析晶溫度范圍 的英文怎麼說

中文拼音 [xījīngwēndùfànwéi]
析晶溫度范圍 英文
temperature range of crystallization
  • 析 : Ⅰ動詞1. （分開; 散開） divide; separate 2. （分析） analyse; dissect; resolve Ⅱ名詞（姓氏） a surname
  • 晶 : Ⅰ形容詞（光亮） brilliant; glittering Ⅱ名詞1. （水晶） quartz; （rock） crystal 2. （晶體） any crystalline substance
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 范 : 名詞1 [書面語] （模子） pattern; mould; matrix 2 （模範; 榜樣） model; example 3 （范圍） boundar...
  • 圍 : Ⅰ動詞1 （四周攔擋起來 使裡外不通; 環繞） enclose; surround; corral 2 （繞; 裹） wrap Ⅱ名詞1 （四...
  • 溫度 : [物理學] temperature
  • 范圍 : scope; limits; extent; boundary; confines; range; range dimension; spectrum
  1. And apatite. by these analyses and comparison with general granite both in china and the world and with the granite in other au or cu belt in china, the characteristics of the granite in this area are concluded as follows. it belongs to magnetite - i or syntectic granite and has crust - mantle mixed characteristics ; it was formed mainly by crystallization differentiation of melting magma and multiphase varied intrusion ; the degree of differentiation evolvement is not high ; the granite and its enclaves p. re congenetic ; the range of temperature is about 500 - 700, the range of pressure is about 2. 50 gpa - 4. 35 gpa, and the range of oxygen fugacity ( lg fo2 ) is - 15. 53 - - 14. 00 ; most granite bodies formed before the collision of plates, and few formed after the collision of plates

    通過對測試數據的分析與綜合研究，並同中國和世界一般花崗巖類以及中國主要金、銅成礦巖體的花崗巖類進行對比，得出本區花崗巖類巖石具有以下特徵：屬磁鐵礦-型或同熔型花崗巖，其巖漿物質具殼幔混源特徵：主要由熔融態巖漿經結晶分異作用，通過多期變速上侵而形成；其分異演化程度較低；寄主巖基和包體具有同源性；巖石的形成溫度范圍約為500 - 700 ，壓力大約為2 . 50gpa - 4 . 35gpa ，氧逸度值1gfo _ 2為- 15 . 53 ? 14 . 00 ；該巖帶主要形成於板塊碰撞前消減的活動板塊邊緣期，為燕山至喜馬拉雅早期的大陸邊緣火山弧環境的產物。
  2. The results indicate that ( a ) before heat treatment, with the increasing of substrate temperatures, content of lower valency ( tij + ) decreases, the stoichiometric proportion of o / ti in all samples is about 2 ; the films have amorphous incompact columnar fiber structure, and with the increasing of substrate temperature, the size of columnar fiber increases ; the films have good hyalescence in visible range and great absorbability at the wavelength of 350nm ; optical constants of the films are calculated from the transmittance spectrums in visible range by mathematical analysis of the orders of interference, the results show that the refractive ind

    研究結果表明， （ a ）熱處理前，隨著基片溫度的增加，薄膜中的低價氧化鈦含量逐漸減少，化學計量比趨于o ti = 2 ；薄膜具有非晶態不緻密的柱狀纖維結構，柱狀纖維的尺寸隨基片溫度的升高而增加;薄膜在可見光范圍內透明，在波長為35onzn時嚴重吸收，利用干涉級次法分析了薄膜的光學常數，結果表明，薄膜的折射率隨基片溫度的升高而增加，根據計算結果得到了tioz薄膜在不同基片溫度下的折射率色散曲線。
  3. Prepared technical parameters were optimized by l9 ( 34 ) experiment analysis. a unique method for cleaning and drying of substrate - cleaning used by scour, drying used by infrared light was fished out by large numbers of experiment. chemical mechnism of zno thin film prepared by sol - gel technique was discussed by dta for the first time. by the measurements of sem, xrd and uvs, the thin film was analysed. the result proved that the thin film with strongly preferred orientation of c - axis perpendicular to the substrate surface which surface was homogenous, dense and crackfree was the crystalline phase of hexagonal wurtzite. the thin film was composed of plentiful asteroidal crystal which crystal dimension approximately 10 30nm. the average transmittance of thin film in visible region was above 90 %. the results of measurements else also proved that the thickness of single dip - coating was 75 240nm, this films resistivity was found to be 3. 105 102 3. 96 105 ? cm. the thickness and resistivity of thin film influenced by dope - content, withdrawal speed, pre - heat - treatment, anealing were reseached respectively

    利用xrd 、 sem以及uvs光譜儀等分析方法對薄膜進行了研究，結果顯示，所制備的薄膜為六方纖鋅礦型結構，具有高c軸擇優取向性；表面均勻、緻密，薄膜材料由許多星狀晶粒組成，晶粒尺寸大約為10 - 30nm左右；薄膜可見光透過率平均可達90 % ；對薄膜厚度以及電學性能進行了測定后發現：單次鍍膜厚度約為75 - 240nm ， al ~ （ 3 + ）離子摻雜型氧化鋅薄膜的電阻率在3 . 015 102 - 3 . 96 103 ? cm范圍內；分別研究了摻雜濃度、提拉速度、預燒溫度、退火溫度等工藝參數對薄膜厚度和電阻率的影響。
  4. In the process of making 95 alumina ceramics, selected five kinds of alumina powder and studied the influence of different alumina powder on the sintering properties and mechanic properties of 95 alumina ceramics, moreover, selected the most agreeable alumina powder according to the apparatus for granularity analysis and scanning electron microscope ( sem ). the influence of different sintering temperature on the sintering mechanic properties, the microstructure of 95 alumina ceramics were investigated by adding y2o3 and la2o3 as two kinds of rare earth additives in alumina ceramics. the results indicated that the additive of la2o3 could improve the properties of 95 alumina ceramics more effectively and could get fine grain and tabular alumina that can enhance the strength of the material

    選用了五種al2o3粉料，研究了其對95al2o3瓷燒結性能和力學性能的影響，並結合粒度分析儀sem對al2o3粉料進行優選；通過添加y2o3 、 la2o3兩種稀土添加劑，研究了不同燒成溫度對95al2o3瓷的燒結性能、力學性能及顯微結構等的影響，結果表明：添加la2o3可以有效提高95氧化鋁瓷燒結性能和力學性能，形成細晶和板狀氧化鋁瓷的顯微結構；通過對比不同氧化鋁粉料制備氧化鋁瓷燒成溫度曲線與燒結性能的關系，確定最佳的燒成溫度范圍為1570 ~ 1600 。
  5. It possess many of the physical properties such as high atomic number ( z ), large enough band gap, high resistivity, relatively low leakage currents, and high intrinsic mobility - lifetime ( ut ) product, which are required for room - temperature nuclear radiation detectors. so it is widely used in nuclear medical imaging system, space engineering, and astrophysics, environmental monitoring, and so on. in addition, it is the best substrate for lattice matched epitaxial growth of hg1 - xcdxte ( mct ) thin films and solar cells

    用單晶czt製成的探測器可在室溫下工作，工作溫度范圍寬（ - 20 40 ） ，能量探測范圍寬（ 10kev 6mev ） ，對x射線、射線能量解析度高，在x射線、射線成像、天體物理研究、工業探測、安全檢測、核輻射探測、核廢料監控、 x射線熒光分析（ xrf ） 、 x射線斷層掃描和核醫學等方面有重要用途。
分享友人
分享到 Line

分享到臉書