束流引出 的英文怎麼說

中文拼音 [shùliúyǐnchū]
束流引出 英文
beam extraction
  • : Ⅰ動詞1 (捆; 系) bind; tie 2 (控制; 約束)control; restrain Ⅱ量詞(用於捆在一起的東西) bundle;...
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  • : Ⅰ動詞1 (牽引; 拉) draw; stretch 2 (引導) lead; guide 3 (離開) leave 4 (伸著) stretch 5 (...
  • 引出 : draw forth; lead to; drawing off; extraction; elicitation; eduction; exhaustion; recording; deriv...
  1. In the problem of way choice of the equity alliance, the article pointed out that the joint capital pattern has withdrew gradually under the system restraint. and it using the case analysis method, analysis the income of shanghai bank who is in the pattern of foreign capital investing ( to become mainstream pattern ), and it also proposes that we should calmly regard the share - holding pattern

    在股權聯盟的方式選擇問題上,文章指制度約下的合資模式已逐步退,並採用案例分析方法,對上海銀行成功的資參股模式(已成為主模式)做收益分析,但同時提應冷靜看待參股模式。
  2. We propose a novel controllable atomic beam - spiller based on the uccc and discuss the splitting mechanism of the guided atomic beam in the beam splitter from two aspects of the magnetic - field distribution and the trace of the guiding centers. the splitting ratio of the beam splitter can be adjusted by adding a homogeneous bias magnetic field along the y - direction, and the relationship between the splitting ratio and the additional bias field is analyzed

    本文提了一種採用在y方向上加一偏置磁場來實現分比可控的新穎原子分器,並從磁場分佈和導中心軌跡兩個方面,詳細分析和討論了基於u -型載導體所構建的原子分器的分機制。
  3. ( 4 ) chapter vi. the theory of ion curren extraction of rf ion source is investigated, the reason of emission surface formation and its effect on ion curren extraction are reasearched emphatically

    ( 4 )對高頻離子源的束流引出原理作了理論推導和分析,著重研究了發射面的形成及其對特性的影響。
  4. Finally, the characteristics of ion curren extraction in different conditions are simulationed with magic software, and the parameter of best emission surface is obtained

    最後,採用magic程序對高頻離子源不同參數下的束流引出特性進行了數值模擬,得到了獲得最佳的離子所要求的等離子體發射面參數。
  5. After 40 hour irradiation time, about 7 ci of radioactive isotope 64cu was produced via 63cu ( n, y ) 64cu reaction. after simple disposal, the irradiated copper sample was installed in the high - intesity ion sputter source on the hi - 13 tandem accelerator. then 64cu ions extracted from the high - intesity ion sputter source and injected into the tandem accelerator, 64cu ions can be accelerated to an energy of 80 mev and formed the off - line rnb since natural

    S )的熱中於通量下,經過34個半衰期輻照,通過『 u … , y )生成放射性l司位素『 cll ,然後將放射性銅靶錐注入串列加速器強濺射離于源中,mcll負離于,經刁串列加速器加速而得到能量為80mcv的離線放射性核「 cll叭。
  6. The orientation path and residual network were defined, the new maximum flow algorithm in network with both node and edge capacity confined was put forward based on feasible flow decompose theorem and by way of the search in artificial intelligence

    定義了有向路徑和殘量網路的概念,依據可行分解定理,入人工智慧中搜索的方法,以鄰接矩陣為網路數據存儲結構,提條件約下的網路最大新演算法。
  7. The calculated results show that, for low energy protons ( energy less than several decade mev ), the contribution of proton nuclear reaction to energy deposition can be neglected ; while for high energy protons ( energy greater than several hundred mev ), the great difference appears for the above two cases. this gives us an indication that the contribution of proton nuclear reaction to the energy deposition must be concerned for high - energy protons. the propagation process in material of thermal shock wave induced by high - energy intense - current pulsed proton beam irradiation is calculated for several different proton energies

    對于入射能注量為418 ( j cm ~ 2 )脈沖寬度為0 . 1 s的矩形脈沖強質子,計算結果表明,由於質子能量不同,起的初始熱激波( 0 . 1 s時刻的熱激波)有單峰結構,也有雙峰結構,不同能量的強質子起的熱激波在傳播的過程中都會現明顯的彈性前驅波。
  8. ( 4 ) light - induced scattering in sbn : 61 : cr crystals under applied fields and its suppression are studied. a new method is proposed that the scattering light can be suppressed through erasure of scattering gratings by higher power pump beam ( coherent or incoherent )

    ( 4 )討論了sbn 61 cr晶體在外加直電場作用下的光感應光散射現象及其消除方法,提通過入另外一相對高強度的光(相干或者非相干) ,利用其對散射光柵的擦除作用消除信號光的散射。
  9. In the angle of economics, this paper firstly analyzes the present flow situation and main problems in existence of our military science and technology human resource, and then analyzes flow and equilibrium of supply and demand from three aspects of the quantity 、 structural and behavior ; systematically describes individual decision and unit decision of military science and technology human resource on the angle of cost and profit, reaches the conclusion that in the flowing process, we should strengthen individual ’ s autonomous right properly, establish “ the leading type of armed forces ” human resource disposition mechanism ; in succession this paper has not only put forward the basic standard of the reasonable flow of the military science and technology human resource ? the effectiveness of combat, but also explained it carefully from flow quantity, flow direction and structure, established optimum floating rate ; finally, having based on the conclusion, the paper puts forward four mechanisms ? fetching in person and brains, inner flow, encouragement restraint and reserving brains in outflow mechanisms that promote our military science and technology human resource to flow reasonably

    本文立足經濟學的角度,在分析軍事科技人力資源動現狀與存在問題的基礎上,從數量、結構、行為三方面分析了軍事科技人力資源動中的供求均衡;從成本收益角度系統描述了軍事科技人力資源的個人決策和單位決策,得了在我軍科技人力資源的動過程中應該適當加強個人的動自主權,建立「軍隊導向型」人力資源配置機制的結論;接著本文不僅提了軍事科技人力資源合理動的根本標準?戰鬥力效用,而且從量、向和結構上進行了細化,確立了最優的動率;最後,本文提了促進我軍科技人力資源合理動的四大機制:智機制、內部動機制、激勵約機制和淘汰退機制。
  10. ( 3 ) chapter v. plasma characteristics of rf ion source is investigated. a zero - dimensional numerical dynamic colisional radiative atomic and molecular ( cram ) model is suggested to simulate the microphysical process. all species " population number densities in plasma are calculated in non - thermodynamics equilibrium condition, and proton content in extracted ion current are measured with 60 ? magnetic analyzer

    ( 3 )提了高頻離子源等離子體的零維cram模型( collisionalradiativeatomicandmolecularmodel ) ,計算了非平衡態( nte )下等離子體中分子、電子、離子、基態原子、激發態原子等粒子濃度,並在zf - 200kev中子發生器上,用60磁分析器實驗測定了的質子比。
  11. It tell us : the abrasive capability of fly ash ; the similar calculation of ash erosion ; the calculation of ash erosion in the tube in turn and tube out of turn ; the reason of tube abrasion for gas flue ; the influence of air parameter for fly ash erosion ; the influence of changing temperature ; the influence of the flue gas composition, etc. next, it advances the solving measure ; reduce the flue gas velocity ; reduce the concentration of fly ash ; responsible construction : replace smooth tube with spiral tube ; use the new material of abrasion ; fuel desulfurization ; reduce so3 of flue gas ; raise flue gas temperature, making it up the dew point ; use the abrasion - resistance material to resist abrasion

    討論了飛灰磨損性能、管壁受飛灰沖蝕的近似計算、灰粒對順列管和錯列管的磨損計算、煙氣走廊起對的磨損機理、空氣動力參數對飛灰沖蝕的影響以及受熱面壁溫變化及煙氣成份對飛灰磨損的影響等問題。接著提了解決的措施:降低平均煙氣速;降低飛灰濃度;使用鰭片管、螺旋翅片管代替光管;選擇合適的結構及排列方式,減少煙氣中so3的含量;提高受熱面壁溫使之大於煙氣的露點溫度;採用抗腐蝕材料作受熱面等防腐蝕的措施。
  12. Under a certain magnetic field, the density and stability of anode plasma determines the ion current density and its fluctuation

    在確定磁場強度下,陽極等離子體密度和穩定性決定了離子密度的大小及其波動幅度。
  13. It is a modern one in the world with its advantage : fierce current, high electricity state, high purity, lot kinds of ions, reliable, easy operation

    Mevva離子注入機突的優點有:強:高電荷態高純度離子種類多大面積穩定可靠,易操作。
  14. There is a part of beam loss during the course as the neutralization of high - energy particles dragged from the ion source, the deflexion of charged particle on the beam stream and the scraped beam of exceeding beam waist and low density. it is necessary to analyze the beam loss and bring forward a rational project for absorbing beam stream

    將離子源的高能粒子進行中性化,再偏轉掉中的帶電粒子,將超過腰半徑、密度較小的削除,在此過程中有一部分損失,它直接影響加熱功率的因素,因此,對損失進行了分析,對損失的吸收提了吸收方案。
  15. It is one of the thesis ' s contribution that introduces the coordination theory in the analysis to the ve workflow process, and builds the restriction rule for the process coordinating on the electronic contract. 3

    本論文將協調論的思想入到虛擬企業工作分析過程中,並提通過入電子合同來建立各企業業務過程協調的約機制。
  16. Particle simulation method is used to investigate the properties of the rco - tat, including the basic physical process of the beam - wave interactions and the dependence of the microwave radiation on the structure parameters, the beam parameters, and the guiding magnetic field intensity and distribution

    利用21 / 2維電磁模相對論pic粒子模擬程序研究了rco - tat工作的基本物理過程,並研究了器件的結構參數、參數、導磁場強度和分佈對波作用和微波輸的影響。
  17. According to the particle simulation, the amplitude of the beam current has a great influence on the microwave output, which is testified by our experiments. therefore, it is believed that higher beam current and input beam power will raise the output microwave power of the present device to a gw level

    在我們實驗的參數下,稍微變大,會起微波功率較大的增加,因此如果能夠提高的大小和適當提高電壓,在目前微波器件基礎上可以輸gw功率的微波。
  18. Combining the hardware and software, the real - time performance is also discussed. ( 5 ) when the system is debugged, some problems are discussed in detail and solved, such as volts d. c of the input signal caused by a / d converter and aliasing in frequency spectrum arising as re - sampling input data. experimental results show that the performance of the system is satisfactory

    ( 5 )討論了本dsp系統的軟、硬體調試方法,並詳細地討論了在系統總體調試時,現的各種問題? ?如a d器件起的輸入模擬信號的直偏置、波形成過程中由於數據抽取起的頻譜混疊,解釋和說明各種問題現的原因,並提了相應的解決方案。
分享友人