機器辨識 的英文怎麼說

中文拼音 [jīqìbānzhì]
機器辨識 英文
machine identify
  • 機 : machineengine
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 辨 : Ⅰ動詞（辨別; 分辨; 明察） distinguish; discriminate; differentiate; recognize Ⅱ名詞（姓氏） a surname
  • 識 : 識Ⅰ動詞[書面語] （記） remember; commit to memory Ⅱ名詞1. [書面語] （記號） mark; sign 2. （姓氏） a surname
  • 機器 : 1. （用來轉換或利用機械能的機構） machine; machinery; engine 2. （引申為機構） apparatus; organ
  • 辨識 : identification辨識符號 identification mark; 辨識技術 identification technique; 辨識器 identifier;...
  1. Development of graduated students archives delivery system

    六軸並聯機器人系統辨識
  2. And then, the error matrixes of location and kinemics of the end point, and the on - line error compensation method are given based on robot ' s dynamics. finally based on puma robot, three simulation examples are given respectively ; the first is about the location error and on - line location error compensation, the second is about the kinetic error and on - line kinetic error compensation, the third is about location and kinetic errors causing by robot ' s dynamics and the on - line error compensations. the simulation results show that : a ) location error of the end point based on elastic deformation of the sensor will be about millimeter ' s degree under the permitting load, b ) the on - line error compensation methods given are available

    第三章首先概括了目前機器人連桿慣性參數識別的四種方法，總結這些方法的優、缺點；指出這些方法存在的問題是：或者需將機器人解體，不能在線進行參數識別，或者不能給出機器人連桿獨立的慣性參數值，只能獲得慣性參數的組合值，而這些方法的共同問題是：不能考慮機器人連桿的關節特性；本章提出了一種基於腕力傳感器的機器人末端連桿慣性參數在線識別方法，給出了該方法的理論計算和推導；研究提出了以腕力傳感器輸出為前提的、基於newton - euler動力學的機器人動力學正向、逆向遞推公式；針對機器人負載參數辨識必須在線、實時的特點提出了基於腕力傳感器的負載參數在線識別方法，給出了負載參數識別的步驟。
  3. In this control structure, an svm is used as identifier, the control signal is solved by an exponentiated gradient algorithm

    該控制結構以支持向量機為辨識器，並用指數梯度演算法來求控製作用。
  4. Variable boundary layer solution is applied to eliminate chattering on the sliding surface and pi speed identifier of mras is used to replace traditional speed sensor to monitor the speed

    應用可變邊界層法削弱滑模面上的抖振，用模型參考自適應速度辨識器取代傳統速度傳感器監測電機速度。
  5. The same ocr techniques that are used for scanning a document could find all the text in the images and feed it to a machine - learning filter

    目前掃描文件用的光學文字辨識技術，可找出影像里的所有文字，再把文字輸入機器學習過濾器。
  6. In the paper, a speed estimator based on artificial neural network is designed according to the principle of direct torque control, the speed estimator is optimized by genetic algorithm, and the parameters of pid speed adjuster is also optimized by genetic algorithm. a stator linkage and torque observer based on stator resistance estimator using fuzzy neural network is also designed. eventually, the intelligent control of direct torque control system is implemented

    本文根據異步電動機直接轉矩控制原理，在應用人工神經網路進行速度辨識的基礎上，利用遺傳演算法對神經網路速度辨識器進行了優化設計；運用遺傳演算法對pid速度調節器的結構和參數進行了整合；在採用模糊神經網路對電機定子電阻辨識的基礎上，進行了定子磁鏈及轉矩的觀測，為最終實現無速度傳感器直接轉矩控制系統的智能控制創造了條件。
  7. The paper focus on the main steam pressure control system and introduce some ways to get the systems " mathematics model. bashed on which i present some control methods and basic theory on neural network control. i designs an neural network controller

    本文以電廠主汽壓力控制系統為研究對象，介紹了主汽壓力主要的數學模型機理建模方法及系統辨識方法，介紹了幾種控制方式以及神經網路控制基本原理，並在其基礎上設計了神經網路控制器。
  8. Genetic algorithm is used to optimize the parameters of pid controller that is used to control the plant lon ( local operating network ) is designed to control vav air - conditioning system. by this means the static pressure control and minimum total supply air volume control are experimented. the paper analyzes the coupling among loops, the whole system ' s stability and energy saving effect under the two control methods

    針對目前變風量空調系統的模型都是用機理建模方法建立的情況，本論文用最小二乘法對機組部分進行系統辨識，建立了水閥?送風溫度、變頻風機?靜壓兩個迴路的模型，經驗證比較接近實際系統；採用遺傳演算法對pid控制器的參數進行尋優，尋優結果令人滿意；設計了變風量空調系統的lon控制網路，以此為實現手段，進行了定靜壓控制和最小總送風量控制，並在兩種控制方式下，分析了各個迴路的耦合情況、兩種控制方式的穩定性和節能效果。
  9. The data is collected and compressed by the single chip computer system and transferred to the server of the data process center via internet. in the server, a handwritten chinese character recognition algorithm using chinese character feature extraction method is proposed. in order to recognize the handwritten chinese character, a new model database of the chinese character is setup

    文中詳細介紹了數據採集終端的硬體設計，闡述了8位單片機系統中手寫漢字點陣模型的建立、版式處理、漢字點陣的壓縮演算法，服務器端漢字點陣預處理方法，筆劃特徵的提取，小字庫量漢字字模的建立形式，並提出了一種基於點陣形式的手寫漢字辨識方法。
  10. That is one of the reasons finite - state machines have been deployed for years in graphics processors and voice - recognition systems and in hardware design

    多年來，繪圖處理器、聲音辨識系統與硬體設計一直都採用有限狀態機，這就是原因之一。
  11. This paper first suggests how a metaphor is understood and then presents a survey of current computational approaches, in terms of their linguistic historical roots, underlying foundations, methods and techniques currently used, advantages, limitations, and future trends. a comparison between metaphors in english and chinese languages is also introduced because compared with development in english language chinese metaphor computation is just at its starting stage. so a separate summarization of current progress made in chinese metaphor computation is presented

    論文第一大部分，首先對比人類隱喻理解的過程總結出隱喻機器理解研究應該分成相互關聯的三個階段來進行：第一個階段是隱喻的識別，即辨別出隱喻並同時辨別出構成隱喻的各相關成分，如本體喻體相似性等第二個階段是隱喻的分析，即構建本體到喻體的相似關系的映射或邏輯分析系統第三個階段是隱喻意義的解析，即推出隱喻的真實含義。
  12. We propose the joint filterbank precoders and decision feedback equalizers structure at first, by which the dispersive channel is equivallent into parallel independent flat fading subchannels such that the diversity gain of the receiver is increased. then we adopt the discrete - time ( dt ) canonical model to convert the problem of blind signal processing of tv dispersive channels into processing the time - invariant multi - channels model blindly, and discuss the problem of blind equalization and identification of tv dispersive channels based on this new model

    第一種是採用濾波器組聯合均衡方法將色散通道等價為一組獨立的平坦衰落子通道，以提高接收機的分集增益；另外一種是提出採用離散正則模型將時變色散通道的盲信號處理轉化為時不變多通道模型的盲信號處理，並針對該模型對時變色散通道的盲均衡與盲辨識方法進行了詳細討論。
  13. As a typical system of mass, a cooperative multi - mobile robot system is at the core of this dissertation. path planning of the cooperative multi - mobile robot system, robust identification and robust control of each mobile robot for tracking the planned paths are studied in five chapters as follows : firstly, definition of multi - agent systems, proposal of robustness study of mass, status and existing problems in path planning of mobile robots, in nonlinear system identification and in nonlinear system robust control are discussed

    全文共分五章，主要內容如下:首先介紹了多智能體系統的定義、多智能體系統魯棒性研究的提出，以及移動機器人系統的路徑規劃、非線性系統辨識和非線性系統魯棒控制的研究現狀及存在的問題;然後針對合作式多移動機器人系統的路徑規劃，創造性地提出了合作式共同進化自適應遺傳演算法，以及移動機器人路徑的定長十進制編碼機制。
  14. The plan is that computers will have a secure mode in which they will run only applications that have been authenticated by remote trusted certification authorities ( “ attested ” ) ; moreover, these authorities would not necessarily be able identify them or their owners

    另外，這些認證機構並不需要辨識電腦或電腦持有人，只要在電腦主機板上安裝一片安全晶片，或是把晶片嵌入其他器材內，就可以執行把關任務。
  15. For vector control of asynchronous motor, a novel rotor resistance identification method, based on extended kalman filter ( ekf ), is proposed in this paper

    針對異步電動機矢量控制，提出了一種基於擴展卡爾曼濾波器的轉子電阻辨識方法，並據此建立了一個matlab / simulibnk模擬模型。
  16. The 100 - kilogram 220 - pound robot can also distinguish eight different kinds of smells, can tell which direction a voice is coming from and uses powers of sight to follow a human face

    這個重達100公斤的機器人還可以分辨8種不同的氣味，識別聲音的來源方向，並能通過其視覺能力識別人的面孔。
  17. The 100 - kilogram ( 220 - pound ) robot can also distinguish eight different kinds of smells, can tell which direction a voice is coming from and uses powers of sight to follow a human face

    這個重達100公斤的機器人還可以分辨8種不同的氣味，識別聲音的來源方向，並能通過其視覺能力識別人的面孔。
  18. This thesis has discussed several primary algorithm of speed estimation and emphasized on the algorithm of speed estimate based on mras. it worth researching duo to it has excellent robustness and little be effected by the parameter of motor

    無速度傳感器是當今電機控制領域的研究熱點，本文討論了幾種基本的電機轉速估算方法，特別是基於mras的速度辨識方法，由於其具有較好的魯棒性，受電機參數變化影響小，很有研究價值。
  19. ( 4 ) with the help of the experimental samples, a drnn identifier is trained off - line utilizing the compound identification method. the nonlinear dynamic model is achieved for the experimental mechanism

    4 .在系統辨識方面，本文以實驗輸入輸出數據作為訓練樣本，採用復合辨識方法離線設計了動態遞歸神經網路辨識器，獲得了彈性連桿機構的非線性動力學模型。
  20. The parameters estimation with the least square method is applied to the open speed system. the least square estimation with forgetting factor and the least square error self - tuning control are applied to the close speed system and controller parameters arc obtained from estimation parameters directly

    採用最小二乘參數估計演算法對某渦扇發動機低壓轉速進行開環辨識，採用帶遺忘因子的最小二乘估和直接獲得控制器參數的自校正控制對該系統進行閉環控制。
分享友人
分享到 Line

分享到臉書