橫向剪切 的英文怎麼說

中文拼音 [héngxiàngjiǎnqiē]
橫向剪切 英文
lateral shear
  • 橫 : 橫形容詞1. （蠻橫; 兇暴） harsh and unreasonable; perverse 2. （不吉利的; 意外的） unexpected
  • 剪 : Ⅰ名詞1 （剪刀） scissors; shears; clippers2 （姓氏） a surname Ⅱ動詞1 （用剪刀等使細的或薄片的東...
  • 切 : 切Ⅰ動詞1 （合; 符合） correspond to; be close to 2 （用在反切后頭 表示前兩個字是注音用的反切）見 ...
  • 橫向 : broadwise; infeed; crossrange; abeam;transverse; transverse direction; cross; crosswise; lateral;...
  1. With this kind of element, panel flutter analysis can be performed not only for thin plates but for the middle - thickness laminates

    由於min3單元計及了壁板的橫向剪切效應，因此這種壁板顫振分析方法不僅可以針對薄板，而且可以針對具有中等厚度的復合材料層合板。
  2. The component of product ： this production line is mainly composed of charging wagon, single or double support uncoiler, transverse cutting machine, piling device and so on, meanwhile swing type mid - bridge, leveling draught device and deviation rectification device and so on are equipped between each machines

    產品組成：該生產線主要由上料小車，單或雙支撐開卷機，橫向剪切機，堆垛裝置等組成，同時在各機之間配有擺動式中間橋，校平牽引裝置，糾偏裝置等。
  3. 2 ) the value of base frequency, which is the first order vertical - bending vibration, is bigger in box girder bridges than those of t - beams. it shows that the vibration performance of box girder bridge is better than t - beams. 3 ) when considering the shear deformation of beam, the vibration frequency calculated by is bigger than those not considering the shear deformation

    T型梁的基頻為橫向振動，而整體箱梁的基頻為豎向彎曲振動；整體箱梁的一階豎彎振動的頻率比t型梁得到了提高；整體箱梁的動力性能優于t型梁；考慮剪切變形后，梁的自振頻率降低，對于整體箱梁其降低值接近於5 ，在分析時不應忽略。
  4. In the layered model, transverse shear is ignored and material is assumed to be in a state of plane stress, and some other presuppositions are introduced, such as cracking of concrete takes place only in the plane perpendicular to the normal

    但是鋼筋混凝土板的非線性有限元研究目前一般都是採用分層法，將板分成若干混凝土層和鋼筋層，忽略橫向的剪切影響，各層混凝土材料按平面應力狀態處理，這與真實情況有區別。
  5. It is shown that the ability of wavefront reconstruction of lsi is better than hws, for the indirect sampling information of wavefront with lsi is more than hws

    結果表明，在相同輸入波前、相同探測面元、相同擬合函數及階數的情況下，橫向剪切干涉儀的波前復原能力比哈特曼波前傳感器強。
  6. In this article, it is systematically introduced the kirchhoff ' s thin plate theory and the reissner ' s moderately - thick plate theory in which the transverse shear force has been taken into account further the different hypotheses of the two theories are analyzed then the difference of the two theories is found out

    本文系統地介紹了kirchhoff薄板和考慮橫向剪切力作用的reissner中厚板的相關理論，分析了薄板、中厚板理論的兩種不同假設，找到了二種理論主要區別。
  7. Inside the blocks, there were also some large scale shear sones or glide belts which has a discontinous and uneven feature in horizontal direction

    在地塊內部不同層次之間也常有巨型水平剪切或滑脫帶存在，造成了準噶爾造山帶在垂向上有明顯的分層性，在橫向上具有不均一性和不連續性。
  8. An experimental program which includes lots of unidirectional laminae is conducted using t300 / bmp - 316 material for researching the static and fatigue behaviour of the unidirectional ply. the experimental research for mechanical behaviour of a unidirectional lamina is to set up expressions of the normalized fatigue life, the residual strength degradation and the residual stiffness degradation of a unidirectional ply in the longitudinal, transverse and in - plane - shear directions, which also verifies the fact of nonlinear shear stress - strain behavior of a unidirectional ply in the 1 - 2 planes

    其中:分別對材料t300 / bmp - 316單向層合板縱向、橫向及面內剪切靜載力學性能及疲勞特性進行了試驗研究，並採用最小二乘法擬合得到各主方向正則化疲勞壽命表達式，以及單層板各主方向疲勞加載剩餘剛度退化表達式及剩餘強度退化表達式;試驗同時驗證了單向層合板1 - 2面上明顯的剪切應力應變非線性關系。
  9. With the increasing of raft foundation thickness, the hypothesis of kirchhoff will be invalid due to the incapable neglecting of transverse shearing deformation. the correct solution can not be deduced through theory of thin plate any more since the influence of transverse shearing deformation does not take into account

    隨著板厚度的增加，橫向剪切變形不可忽略， kirchhoff假設不再成立，薄板理論已不能給出正確的解答，橫向剪切變形的影響必須加以考慮。
  10. Transverse shearing test

    橫向剪切試驗
  11. Cross cut shears

    橫向剪切機
  12. Transverse shear modulus

    橫向剪切模量
  13. 5. the truss - arch model is brought up to analyze the shear capacity of columns within yield hinge regions. the shear contribution of concrete and transverse reinforcement, the response of various displacement ductility factors under cyclic load is described

    本文還推導了框架柱塑性鉸區域橫向剪切變形計算公式，探討了塑性鉸區域剪切變形與彎曲變形成分隨加載循環次數增加而變化的規律。
  14. The rayleigh - ritz method is used to lead to analytical expressions for the stiffness and mass matrices and load vector as well as their sensitivities, which uses the simple polynomials to define assumed displacement functions, geometry and construction of wing structures. excluding some selected terms from the displacement functions or using stiff springs at the specified locations imposes boundary conditions. the accuracy of calculated results is improved by including transverse shear effects and using multiple sets of ritz functions in the analysis

    它使用簡單多項式作為ritz基函數、定義翼面的幾何和結構參數，利用rayleigh - ritz方法導出翼面結構的剛度矩陣、質量矩陣和載荷向量及其靈敏度的解析表達式，通過排除位移函數中某些選定的項或在指定點使用約束彈簧施加各種邊界條件，考慮橫向剪切變形和使用多組ritz基函數改進分析的質量，使用等效蒙皮和等效夾芯技術提高計算效率。
  15. Our collimation testers are lateral - shearing interferometers that can be used to examine and adjust the collimation of laser light

    我們的剪切板準直度測量儀是用於檢查和調整激光光束準直度的橫向剪切干涉儀。
  16. The detection and reconstruction of wavefront by lateral shear interferometer ( lsi ) and hartmann wavefront sensor ( hws ) have been deduced analogically and simulated numerically

    對橫向剪切干涉儀和哈特曼波前傳感器的波前探測和復原進行了類比推導和模擬計算。
  17. The results indicate that auto - ignition occurs more easily when the igniter uses the cross injector with rearward facing step, the height of the rearward facing step influences the stability of the combustion flame, the longer the combustor characteristic length is, the more easily auto - ignition occurs

    研究結果表明，採用帶後向臺階的橫向噴注器比氣液同軸剪切噴注器更易於自燃，後向臺階的高度對燃燒室火焰穩定有影響，燃燒室的特徵長度越長，越利於自燃。
  18. The results show that the existing of the fluid phase has great influence on the propagation of rayleigh waves. when compressibility of the solid grains are considered, the speed of rayleigh waves is not only decided by the speed of the fast wave and the quasi - transverse wave in the solid skeleton, but also affected by the speed of the slow wave

    指出橫觀各向同性含液飽和多孔介質中，流體相的存在對瑞利波的傳播特性有很大影響，當考慮固體顆粒的可壓縮性時，瑞利波的波速不僅取決于固體骨架中快波和剪切波的波速，而且受慢波波速的影響。
  19. Abstract : the dynamic characteristics of unsymmetric ship structure with consideration of bending - bending - twisting coupled vibration and shear deformation are investigated, and the transfer matrices and a computing example are presented

    文摘:分析不對稱船體結構的雙向橫彎曲和聖維南扭轉耦合振動並考慮了剪切變形影響，給出了傳遞矩陣及算例
  20. Testing method for transverse shear strength of glass fiber reinforced plastics

    玻璃纖維增強塑料橫向剪切強度的測試方法
分享友人
分享到 Line

分享到臉書