動力性能未受影響，能耗率有所改善。
  14. When sintered at 1050c, the wear resistance of the composites were better than that of the ferroalloy under both low and heavy load without oil lubrication. the wear resistance, hardness, and other mechanical properties of the composites with nickel coated sic were better than those of the composites with bare sic particles. however, when sintered at 1100c, interfacial reaction became so acute that the properties of the composites with nickel coated sic particles was worse than those of the composites with bare sic particles

    試驗結果表明：與鐵合金相比，在1050時燒結時，加入適量的sic后，耐磨性有較大的提高；而且加入鍍鎳sic的復合材料的耐磨性、硬度和拉伸強度等力學性能比加入相同含量的未鍍sic的材料的性能要好；在1100燒結時，由於界面反應的加劇，含有鍍鎳sic材料的性能反而比含有未鍍sic材料的性能差。
  15. At present, there was n ' t reported about optimization of mixing and transport line system at raw material yard inside and outside of our country, there are only similar mixing model in sinter and steel - making plant

    目前國內外對于原料場配料與作業線的系統優化設計還未見報道，只有燒結廠、煉鋼廠有類似的配料模型。而且可用於指導原料場生產的系統優化方案也未見報道投入使用。
  16. Will remain useful for years to come and guarantees consistent, high - quality firing results

    更能夠滿足未來的需要，保證konistent最佳質量的焙燒結果。
  17. The physical properties were measured using x ray diffraction analyzing, sem observing, fracture toughness and fracture strength measuring, micro - hardening and density detection etc. the results display that the relative densities are above 98 % for all the samples, especially reaches 99. 8 % for the sample added 2vol % sic nano - particles

    在sic加入量為2vol %時，由於分散比較均勻，對樣品燒結性能影響不大，相對密度可達99 . 8 % 。在未加sic時，四方zro2的含量最高為50 . 5vol % 。隨sic加入量的增加，四方相zro2的含量呈下降趨勢。
分享友人
分享到 Line

分享到臉書