機械脫出 的英文怎麼說

中文拼音 [jīxiètuōchū]
機械脫出 英文
mechanical runout
  • 機 : machineengine
  • 械 : 名詞1. （器械） tool; instrument 2. （武器） weapon 3. [書面語] （枷和鐐銬之類的刑具） fetters, shackles, etc
  • 脫 : Ⅰ動詞1 （脫落） cast; shed; drop; fall off 2 （取下; 除去） take off; strip; cast off 3 （脫離） ...
  • 機械 : 1. （利用力學原理組成的各種裝置） machinery; machine; mechanism 2. （死板; 刻板） mechanical; inflexible; rigid
  • 脫出 : abjection; prolapse; take off; come off
  1. Its principle is : a laminated structure ( beam or plate ) with delamination consists of undelaminated region and delaminted region which can be divided to upper and lower parts. when a low - amplitude and high - frequency excitation has the frequency close to some part ' s natural frequency, this part will resonate and certain amount of mechanical energy will convert to heat so that the delaminated region ' s temperature exceeds greatly that of the undelaminated region. therefore the delamination can be located by means of infrared thermograph

    其原理是具有脫層的層合材料構件（梁或板）包含脫層區域及未脫層區域，脫層區域分為上下兩部分，若對層合材料構件施加小振幅、高頻率的振動激勵，當激勵頻率恰好接近其中一部分的固有頻率時，該部分就會產生共振響應，部分機械能將轉化為熱能，使脫層區域的溫度遠高於未脫層區域，藉助紅外熱像儀即可顯示出脫層的位置。
  2. An automated de - noising algorithm based on the energy of wavelet packet not donoho ' s threshold algorithm is established. a gear feature vibration signal extraction method using the wavelet packet energy is proposed, which can separate gear meshing vibration, noise vibration and gear fault vibration signal from the original gearbox case vibration signal. basis pursuit ( bp ) algorithm is introduced into the filed of mechanical signal de - noising and feature extraction for the first time

    第三章擺脫了donoho的閾值消噪思想，從能量的角度建立了基於小波包的自動消噪演算法；提出基於小波包能量分佈的齒輪故障特徵信號提取方法，可以將齒輪嚙合振動信號、干擾振動信號以及故障沖擊振動信號從原始齒輪振動信號中分離出來；首次將基追蹤消噪演算法引入到機械故障信號的消噪與特徵提取上，通過對齒輪故障信號的消噪，表明了它的有效性，並對影響該方法實際應用效果的因素進行了全面的分析，同時也指出了該方法存在的局限性。
  3. Practice during the period of four years shows : ( 1 ) settled water pond and three - stage filtration system with mechanical agitation can meet the requitments of reverse - osmosis components to the inlet water quality ; ( 2 ) it must be considered in the design that the demineralization efficiency of reverse - osmosis components will be decreased about 1 % 2 % in every year ; ( 3 ) in normal case, the outlet water from reverse - osmosis equipment shall enter into mixed bed via a decarbonator ; ( 4 ) the output capacity of the mixed bed must have a sufficient surplus, to avoid its influence on the water supply

    經4年的實踐表明： （ 1 ）採用機械攪拌澄清池和三級過濾的系統，可以達到反滲透組件對進水水質的要求； （ 2 ）反滲透組件的脫鹽率每年約降低1 % 2 % ，在設計中必須考慮； （ 3 ）一般情況下，反滲透裝置的出水應經過除碳器再送入混床； （ 4 ）混床的出力必須有足夠的余量，以免影響供水。
  4. Just like all mechanical devices, growing metallic prostheses will wear out, break or become loose with time

    一如所有的機械裝置，金屬骨經長時間使用后，同樣會出現勞損、破裂和松脫的現象。
  5. The compound technique used carbon acid lithium or lithium hydroxide monohydrate as the raw material, and the technique of mechanism dehydration of high chlorine acid lithium is created by our academic only

    本項目在我所多年研究生產的基礎上，制定出工藝路線，採用碳酸鋰或氫氧化鋰為原料進行高氯酸鋰合成技術、高氯酸鋰機械化脫水分散技術為我所獨創。
  6. Sludge disposal system availability range from c13 superscript bin discharging sludge dewatering mouth, until dry sludge provide material, burning, smoke and ash emissions purification of the entire output of mechanical equipment, process pipelines, electrical equipment, instrument control system and civil engineering, including the whole project within the scope of the design, construction, manufacture, installation, and trial run and test run after the normal operation of the after - sales service

    污泥處置系統供貨范圍從c13標脫水污泥料倉出料口開始，直到干化污泥出料、焚燒、煙氣凈化排放和灰渣輸出為止的整套機械設備、工藝管道、電氣設備、儀控系統和土建工程，包括整個工程范圍內的設計、施工、製造、安裝調試、試運行及正常運行后的售後服務。
  7. The catalyst for ethylbenzene dehydrogenation with high mechanical strength was prepared by optimizing chemical composition and adjusting preparation condition

    實驗結果表明，通過優化催化劑的化學組成，改進催化劑的制備條件，完全可以開發出機械強度好的低鉀乙苯脫氫催化劑。
  8. In this thesis, a novel structure of silicon - based passive ring waveguide resonation cavity is firstly introduced and designed. the design is combined with the mems technology, which gets rid of the curved waveguides in the previous waveguide ring resonation cavity and facilitates optical integration. the structure has characteristic of " the smaller the resonation cavity, the smaller the loss ", which has a promising future of miniaturization and fits the field of resonation rmog

    本文首次提出並設計了一種新結構的硅基無源環形波導式諧振腔，該設計與微機械技術相結合利用集成反射鏡實現光波導直角轉彎，擺脫了以前的波導式環形諧振腔中必需包含的彎曲波導，易於光學集成；同時該結構具有諧振腔越小損耗就越小的特點，有很好的微型化前景，很適合應用於諧振式微光陀螺（ rmog ）領域。
分享友人
分享到 Line

分享到臉書