栓緊圖 的英文怎麼說

中文拼音 [shuānjǐntú]
栓緊圖 英文
tie-down diagram
  • 栓 : 名詞1. （可開關的機件） bolt; plug 2. （塞子） stopper; cork
  • 緊 : Ⅰ形容詞1 （物體受到幾方面的拉力或壓力以後呈現的緊張狀態） taut; tight 2 （物體受外力作用變得固定...
  • 圖 : Ⅰ名詞1 （繪畫表現出的形象; 圖畫） picture; chart; drawing; map 2 （計劃） plan; scheme; attempt 3...
  1. Clean and degrease the surfaces of the shaft to be fitted to. comply with the indicated tightening torque of screws ( mt )

    安裝前必須把軸徹底清潔和除油，收緊鑼栓（ mt ）時要參考上圖所示的數據
  2. The two locking bolts should be tightened first in order to position the flanges correctly as shown in fig. 1

    為了如圖1所示正確定位法蘭，應該首先緊固兩個鎖定螺栓。
  3. According to the analysis of the table lookup, the graph method and the simulating formula method of selecting bolt diameter without controlling pretightening force under dead load were presented in this paper

    摘要通過對查表法資料進行分析，提出了靜載時選擇不控制預緊力的緊螺栓聯接螺栓直徑的圖線法和模擬公式法。
  4. Installation of flange connecting valve is on diagram. lock down the connecting bolt after add sealing washer

    安裝如示意圖，加密封墊后均勻鎖緊聯接螺栓。
  5. Pay attention to the flow direction of medium showed on the body. installatio of flange connecting valve is on diagram. lock down the connecting bolt after add sealing washer

    安裝時請注意閥體上標注（箭頭）的介質流向，安裝如示意圖，加密封墊后均勻鎖緊聯接螺栓。
  6. Pay attention to the flow direction of medium showed on the body. installation of flange connecting valve is on diagram. lock down the connecting bolt after add sealing washer

    安裝時請注意閥體上標注（箭頭）的介質流向，安裝如示意圖，加密封墊后均勻鎖緊聯接螺栓。
  7. Fasteners - bolts, screws, studs and nuts - symbols and designations of dimensions

    緊固件.螺栓螺柱和螺母.圖形符號和尺寸
分享友人
分享到 Line

分享到臉書