棱鏡誤差 的英文怎麼說

中文拼音 [léngjìngwùchā]
棱鏡誤差 英文
prismatic error
  • 棱 : 棱名1. （物體上不同方向的兩個平面接連的部分） arris; edge; corner 2. （物體上一條一條的凸起部分） corrugation;ridge;raised angle
  • 鏡 : Ⅰ名詞1 （鏡子） looking glass; mirror 2 （幫助視力或做光學實驗的器具） lens; glass 3 （姓氏） a s...
  • 誤 : Ⅰ名詞（錯誤） mistake; error Ⅱ動詞1 （弄錯） mistake; misunderstand 2 （耽誤） miss 3 （使受損害...
  • 差 : 差Ⅰ名詞1 （不相同; 不相合） difference; dissimilarity 2 （差錯） mistake 3 [數學] （差數） differ...
  • 誤差 : error
  1. This paper analyses the critical angle method that often use in focus detected. we receive two relations, the first relation between refractive index of the critical - angle prism and focus - error signal ; the second relation between numerical aperture of object lens and out - of - focus error signal

    本文針對伺服系統中常用的調焦方法-臨界角方法進行了分析，理論上得到臨界角棱鏡的折射率、物鏡的數值孔徑與離焦誤差信號的關系。
  2. This paper analyses emphatically the position error and manufacture error of critical - angle prism the position error and aberration of object lens the position error and manufacture error of the polarization beam splitter the position error of the detector, and come out their relations

    著重分析了臨界角棱鏡位置誤差與製造誤差；物鏡的位置誤差與像差；偏振分束棱鏡的位置誤差與製造誤差；探測器的位置誤差等對離焦誤差信號的影響，並給出了理論曲線。
  3. In this dissertation, we studied the tcra1101plus total station position system, which introduced the principle and characters of the instrument ' s closed loop tracking system. also we explained the cause of prism ' s position error and brought forward mathematic model to correct, moreover, the good results has been drawn form the expenriments. the kinetic survey system have been realized, which the sampling rate attain more than 5hz and the position precision can be less than 2mm on condition that targeted - point moving slowly at the velocity below 2cm / s. having finished the survey system to examine whether the fine - tuning stewart platform in good status, we have finished mensurating the position reference of the fine - tuning stewart platform and the offset of the prism

    在此基礎上研製了多臺儀器在線控制高頻采樣動態跟蹤測量系統，采樣率大於5hz ，在跟蹤小於2cm / s低速運動目標時，測量精度好於2mm ；完成對饋源二次精調系統的檢測，包括對二次精調平臺位置基準的標定和觀測棱鏡偏心差的測定；設計不同動態測量實驗，對全站儀動態跟蹤的誤差來源和特點進行了分析；從實驗角度，對全站儀的測量時滯及其穩定性進行了測試分析，給出了定量的結果；比較了全站儀和計算機的內部時間系統，發現兩者存在較大差異。
  4. The analyse of theary about effect on angular error for reflective characterisitic of move angular cone prism

    角度誤差影響運動角錐棱鏡反射特性的理論分析
  5. We simulate the practicality system to experimentalize, obtain the relation between defocus and focus error signal, make it a condition that na = 0. 625 and n = 1. 7979

    並模擬實際系統，實驗得出當臨界角棱鏡的折射率n = 1 . 7979 、物鏡的數值孔徑na = 0 . 625時，離焦量與離焦誤差信號的關系曲線。
  6. Only the main transmitted light from the glued layer or the first - order transmitted light also, is considered at most in the existing study outcome about light intensity transmission. on occasion, some experimental results about light transmission are given as a performance index. and nearly no one considers the contribution of the higher - order transmitted lights and the effects of the inaccuracy in glue technology on light distribution

    人們對它的研究，往往只考慮棱鏡膠合層的兩切割斜面上的主透射光束，至多同時考慮次級透射光束對出射光強的影響，或直接將光束光強透射比的實驗值的平均結果作為棱鏡的一個性能指標給出，很少考慮棱鏡膠合層間光束的多次反射對輸出光強的影響以及結構誤差和使用調整誤差對棱鏡光強分佈的影響。
  7. Influence of beam turning error of pentagonal prism on wavefront measurement

    五角棱鏡的光束轉向誤差對波前測量的影響
  8. Abstract : a principle of linear ccd prism spectrometer system used to measure colors is presented. the spectrum sensitivity of the system is measured and its test and verify is finished in experiment. the reasons for error of the system is analyzed and improved method is obtained

    文摘:介紹了用於顏色測量的線陣ccd棱鏡光譜儀系統的工作原理，測出了系統的光譜靈敏度並作了實驗驗證，對系統的誤差原因及改進措施進行了分析。
  9. Abstract : on the basis of analyzing the scan error of a pentaprism, the principle of scan error compensation is put forward, and the quantized formulas and applying method of compensating the scan error are presented

    文摘:在分析五棱鏡掃描誤差的基礎上提出了誤差補償原理，並給出了量化補償公式及誤差補償原理的實現方法。
分享友人
分享到 Line

分享到臉書