橫向支承 的英文怎麼說

中文拼音 [héngxiàngzhīchéng]
橫向支承 英文
lateral support
  • 橫 : 橫形容詞1. （蠻橫; 兇暴） harsh and unreasonable; perverse 2. （不吉利的; 意外的） unexpected
  • 支 : Ⅰ名詞1 （分支; 支派） branch; offshoot 2 （地支） the twelve earthly branches3 （姓氏） a surname...
  • 承 : Ⅰ動詞1 （托著; 接著） bear; hold; carry 2 （承擔） undertake; contract （to do a job） 3 （客套話...
  • 橫向 : broadwise; infeed; crossrange; abeam;transverse; transverse direction; cross; crosswise; lateral;...
  1. The main girders support i-section transverse ribs.

    主梁支承著工字梁的橫向肋。
  2. The mechanism consists of a steering gear box, pitman arm, drag kink, tie rods, steering arms, and steering knuckles, the latter supporting the front wheels

    該機構由轉向器，轉向垂臂，縱拉桿，轉向橫拉桿，梯形臂和轉向節構成，轉向節支承著前輪。
  3. 2 ) the structure elements should be laid out symmetrically and uniformly when designing steeve - arch structure, what ' s more, the reasonable selection of section geometric size near the arch foots of first beams is paid attention to and the arrangement difficulties of steel bar due to the big eccentric pressures 2, the analyses of anti - seismic features on transverse direction of the aqueduct l ) the method of adjusting the elements " mass can be harnessed in order to even the layout of seismic loads

    2 ）設計吊桿式拱架支承結構時，各部分構件應當均勻對稱布置。另外，還應注意頭道梁拱腳附近截面的尺寸擬定，克服地震內力造成的大偏心受壓狀態給結構配筋設計增加的困難。 2 、橫槽向抗震性能分析1 ）可利用調整構件質量的方法，使得結構的某些構件的地震荷載分佈均勻一些。
  4. Generally, the skew bridge ' s calculation theories can be divided into three types : the category 1 is the plank theories method, such as the finite difference method, the finite element method and the finite strip method, etc ; the category 2 is the beam theories, such as the grid beam theories, the general grid theories, the rigid cross - beam method, the elastically - supported continuous beam method and the bar system analytical method, etc ; the category 3 is the practical method, such as the g - m revising method, the grid - beam simple method and ghali form coefficient method, etc

    目前關于斜梁橋的計算理論和方法概括起來，大致可以分為三類：第一類為板理論方法，如有限差分法、變分法、有限單元法、有限條法等；第二類為梁理論法，如格構梁理論、一般格構理論、剛性橫梁法、彈性支承連續法、桿件結構的分析方法；第三類為實用計演算法，荷載橫向分佈的計算方法如g ? m修正法、格構梁的簡易法、 ghali表格系數法等。
  5. The simplified method of load lateral distribution of curved beam bridge with non - radial bearings

    非徑向支承彎梁橋荷載橫向分佈的簡化計算
  6. Except from the above achievements, the paper adopts two kinds of computational methods to analysis and compare, one is the spatial fem, the other is the cross direction supporting frame method. the results are present which the spatial fem can relatively accurately reflect stress of the practical structure, and which in spite of being convenient, the cross direction supporting frame method can lead to error while determining dimension of the cross bending str ess

    另外，還針對該橋箱室較寬的特點，分別採用空間有限元模型和橫向支承框架法兩種計算方法對橫向彎曲問題進行了分析研究。結果表明：空間有限元模型能夠較準確地反映出實際結構截面的受力特點，計算所得的結果基本符合實際情況。
  7. Consequently, the precast components don ’ t need any interim falseworks to be supported in the mid - span as bottom forms when the laminated concrete lay is being placed. furthermore, to form two - way slabs, the transverse steels can be arranged through the rectangular cores in the ribs of the precast slabs as needed. it makes the construction of composite two - way slabs easier and more feasible, practical, and suitable to introduce and apply to the building construction on a large area

    由於預制構件具有剛度大和承載力高的特點，施工時以預制構件作為樓板底模無需設置跨中臨時支撐;同時還能通過預制構件板肋預留的長方形孔布置橫向受力鋼筋實現樓板的雙向配筋，使預應力雙向疊合樓板的施工簡單易行，更適合於大面積的推廣應用，具有較大的工程應用價值。
  8. Based upon the experimental research and nonlinear finite element calculation, and the analysis of joint failure modes, a set of formula was proposed to predict the ultimate bearing capacity of cfrst joints : 1 ) the ultimate bearing capacity of t -, y -, x - compression joints and k - compression branch joints can be predicted according to the failure model of transverse local compression

    基於試驗研究和非線性有限元數值計算，通過對矩形鋼管混凝土桁架節點各種可能破壞模式的分析，提出了矩形鋼管混凝土桁架節點承載力計算的破壞模式和相應計算公式： t 、 y 、 x型受壓節點和k型受壓支管節點承載力按橫向局部承壓破壞模式進行計算。
  9. Displacement method in structural mechanics and generalized grillage analogy method are combined to analyze skew support continuous curved t girder bridge, when calculating inner forces of a single curved beam, calculate its deformation, then at the base of basic principle of generalized grillage analogy, derivates calculating equations of load lateral distribution and inner forces of skew support continuous curved t girder bridge

    對斜支承連續曲線t梁橋進行分析時，採用結構力學的位移法與廣義梁格法相結合，在求解單根曲線梁內力的同時，求得其變形，在此基礎上利用廣義梁格法基本原理，進行荷載橫向分佈及內力計算，推導出斜支承連續曲線t梁橋的內力與荷載橫向分佈計算公式。
  10. In cross calculation, the structure subject to cross force and the reverse force of elasticity support can be derived from the bottom elasticity support on each longitudinal beam ; then, with the elasticity reverse force as the loading reversed acting on the side walls and the middle longitudinal beam, the longitudinal beam subject to force can be calculated

    橫向計算中，底部彈性支承在各縱樑上，可求得結構的橫向受力與彈性支承反力；然後將彈性反力作為荷載，反向作用於側墻和中間縱樑上，進行縱向梁的受力計算。
  11. Thus, when functions and incomes can not be peer to peer, or local governments encounter fiscal gap inevitably, we need more detailed distinction to ensure the rationality of function that local governments take on, and we need transfer payment to realizes upright equilibrium and horizon equilibrium, ensuring inhabitants in different areas can enjoy fundamental or approximately equivalent public services

    因此，在事權財權無法對等的情況，在地方政府不可避免存在財政缺口的情況，我們需要對支出職能更加詳細的劃分確保地方政府所承擔支出職能的合理性；我們需要依靠轉移支付來實現縱向平衡和橫向平衡，保證不同地區的居民都能享受到最基本或大體相當的公共服務。
  12. While a cwps can be as high as 13 metres, the ground behind the cwps would yield high lateral earth pressures, which shall be counter - balanced by the pile foundations

    -由於冷卻用水抽水站可能有13米高，因此，冷卻用水抽水站後方的土地須承受巨大的橫向土壓力，必須以樁柱地基支承。
  13. We consider each sleeper as an abutment of opposite forces, rails on horizontal sleepers as a mock dispersed elastic ground beam model and trains as moving load on beams. geometric roughness and damping are not taken into consideration

    將每根枕木考慮成一個支座反力，將橫向枕木支承的鋼軌模擬成離散的彈性地基梁模型，將列車考慮成一個作用在樑上的移動荷載。
  14. In this paper, the studied works are list as follows : 1 ) the theory of elastically supported continuous beam method is brought forward to transfer spatial continuous beam - arch composite bridges into plane structure. the plane finite element method is used to calculate inner forces and deflections of each beam and arch. at the same time, spatial finite element model is created for contrast

    研究提出用彈性支承連續梁法荷載橫向分佈理論計算空間梁拱組合式橋梁的荷載橫向分佈，從而將空間問題轉化為平面計算問題，進而用平面桿系有限元理論分析求解梁拱拱片各桿件截面的內力和撓度，並用空間有限元理論和通用程序建立空間模型進行對比計算。
  15. The danger of buckling may be present here if sufficient lateral support is lacking.

    如果缺乏足夠的橫向支承，這里就有可能存在彎曲的危險。
分享友人
分享到 Line

分享到臉書