梯溫加熱 的英文怎麼說

中文拼音 [tīwēnjiārè]
梯溫加熱 英文
taper heating
  • 梯 : Ⅰ名詞1 （梯子; 樓梯） ladder; stairs; steps; staircase 2 （姓氏） a surname Ⅱ形容詞（形狀像樓梯的...
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  1. The simulation results suggest that, at the end of the scanning line, the dissymmetric temperature field and the great temperature gradient result in the balling phenomenon and great thermal stress, which could lead to the destruction of the sintering samples in this region. because of the coupling effect between scanning lines, the balling phenomenon is increased as the increase of the scanning lines, thus the over short scanning lines should be avoided in the sintering process. different scanning strategies have significant influence on the sintering

    模擬結果表明，掃描端點溫度場的不對稱及較大的溫度梯度造成了端點球化現象，並在端點處產生較大的熱應力，使燒結成形試樣易在此處破壞;激光掃描線間的耦合作用使端點球化現象隨掃描線的增加而逐漸顯著，燒結時應避免過短的掃描線;不同掃描策略對燒結成形有很大影響，交替掃描會影響燒結試樣的質量，實際製造時應採用單向掃描策略。
  2. Increscent weight of oxidation, graphic and micrographic were explored, meanwhile, the mechanism of anti - erosion and wear - resistant of new coating material are also studied. at last, a program applied to calculate the temperature distribution and heat transmission between water wall tubes with sprayed coatings and metal anti - erosion tile was developed by use of visual basic

    文中最後採用vb6語言計算機編程，計算了不同材料塗層對鍋爐水冷壁管的傳熱效果及徑向溫度梯度的影響，同時與加裝了防護瓦和未加任何防護的水冷壁管進行了比較。
  3. The diagnostic analysis for the sandstorm process on the base of height, temperature, pressure and wind etc output from the model shows that the upper cold trough, low - level wind shear, surface cold anticyclonic ridge, mesoscale cyclone and cold front are the main synoptic systems, surface cold anticyclonic ridge and cold front provide condition of wind force to occurrence of the sandstorm weather, the strong mesoscale cyclone before front makes pressure gradient before and after cold front obviously strengthen, moreover, and it increases obviously the temperature of the controlled area, as a result, the updraft movement caused by convergence before front strengthens

    500hpa強鋒區、 700hpa切變和鋒前中尺度系統的強弱及位置變化是沙塵暴天氣發生發展到減弱的直接原因。地面冷高壓、地面氣旋及冷鋒是造成本次沙塵暴天氣的主要地面天氣系統。地面冷高壓及冷鋒為沙塵暴天氣的發生提供了風力條件，而中尺度氣旋使冷鋒前後氣壓梯度明顯增強外，又使所控制的區域增溫明顯，使鋒前輻合上升運動加強，為沙塵暴天氣的發生提供了熱、動力條件。
  4. There are many advantages to heat by air condition system, but there are also many problems. the air distribution of air condition room is often designed according to the summer outdoor parameters. thus, in winter, the hot air will arise with the influence of buoyancy, which result in the decline of vertical temperature gradient and produce a successive of problems

    空調送風供暖有著很多的優點，但也出現了很多問題，由於空調房間的氣流組織一般是以夏季工況為設計工況，在冬季由於送風熱氣流在浮升力作用下上升，引起垂直溫度梯度的增加，並產生一系列的問題，致使空調房間冬季室內熱舒適性較差、能源利用效率較低。
  5. The saffman force does not affect the axial velocity of the flow, while it change the concentration of the particle. the gas - particle two - phase flows in the present of temperature were also numerical simulation

    討論了絕熱、有溫差和添加熱泳力三種情況下的兩相流場，分析了溫度梯度、湍動能、軸向速度和顆粒濃度的變化。
  6. Through analyse, the thermal prompting source of infrared bulbs was improved on. the time controller can control the loading time, which was one components of the device of infrared bulbs. the improved thermal prompting source can fit the change fo size of object

    通過分析，對紅外燈的熱激勵源進行了改進，使其由時間控制器控制加載時間，使其能滿足試件大小要求，形成空間梯度小，時間梯度大的均勻溫度場分佈。
  7. If the soil water content is gradually added from very little value, the value of water content gradient resulted from temperature gradient first is lower, then bigger and finally lower. based on the test data, a linear regression equation about temperature and water content is got. after deciding the temperature and moisture distribution of the soil samples, the problem of coupled thermal and moisture is discussed, the temperature distributions show that the heat - conducting coefficient is related to the density and water content

    由溫度場的分佈可以得到：在溫度梯度的作用下，導熱系數是變化的，而導熱系數沿長度方向的變化，使得穩態溫度場沿長度方向成非線性分佈；密實度對溫度場分佈的影響是干密度越大導熱系數越大；初始含水量對溫度場分佈的影響是含水量增大，導熱系數也增大，達到最大值后，含水量增加導熱系數反而減少，含水量對溫度場的分佈有顯著的影響。
  8. In this dissertation, mgo5 is introduced to form solid solution to restrain the decomposition of at in high temperature. then at is mixed with the al2o3, forming gradient composite to raise the integral intensity of the material and not affecting the thermal properties. the experimental results show that the additive mgo5 can effectively restrain the decomposition of at and promote the sinter process, which enhances the density of at

    本文在充分分析本領域國內外研究現狀的基礎上，首先通過引入添加劑鈦酸鎂（ m2t ） ，使其與鈦酸鋁形成固溶體，以達到抑制鈦酸鋁中溫分解的目的；再通過與強度高、氣密性好的氧化鋁進行梯度復合來提高整體材料的強度並能彌補鈦酸鋁滲透性能差，同時對材料的低熱膨脹性能影響不大。
  9. The finite element method ( fe '. i ) is adopted to analyze the effects of the numbers of coil turns, current intensity and current frequency upon the rate of joule heat generation in details. the thermo - radiation analytical countermeasures of various types are adopted to carry out the numerical analysis of the effects of the crucible with different shapes and sizes and the blind holes with different depths opened in the tops of crucibles as well as coil positions upon the thermal field distribution whereby solving the main problem of field the thermo - field design of the induction - heating sic crystal growth system. a new combination idea of the thermo - field design obtained by means of the united design of the thermo - insulator and blind holes has been presented

    採用有限元分析方法對線圈匝數、電流強度、電流頻率等對焦耳熱產生速率的影響進行了詳細的分析討論；採用不同的熱輻射分析策略，對不同坩堝形狀、坩堝頂部開設不同深度的盲孔以及線圈的位置等對熱場分佈的影響進行了數值分析，解決了感應加熱碳化硅晶體生長系統熱場設計的主要問題，提出了通過絕熱層與盲孔的聯合設計獲得所需熱場設計的思路，給出了根據軸向溫度梯度的波動對線圈位置實行動態調節以控制熱場的理論依據。
  10. The formula for computing the recommended element spacing to obtain an even temperature gradient on the product being heated is shown in figure 4

    通過間距計算公式得知加熱產物溫度梯度，具體詳見圖4 。
  11. The formula for computing the recommended spacing to obtain an even temperature gradient on the product being heated is shown in figure 3

    為了得到加熱產品的更合適的溫度梯度，具體的計算間距的公式見圖3 。
  12. For the purpose of high temperature gradient, liquid metal cooling with circulatory water cooling is used directly to cool the sample, and at the same time, radiation baffle with appropriate size and shape is needed

    該裝置採用了雙區加熱和液態合金直接冷卻技術，再配以合適的輻射擋板，可以提高液固界面處的溫度梯度。
  13. In order to study the regeneration mechanism of dpf in detail, we still need a mathematical model of the channel unit, which present temperature field and the soot reaction rate of the channel. finally, it points out the influences of various factors to the regeneration process by computing the numerical solution of model under different boundary conditions and geometry parameters, such as the initial temperature, the gas flow rate, the oxygen concentration, the sediment quantity and the wall thickness of the filters, and so on. in this way, the paper provides theoretical guidance for optimization design of the dpf

    首先研究了干凈壁流式過濾體的加熱特性，然後在加熱和燃燒理論的基礎上建立了微粒捕集器再生過程的數學模型，並對模型進行了數值計算，得到了捕集器內部的三維溫度場分佈以及溫度梯度分佈，結果與實驗值吻合較好，驗證了模型的正確性;為了詳細的研究微粒捕集器的再生機理，建立了孔道單元數學模型，得到了孔道內的溫度場分佈和微粒反應速率分佈;最後，通過求解模型在不同邊界條件和不同幾何參數下的數值解，分析了各種因素對再生過程的影響，如過濾體初始溫度、過濾體內氣流的流動速率、氧濃度、微粒沉積量以及過濾體壁面厚度，為微粒捕集器的優化設計提供理論指導。
分享友人
分享到 Line

分享到臉書