極限抗拉力 的英文怎麼說

中文拼音 [jíxiànkànglālì]
極限抗拉力 英文
ultimate tension
  • 極 : i 名詞1 （頂點; 盡頭） the utmost point; extreme 2 （地球的南北兩端; 磁體的兩端; 電源或電器上電流...
  • 限 : Ⅰ名詞（指定的范圍; 限度） limit; bounds Ⅱ動詞（指定范圍, 不許超過） set a limit; limit; restrict
  • 抗 : Ⅰ動詞1 （抵抗; 抵擋） resist; combat; fight 2 （拒絕; 抗拒） refuse; defy 3 （對等） contend with...
  • 拉 : 拉構詞成分。
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 極限 : 1 （最高的限度） the limit; the maximum; the ultimate limit; limitation; extremity; tipping point...
  • 拉力 : pulling; pulling force; thrust; traction; tension拉力表 draw bar [pull] dynamometer; 拉力測定儀 [...
  1. On the other hand, for the pre - press stress being threw by the hub was inserted after cooling with liquid nitrogen, the poor transverse tension strength of the multi - ring flywheel rotor could be counteracted. so the rotate speed and energy storage density can be increased efficiently

    而採用多環套裝纏繞技術製造的多層飛輪輪環，在利用溫差過盈裝配方法給復合材料輪環施加預壓應力后，能夠有效避免飛輪轉子的復合材料輪環部分因較低的纖維橫向抗拉強度而破壞失效，從而大幅度提高飛輪轉子的極限轉速和儲能密度。
  2. At first, the experiment carried out by tianjin university has been analysed according to the " nonlinear balance trying calculation " method, and the values of yield load and ultimate load agree with the test result better, and the curve of bending moment - curvature, bending moment - deflection can agree with the results. the second, the simplified formula for evaluation the ultimate flexural capacity of cfrp strengthened rc members is presented according to the three probable failure modes ( compression failure ; cfrp rupture ; crushing of the concrete in compression before yielding of the reinforcing steel ). it is applicable to both singly and doubly reinforced rectangular sections, as well as flanged sections

    首先利用鋼筋混凝土非線性平衡試演算法對天津大學試驗進行了理論分析，所得分析值與試驗結果相比，加固梁的屈服荷載、極限荷載能夠很好地吻合，彎矩曲率關系曲線及彎矩撓度關系曲線較為吻合；其次，為了滿足實際工程的需要，根據碳纖維布加固構件可能發生的三種破壞形態（壓區混凝土壓碎破壞、碳纖維布拉斷破壞以及受拉鋼筋尚未屈服時壓區混凝土已壓碎破壞） ，區別三種鋼筋混凝土構件截面形式（單筋矩形截面、雙筋矩形截面、 t形截面） ，分別給出了碳纖維布加固混凝土構件抗彎承載力的簡化計算公式和適用條件，並進一步探討了這三種截面形式下進行加固設計和復核的步驟。
  3. According to calculating and analysis, educes the distributing laws and their correlations of horizontal displacement and stress of stabilizing pile, anchor pull and earth press in two sides of pile, including the distributing of point repel force and internal force of pile at the terminal state, providing full theoretical basis for anchor cable and stabilizing pile structure design, strength check, stability check and determination of anti - slide force for a single stabilizing pile

    通過計算分析，得出了抗滑樁的水平位移、樁身應力、錨索拉力和樁側土壓力的分佈規律和它們之間的相互關系以及極限狀態時的樁的結點抗力和樁的內力分佈規律，為錨索樁的結構設計、強度校核、穩定性校核和單樁抗滑力的確定提供了充分的理論依據，同時也提出了錨索抗滑樁計算分析的一種新方法。
  4. On one hand, the stress in mass concrete is caused because of the difference between internal temperature and external one. on the other hand, with the concrete solidifying, the tensile stress will appear due to concrete ' s shrinkage restrained by base rock

    大體積混凝土一方面由於內外溫差而產生應力，另一方面，由於混凝土的凝固，收縮變形受到約束，混凝土會產生拉應力，一旦溫差引起的應力和收縮變形引起的應力超過同齡期混凝土的極限抗拉強度，混凝土就會產生裂縫。
  5. The sx thermal stress of concrete compared with splitting tensile strength couldn ’ t reach the limiting tensile strength, so didn ’ t create damage

    與混凝土的劈裂抗拉強度相比較，混凝土的sx溫度應力沒達到極限抗拉強度，使混凝土產生損傷。
  6. Testing of wood ; determination of ultimate tensile stress parallel to grain

    木材試驗.與木料紋理平行的極限抗拉應力的測定
  7. Ultimate tensile stress

    極限抗拉應力
  8. We analyes post - tensioned prestressing properties and comparing with practiced results. we analyse one - way precast slab sandwich negative moment section resistant crack properties and two - way precast slabs sandwich under plane resistant crack at unprestressed section and second - prestressing propties. we compare canceling bonded reinforcement with laying on bonded reinforcement resistant crack properties and deformation. auxiliary lab include : concrete resistant pollution intensity. concrete resistant compressing intensity and elastic modulus, compare with results of code. analyse sandwich ' s strain and long - time stress, strain and introduce a new method through theory calculating long - time stress and strain

    配套的試驗研究有：混凝土的抗拉強度和彈性模量試驗及混凝土的抗壓強度和彈性模量試驗，混凝土的極限抗拉強度和極限拉伸應變試驗，並與《混凝土結構規范》 （ gb50010 - 2002 ） ，結果進行了對比；單塊夾層板放張階段的彈性應力、應變分析和長期應力、應變分析，並詳細介紹了按混凝土徐變理論進行長期應力、應變分析的方法。
分享友人
分享到 Line

分享到臉書