橋路電阻 的英文怎麼說

中文拼音 [qiáolùdiànzǔ]
橋路電阻 英文
bridge resistance
  • 橋 : 名詞1. （橋梁） bridge 2. （姓氏） a surname
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 電阻 : （物質阻礙電流通過的性質） resistance; electric resistance （電路中兩點間在一定壓力下決定電流強度...
  1. Sales : imported and domestic natural rubber, butylbenzene rubber, polybutadience rubber, butyronitrile rubber, epdm rubber, butyl rubber, chlorosulfonated polyethylene tyre types superfine, smell - free, butyl, butyronitrile, color and milk natural rubbers, compound rubbers and reclaimed rubbers ; raw and auxiliary materials for rubber chemical such as rubber accelerator, antiager, black, paraffin, octadecoic acid, zinc oxide, magnesium oxide, titanium pigment, coumarone and powder sulfur ; different specifications of epdm color granules, crossover antiskid rubber floor brick, plastic rubber sites, lawn layout, different specifications of antiskid rubber floor brick, rubber blind - people road brick, plant brick, tree guard brick, top adiabatic brick, road rubber reducer brick, special green rubber tyre rubber granule, rubber powder and product, different rubber and plastic pipe, adhesive tape and plate, flexible rubber soft joint, rubber stop tape, bridge extension device, natural rubber plate pedestal, water - expanding rubber, rubber and plastic air duct, pe / pp / pvc water pipe, fulgurite, flame retardant wire gutter, floor wire gutter, mc nylon product, rubber and plastic machinery and fitting relieve, and processing of different ordinary and special rubber and plastic and nylon products

    經營銷售：進口、國產天然膠、丁苯膠、順丁膠、丁腈膠、三元乙丙膠、丁基膠、氯璜化聚乙烯、輪胎類精細、無味、丁基、丁腈、彩色、乳膠類等多種型號天然橡膠、合成橡膠和再生橡膠；硫化促進劑、防老劑、炭黑、石蠟、硬脂酸、氧化鋅、氧化鎂、鈦白粉、古馬龍、工業硫磺粉等各種橡膠化工原輔材料；各種規格epdm彩色顆粒，天橋防滑橡膠地磚、塑膠場地、人造草坪鋪裝、各種規格防滑橡膠安全地磚、橡膠盲道磚、植草磚、樹木圍護磚、屋頂隔熱板、道路橡膠減速塊，專用綠色環保型橡膠輪胎膠粒、膠粉及成品，各類橡膠、塑料膠管、膠帶、膠板，可撓曲橡膠軟接頭，橡膠止水帶，橋梁伸縮裝置，天然膠板式橡膠支座，遇水膨脹橡膠，橡膠、塑料導風筒， pe pp pvc水管、電管、阻燃線槽，地板線槽、 mc尼龍產品、橡塑機械及配件調劑，並承接各種普通、特種橡塑、尼龍產品加工製造。
  2. Among various fabrication techniques of thin film, the sol - gel process has gained much interest for the preparation of pzt thin film, due to ihe advantages of good homogeneity, easy control of composition, low in - ill i reaving temperature, easy formation of large area thin films pb ( zrxti : - k ) 0 :, ( pzt ) films were prepared on the ito coated glass plates and low resistor silicon wafer in sol - gel dip - coating process associated wi di heat treatment : at different temperatures and characterized by x - ray diffraction ( xrd ) and transmission electron microscopy ( tem ). lt is shown that the pzt ferroelectric thin films with ( 110 ) preferred orientation and well - crystallized perovskite structure can be obtained after annealing at 680 ? for 30 minutes on ito substrate and at 800 " c for lornin on silicon substrate

    Pzt的制備方法有很多，其中溶膠?凝膠（ sol - gel ）方法可以和集成電路（ ic ）光刻工藝相互兼容，處理溫度低，有大面積塗敷性能，能精確地控制組分，無需復雜的真空設備，成本低廉，所以對于集成鐵電薄膜電容的應用這種方法有很廣闊的前景。本文利用sol - gel技術在摻錫的in _ 2o _ 3透明導電薄膜（ ito ）襯底和低阻硅襯底上成功地制備了pzt鐵電薄膜。運用了x射線衍射， sawyer - tower電路和lcr電橋分別對薄膜的晶化溫度，結構和電學性能進行了測試。
  3. Recording units for resistance thermometers are mostly based upon the wheatstone bridge circuit.

    電阻溫度計的記錄設備基本上是根據惠斯通電橋的電路。
  4. 1 m 0. 5, the phase - shifted angle 6 is controlled in term of sine law which makes the magnitude of resonant voltage track a reference sine voltage, and the resonant voltage is rectified, filtered, inverted and then the better sine - voltage output is obtained, theoretical analysis and experimental results show that for the resistive load and inductive load, the switches of leading leg of the phase - shift - controlled circuit are always turned on at zvs, and ones of lagging leg are turned on at zvs ( < 0 ) or turned off at zcs ( ( > 0 ), moreover, all switches in the low - frequency inverter are always turned on and off at zvs, the measured circuit efficiency for rated load reaches up to 88 %

    從功率單向流動角度出發，提出了一種lcc諧振型恆頻移相單相高頻鏈逆變電路拓撲，在調制系數0 . 1 m 0 . 5情況下，控制移相角按正弦規律變化，使諧振電壓脈沖列的幅值追蹤參考正弦電壓信號，經過整流、濾波、低頻逆變，從而獲得正弦度較好的輸出電壓。理論分析和實驗結果證明對于阻性負載或阻感性負載，移相全橋具有超前橋臂零電壓開通，滯后橋臂或者零電壓開通（ _ 0 ）或者零電流關斷（ _ 0 ）的軟開關特性，而低頻逆變器的各個開關均實現零電壓條件下的開通與關斷。
  5. Self - balance display instruments for temperature measurement. guidance for the calculation of bridge resistance, scale and chart

    自動平衡式測溫顯示儀表.橋路電阻標度尺和記錄紙的計算導則
  6. In order to describe the actual working processes of dielectric barrier discharge ( dbd ) circuit, an analysis model of differential - difference equations was presented, based on the working modes of full bridge serial load resonant dbd circuit, which was adopted with phase shifting control

    摘要為描述介質阻擋放電型臭氧發生器電路的實際工作過程，在分析一種移相全橋脈寬調制下串聯負載諧振電源供電的臭氧發生器電路的基礎上，提出了採用微分差分方程來描述電路的工作過程，並給出了電路可能的工作軌跡。
  7. A resolution method in software is applied to calibrate zero point and full scale of the circuit. software approach to nonlinear correction for sensor and circuit is presented. therefore system error is eliminated, and measurement accuracy of temperature is improved. the signal of acidity electrode is detected by a differential amplifier circuit, which consists of operational amplifiers tlc2254 with high input impedance and low drift

    採用橋路和單運放差動放大電路對溫度傳感器信號檢測放大，軟體校正溫度傳感器和測量電路的非線性，軟體校準測量電路的零點和滿度，消除測量電路的系統誤差，提高補償溫度的測量精度；採用高阻、低漂移運放tlc2254組成高阻差動放大電路用於酸度電極信號測量。
  8. By compared with the simulation results and the experiment results, we come to the conclusions that : ( 1 ) circuit with assistant network can widen soft - switching extent in lagging arm, reduces duty - cycle loss on the secondary, diminishes switching dissipation of inverter spot - welding power source. ( 2 ) the range of resonant capacitor, the important factor to soft - switching process, not only affects zero - voltage turn - off of power switches, but also affects the range of zero - voltage turn - on of power switches. so resonant capacitors must be considered according to many aspects ; ( 3 ) it easily fulfils soft - switching condition in lagging arm as leakage inductance of power transformer increases, but bigger leakage inductance of power transformer increases opening dissipation of transformer and decreases efficiency of soft - switching inverter power source

    通過模擬結果與軟開關點焊逆變器試驗結果的對比分析，得到了如下主要結論：採用輔助網路可以完全拓寬全橋軟開關逆變器的滯后橋臂軟開關范圍，減小了次級占空比丟失，降低了逆變電阻點焊電源的開關損耗；諧振電容是影響軟開關工作狀態的重要因素，其大小不僅影響開關管的零電壓關斷，同時也影響開關管的零電壓開通范圍，因此，諧振電容應該綜合考慮；功率變壓器漏感越大，越容易滿足滯后橋臂的軟開關條件，但是大的漏感也使變壓器的通態損耗增加，降低了軟開關逆變器的效率。
  9. It is convenient to adjust the circuit and easy to acquire sensitive signal by using this method, and there is not the impedance mismatching problem met in bridge - based self - sensing circuit

    該方法使得自感知電路的調節和感知信號的獲取變得容易，克服了電橋法自感知電路阻抗不易匹配的不足。
  10. The other is supported by emerson network power co., ltd as an advanced research project. and this paper mainly introduces how to design and realize a four - quadrant running srd system to control a 3kw srm ( 8 / 6 poles ) based on a dsp ( tms320f240 ), which uses h - bridge power convertor and power - consumption braking method

    本文基於省重點科研項目「開關磁阻電機新型控制及其調速系統」和深圳emerosn網路能源公司預研部項目，分析討論了如何設計實現一套以3kw的四相（ 8 6極） srm為控制對象以dsp為控制核心採用h橋式功率變換器和能耗制動方式的四象限運行srd系統。
  11. 2, design a structure makes the liner output higher to 160mv with a liner input about 150 in bridge of spin - valve gmr. in comparison of some typical mr angular sensors it ' s output make a great progress

    2 ，設計了一種結構使自旋閥gmr晶元組成的橋路輸出電壓信號線性區達到約150 ，輸出幅度達到了160mv ；相比一些典型的磁阻非接觸式角度傳感器，量程獲得了可觀的擴展。
  12. A new bridge type high temperature superconducting fault current limiter ( sfcl ) with a limiting impedance of superconductor serried in the limiting circuit is proposed, which could limit the peak value and the stable value of the fault current

    摘要提出一種改進的橋式高溫超導限流器拓撲結構，將不同高溫超導體製成的限流電阻與限流電感同時申入橋式限流迴路。
  13. Directives of designing and calculating the bridge resistances and scales of moving coil temperature indicators

    動圈式溫度指示儀.橋路電阻標度設計計算導則
  14. Usually the bridge circuit has a relatively high input impedance so that it has an insignificant effect on the signals in the transmission line

    通常橋接電路具有較高的輸入阻抗，因此傳送線上的信號將不受影響。
  15. In this paper, a kind of improved practical active linear bridge circuit with platinum resistor is used to eliminate the error mentioned above, and the precise temperature measurement can be made

    本文採用鉑電阻改進型實用有源線性化橋路克服了上述誤差，實現了高精度的溫度測量。
  16. The 3 - db bridge of low loss, which is the vital part in improving power combining efficiency, is different from wilkinson bridge. it features usage in high performance power division and combining networks with the usual dielectric materials, as well as low loss, no need for resistant material, and simple fabrication technology

    本課題設計的低損耗3 - db電橋不同於一般常用的wilkinson電橋，其特點除了損耗低外，無需阻性材料，且製作工藝簡單，可以在常用的軟基片上做出高性能的功率分配、合成網路。
分享友人
分享到 Line

分享到臉書