橫向收縮 的英文怎麼說

中文拼音 [héngxiàngshōusuō]
橫向收縮 英文
cro shrinkage
  • : 橫形容詞1. (蠻橫; 兇暴) harsh and unreasonable; perverse 2. (不吉利的; 意外的) unexpected
  • : Ⅰ動詞1 (把攤開的或分散的事物聚集、合攏) put away; take in 2 (收取) collect 3 (收割) harvest...
  • : 縮構詞成分。
  • 橫向 : broadwise; infeed; crossrange; abeam;transverse; transverse direction; cross; crosswise; lateral;...
  • 收縮 : 1 (由大變小; 由長變短) contract; shrink 2 (緊縮) concentrate one s forces; draw back 3 take u...
  1. The cyclo - hoop effect which steel tubular has exert to the concrete shows the character of heterogeneous in the arch rib section, the same to the axial direction. the paper verifies the change of the material poisson ration and the concrete grade will make the cyclo - hoop effect obvious alteration, the change of the cyclo - hoop effect and the stress redistribution of the section produced by the shrinking and creeping of the concrete and the expensive concrete on the section

    在鋼管混凝土拱肋斷面上,鋼管對內填混凝土的環箍效應具有非均勻性,在拱軸方上環箍效應也呈現非均勻性。驗證了材料的變形系數、混凝土標號等參數的變化將引起環箍效應的明顯改變;混凝土的、徐變和膨脹混凝土的應用導致鋼管混凝土的環箍效應發生變化並使截面的應力發生重分佈;並總結了其變化的基本規律。
  2. While in diastole, there were ( 1 ) antegrade in the transverse aorta, and retrograde in the ascending aorta and descending aorta ( below fda ), and ( 2 ) left - to - right shunt in the fda

    結果發現:在期時,在升、降主動脈是順(前進)血流,在主動脈是逆血流,在動脈導管是右至左分流。
  3. In this thesis, the new structure of pre - stressed cantilever composite beam with corrugated steel webs on steel - concrete composite spine girder was brought forward for the first time, a series of experimental researches and theoretical analyses relating to this new structure are conducted, including load transverse distribution rule, shrinkage and creep effect, temperature difference effect, and ultimate bearing capacity

    本文提出大懸臂預應力波形鋼腹板挑梁這一新的構造形式,對其分佈規律、徐變、溫差效應以及承載能力等方面的受力特徵進行了分析和試驗研究。
  4. The experiment data shows that the region with large surface gradients in longitudinal and horizontal direction locates at the vicinity of spur dike. backwater appear upstream the spur dike, and there exist a recirculation area at the same side downstream the spur dike

    實測水位資料表明水流縱比降大的區域位於丁壩上下游附近,在丁壩的上游出現壅水,下游存在有區和恢復區,離丁壩越遠縱水位的變幅越小。
  5. Welding position : if the configuration collocation of weld is symmetry and the welding sequence is reasonable, the longitudinal contraction and transverse lateral contraction deformation are usually produced, incontrast, the bending deformation is usually produced

    焊接位置:如果焊縫在結構布置對稱,焊接順序合理時,則主要產生縱橫向收縮變形,反之,則要發生彎曲變形。
  6. Transverse / cross / lateral contraction deformation : the component contracts in the upright direction of weld after weiding

    橫向收縮變形:構件焊后在垂直焊縫方上發生的
  7. Recommendations for the presentation of plastics design data - mechanical properties - creep lateral contraction ratio poisson ' s ratio

    塑料設計數據表示方法推薦標準.第1部分:機械特性.第1節:蠕變.第3小節:蠕變橫向收縮
  8. Secondly author calculates and analyses normal stress and shear stress of the girder for a assembling post - tensioned concrete skew girder bridge with a span of 40 m due to the actions of the dead load, temperature changes, shrinkage and creep of concrete and live loads, and calculates and analyses normal stress and shear stress of diaphragms due to the actions of the subordinate phase dead load, temperature changes, shrinkage and creep of concrete and live loads

    其次重點對跨徑為40m標準設計的裝配式后張預應力混凝土斜梁橋在恆載、溫度變化、混凝土和徐變、活載作用下主梁的正應力、豎變形和恆載、活載作用下主梁的剪應力進行計算分析。計算分析隔板在二期恆載、溫度變化、混凝土、活載作用下的正應力、剪應力。
  9. Taking the example in the three gorges hydroelectric station, we researched the influence of the weld process on the construction and operation of penstock after moving contract - elongate nodes, analyzed the deformation law of two plans and calculated the crosswise and lengthwise shrinkage in weld process using experience formula and theory respectively, and then analyzed the influence of the welding and installing process on shrinkage, finally chose the best installation plan

    摘要以三峽水電站引水壓力鋼管施工現場為實例,研究取消伸節后焊接對引水壓力鋼管施工的影響,分析了兩種方案在焊接過程中的變形規律,分別用經驗公式和理論計算出兩種方案焊接時的和縱量,然後分析量對安裝焊接過程的影響,選擇出最佳安裝方案。
分享友人