橫裂紋 的英文怎麼說

中文拼音 [hénglièwén]
橫裂紋 英文
cross crack
  • 橫 : 橫形容詞1. （蠻橫; 兇暴） harsh and unreasonable; perverse 2. （不吉利的; 意外的） unexpected
  • 裂 : 裂動詞[方言] （東西的兩部分向兩旁分開） open
  • 紋 : 名詞（花紋; 紋縷兒） lines; veins; grain
  1. Floor-beam webs have cracked in tied arch bridges.

    在系干拱橋的橫梁腹板上發生裂紋。
  2. Often lack of fusion adjacent to the girder web in the transverse groove welds led to the cracking.

    在靠近主梁腹板的橫向坡口焊縫處常常出現未熔透而導致裂紋。
  3. In order to show the scattering and complex mode - conversion clearly, the total field is decomposed into longitudinal and transverse parts and the scattered field is obtained by subtracting incident wave from the total field

    通過對縱橫波的分離和在全波場中對散射波的分離，清晰地顯示了裂紋對脈沖超聲波的散射和復雜的模式轉換。
  4. These cracks occurred at either the beam flange or in the column flange depending on the reentrant corner weld angle.

    這些裂紋視凹形焊角的不同，或者出現在橫梁翼緣上，或者出現在立柱翼緣上。
  5. Cracks, growing at weld toe, tend to form at numerous sites along the transverse width perpendicular to the applied stresses.

    焊趾處萌生的裂紋往往在垂直於作用應力方向沿著橫向寬度在多處形成。
  6. 3. the two stages of primary creep and steady - state creep of 3d c / sic correspond to the gradual saturation of matrix crack and the opening of these cracks respectively. the transverse crack is the main contributor to the macroscopic creep strain of 3d c / sic, and its opening is controlled by the creep temperature

    （ 3 ） 3dc sic復合材料的減速蠕變階段和穩態蠕變階段分別對應著基體裂紋趨于飽和和逐漸張開這兩個過程；橫向基體裂紋是3dc sic復合材料宏觀蠕變應變的主要貢獻者，溫度是影響橫向裂紋張開速度的一個重要因素。
  7. This segregation behavior of sn accords with the mechanism of non - equilibrium segregation. it can be obtained through the theoretical calculations that the critical time of sn non - equilibrium segregation is 124 seconds at 750 and the critical cooling rate is 8 / s when cooling from 1320. it is suggested that controlling the cooling rate during continuous casting to avoid the critical cooling rate ( 8 / s ) and avoiding high stress near the trough temperature ( 750 ) may control the form

    通過研究殘留元素sn的偏聚機制及其對o . 15wt . % c鋼熱塑性的影響，對試驗鋼進行脆性預測:建議在該鋼的連鑄過程中彎道矯直溫度盡量避開塑性谷底溫度750 ，二冷區的冷速盡量避開臨界冷卻速率8 / s ，從而可以減少該低碳鋼連鑄坯表面裂紋和橫向裂紋，提高其成材率。
  8. Main research content including : 1 ) have studied a same diameter shaft, study how to make use of the change of natural frequency to discern the transverse crack

    本文主要的研究內容包括： 1 ）以最簡單的等直徑光軸為例，研究了利用固有頻率的變化來識別光軸上橫向裂紋的可行性。
  9. A complete parabolic shear - lag analysis containing delamination damage induced by transverse cracks was proposed and applied to predict the global properties of materials

    第三，研究了在應力較高時橫向開裂裂紋的裂尖引發的分層損傷現象。
  10. 2 ) the effects on waves conversion are stronger in rocks with dry fractures than that in rocks with water - filled fractures, and s - waves attenuate more rapidly in rocks with water - filled fractures. 3 ) the explosive point source which locates in anisotropic media can excites not only p - waves but also s - waves. 4 ) the properties of waves propagation were discussed and compared for several point sources with different source functions

    結果表明： 1 ）平行排列裂縫造成的各向異性使波前變寬； 2 ）含乾裂縫巖石對波型轉化的影響比含充水裂縫巖石的大，橫波在含充水裂紋中傳播時衰減較快； 3 ）當介質存在各向異性時，爆炸點源產生的波不僅有縱波，還有橫波； 4 ）通過改變點源函數研究不同點源所產生波以及波型的轉換。
  11. Research on solving cracks on bottom cross beam of 30000 t water hydraulic press and its removal

    三萬噸水壓力機下橫梁裂紋處理的研究與消除
  12. 2 ) have studied the natural vibration characteristic of the crankshaft with and without the transverse crack

    2 ）研究了曲軸在含橫向裂紋前後兩種狀態下的固有振動特性。
  13. Though this text is the research on the transverse crack in the crankshaft, but the method and the conclusion should have reference value to other scholars

    本文雖然研究的是曲軸上的橫向裂紋，但是研究所採用的方法和所得出的結論對其他的學者的研究應該是參考價值的。
  14. The result indicates : adopting certain data processing method, it is feasible to make use of the change of natural frequency to discern the transverse crack in the shaft, and the precision discerned is very high

    結果表明，採用一定的數據處理方式，利用固有頻率的變化來識別光軸上的橫向裂紋是完全可行的，並且識別的精度很高。
  15. The result shows that when contain the transverse crack in the crankshaft, and the depth of the crack is strengthened gradually, its acceleration signal responding frequency moves toward high frequency gradually

    結果表明，當曲軸中含有橫向裂紋，且裂紋逐漸加深時，其響應的加速度信號在頻域范圍內的主頻是逐漸向高頻方向移動的。
  16. The result indicates : when the transverse crack was contained in the crankshaft, the crankshaft ' s natural frequency reduced obviously, but does not change the vibration form of every type

    結果表明，曲軸在含有橫向裂紋后，其固有頻率有很明顯的降低，但是不改變各階振型的振動形式。因此，固有頻率的降低可以作為曲軸中含有橫向裂紋的標志。
  17. The crack moving problem for an infinite orthotropic functionally grated material under antiplane shear loading

    無限大橫觀各向同性功能梯度材料反平面裂紋動力學問題
  18. The incident involved a cathay pacific airways boeing 747 - 236f freighter. the torque bulkhead at the rear of the aircraft s no. one engine pylon was found to have suffered from a failure in the form of a crack that extended across the full width of the bulkhead

    事故涉及國泰航空公司一架波音747 - 236f型貨機的一號發動機吊架後部的扭力隔板損壞，有一道裂紋橫跨整段隔板。
  19. Analysis on cause of crack formation in beam of linear vibration screen

    直線振動篩橫梁產生裂紋的原因分析
  20. ( 1 ) assuming that the gfrp rods is transversely isotropic material. derive the micro - mechanical model of splitting failure in concrete reinforced with gfrp rods. analysis the stress and its distribution of the cracked concrete around the gfrp rods, finding the relations of the number of cracks and the crack radius and the stress around the interface of concrete and gfrp rods

    （ 1 ）將玻璃鋼筋視為橫觀各向同性材料，推導了gfrp筋增強混凝土劈裂失效的細觀力學模型，分析了玻璃鋼筋周圍混凝土開裂時的應力及其分佈情況，得到了裂紋數量、開裂半徑與玻璃鋼筋/混凝土界面周圍應力的定量關系。
分享友人
分享到 Line

分享到臉書