毛線毛線制的 的英文怎麼說

中文拼音 [máoxiànmáoxiànzhìde]
毛線毛線制的 英文
worsted
  • : hairdownfeatherfur
  • : 名詞1 (用絲、棉、金屬等製成的細長的東西) thread; string; wire 2 [數學] (一個點任意移動所構成的...
  • : Ⅰ動詞1 (製造) make; manufacture 2 (擬訂; 規定) draw up; establish 3 (用強力約束; 限定; 管束...
  • : 4次方是 The fourth power of 2 is direction
  • 毛線 : knitting wool; woolen yarn; hand knitting yarn毛線針 knitting needle
  1. In this paper, thermal evolution history of organic matter of the source rocks and hydrocarbon generation history have been researched by tti method, hydrocarbon migration direction and migration times were probed combining with the area structure development feature ; distribution pattern of the main reservoir intervals on lateral and longitudinal have been predicted by researching on development feature and control factors of the reservoir intervals, the actions of reservoir conditions in hydrocarbon accumulation and bearing also were probed combining with pore evolution feature ; the micro - pore feature of regional cap and direct seal in carboniferous - lower triassic in this area have been determined with micro - capillary pressure curve and intrusive mercury curve ; the prospecting districts have been pointed out combining with the hydro - geologic feature, the potential reservoirs were classified according to trap types in this area, the author attempt to evaluate on the hydrocarbon - bearing condition in the str ata of carboniferous ~ lower triassic from hydrocarbon generation and migration reservoir condition, reserved condition etc, and predict the reservoir types and hydrocarbon - bearing patterns combining with the structure evolution. based on above, the author point out that the central block of chenghu - tuditang synclinorium and the southern block of dangyang synclinorium are the advantageous regions for exploration

    本文用tti方法研究了烴源巖有機質熱演化史和油氣生成史,並結合區內構造發育特徵,探討油氣在區域上運移方向和在時間上運移期次;通過對儲集層段發育特徵和控因素研究,預測了本區主要儲集層段在橫向上和縱向上分佈規律,並結合孔隙演化特徵,探討儲集條件在油氣聚集成藏中作用;利用微細管壓力曲法和壓汞法,對石炭系?下三疊統區域蓋層和直接蓋層微孔隙特徵進行了定量評價,並結合水文地質分佈特徵,指出有利於油氣保存地區;根據區內存在各種圈閉類型,對可能存在油氣藏進行了分類,並試圖從油氣生成與運移、儲集條件、保存條件等方面,動態地綜合評價石炭系?下三疊統油氣成藏條件,並結合構造演化特徵,預測其油氣藏類型和成藏模式。
  2. Aiming at technical features and technology requirements for cold bending forming production line of steel bar for packing case, equipment including in such line has been introduced with emphasis on working principle and devices for burr trimming and opening piercing, on control principle of hydraulic expanding and flying shearing on the line

    摘要針對包裝箱鋼條冷彎成形生產技術特點及產品工藝要求,介紹了包裝箱鋼條冷彎生產設備組成;重點闡述了包裝箱鋼條預沖刺及豁口孔設備工作原理及裝置、包裝箱鋼條產品液壓擴孔及液壓飛剪技術原理。
  3. In the past, a player was allowed to move loose impediments from his line of putt only with his hand or club. this restriction will be removed in 2004, so that the use of a towel or a cap will no longer be a breach of rule

    過往球員準許在推球上用手或球桿移動散置障礙物,這個限在新一年球例中會被刪除,因此球員可用巾或帽子移動散置障礙物亦不會受到處罰。
  4. The controlling approach of ring - spinning ' s feather

    環錠紡紗成紗措施探討
  5. In the paper, by using bp ( back propagation ) method of ann, we can get the relationship between grading, asphalt - aggregate ratio, bulk density, percentage of voids, test temperature and ds. at the same time, we can get the relationship between grading, asphalt - aggregate ratio, bulk density, percentage of voids, test temperature and viscoelastic parameter. at last, we can estimate the ds and draw the deformation curve

    本文應用bp人工神經元網路,建立瀝青混合料礦料通過百分率、瀝青用量、體積密度、空隙率、試驗溫度與瀝青混合料粘彈性參數關系,或建立瀝青混合料礦料通過百分率、瀝青用量、體積密度、空隙率、試驗溫度與車轍試驗動穩定度值關系,從而預估車轍試驗動穩定度值和繪車轍試驗變形曲
  6. Its unique compound formula can regulate the skin ph value, inhibit excessive sebum secretion, and decompose excessive greases through oxidizing reaction with greases on the skin surface ; the shrinking factor contained can smoothen and shrink pores inward, improve roughness arising from pore blocking, make skin look tight and fine

    其獨特復合配方,能調節皮膚酸堿度,抑皮脂分泌過多油脂,並能與皮膚表面油脂發生氧化反應,使多餘油脂分解代謝,蘊含收斂因子更能暢通孔,令孔向內收縮,從而改善因孔阻塞而造成粗糙問題,使肌膚看起來緊實細致。
  7. The thesis also introduces the virtual instrument ’ s concept, system architecture, etc. the development of virtual instrument ’ s application software is discussed in detail. it includes virtual instrument software architecture ( visa ), and virtual instrument ’ s software platforms. the thesis discusses the principle and mechanism of work of the simulation of embedded system. by comparing with the principle of traditional logical analyzer, it draw a conclusion that the virtual logical analyzer will work in synchronous way when it is used for both logical state analyzer and logical time analyzer. the thesis

    論文接著探討了嵌入式模擬平臺原理和工作機,通過與傳統邏輯分析儀原理比較,得出了嵌入式模擬平臺下邏輯分析儀無論是做定時分析,還是做狀態分析都工作在同步方式下;並重點剖析了探頭原理,采樣定理和刺,數據建立和保持時間等邏輯分析儀重要技術指標,得出了虛擬環境對虛擬邏輯分析儀功能和各項技術指標影響,還提出了流水狀態表思想和實現機
  8. In this paper, through stress analysis of region about conical and spherical parts during drawing, a calculating formula of maximum tangential compressive stess in unsupported wall region is deduced. and this is condition of causing internal wrinkle. then on the premise to guarantee not breaking workpiece, a critical calculating formula is presented

    通過圓筒形及盒形件拉深前後網格變化分析,並確定變形區和非變形區,由此得到不規則盒形件坯展開形狀由不變形區和參與變形拉深組成,並用此方法計算出汽車動閥安裝板坯形狀和尺寸,在試模時一次即獲得成功,具有一定實用價值。
分享友人