檢定板 的英文怎麼說

中文拼音 [jiǎndìngbǎn]
檢定板 英文
assaying table
  • : Ⅰ動詞1 (查) check up; inspect; examine 2 (約束; 檢點) restrain oneself; be careful in one s c...
  • : Ⅰ形容詞1 (平靜; 穩定) calm; stable 2 (已經確定的; 不改變的) fixed; settled; established Ⅱ動詞...
  • : Ⅰ名詞1 (片狀硬物體) board; plank; plate 2 (專指店鋪的門板) shutter 3 [音樂] (打拍子的樂器) ...
  • 檢定 : docimasy; docimasia; verification; calibration; appraisal檢定報告 probation report; 檢定滴定管 [...
  1. Microbiological examination of meat and meat products ; determination of coagulase - positive staphylococci ; by the drop method

    肉和肉製品微生物驗.凝結陽性葡萄球菌.滴
  2. Verification regulation of slip plate type automobile side slip tester ' s aligner

    式汽車側滑驗臺儀試行
  3. Motor vehicle safety testing equipment technical requirements of verification - part 1 : technical requirements of verification for side slip tester of slipper type

    機動車安全測設備技術條件第1部分:滑式汽車側滑試驗臺技術條件
  4. Verification regulation of spherometer special - gauge

    球徑儀樣試行規程
  5. Verification regulation of slipe plate type automobile side slipe tester

    式汽車側滑驗臺規程
  6. Verification regulation of gear helix master

    齒輪螺旋線樣規程
  7. Verification regulation of wheel seat gauge for vehicle axle

    車輛車軸輪座弧度樣規程
  8. Verification regulation of coupler gauge no 13 used for depet repair

    13號車鉤段修樣規程
  9. In view of the altitude problems of inspecting the weighted average ways of obtaining altitude and the advantages and disadvantages of moving surface interpolation method are talked about through comparison, with which the writer draws a conclusion that moving surface interpolation method is suitable to be applied for the dynamic state inspection places, moreover the key technology about the dynamic slate inspection is also taken into consideration, which includes digital camera and types of camera lens, the cause of camera lens distortion and the fundamental determining principle, the gain of image coordinate and the realization of time synchronization

    針對點高程問題,分析比較了獲取高程的加權平均法和移動曲而內插法的優缺點,得出移動曲面內插法適合用於動態場的結論。特別是針對動態的關鍵技術給予了相關研究,內容涉及:數碼相機及相機鏡頭的選型,相機畸變差產生原因及測的基本原理,像片坐標獲取以及時間同步實現,得出結論:利用gpsoem的秒脈沖( 1pps )輸出特性,能夠實現兩臺數碼相機與gps接收機時間同步,滿足動態指標要求。
  10. Verification regulation of standard grid plate

    標準玻璃網格規程
  11. Calibration of involute tooth profile gauges for the gears of locomotive

    機車齒輪用漸開線齒形樣
  12. If the confirmed size from the above formula is not practical, it is necessary to apply flange wheel hub and checking board, the checking board should be connected with gear with bolt, and the bolt should be on special pitch circle radius

    21 . 1如果從上面公式確的鍵槽尺寸不實用,那麼應採用帶鍵的法蘭式輪轂和用螺栓連接在輪上,螺栓處于特別的節圓半徑上。
  13. Verification regulation of colour standard plates

    標準色規程
  14. Verification regulation of the chambers for counting blood cells

    血細胞計數試行規程
  15. The technology of micro - electronics and calculation method was fully made in the system. how to improve the accuracy of standard orifice measurement is also discussed from the following aspects : the means of measurement and transmitter, online correction of measurement parameter and abnormal condition. all those means are used to overcome its shortcomings of less scale of measurement range, short period of checkout, more tache of maintenance and low accuracy of measure

    該系統充分利用微電子技術和計算技術以及通過實際現場總結的經驗,主要從測量與變送環節採取的措施、相關參數的在線實時補償演算法、非正常情況的在線補償三個方面對如何提高量精度加以論述,盡可能地彌補孔差壓式流量計量程比較小、周期短、維護環節多、準確度低的不足。
  16. Verification regulation of model clx - 2 clx - 20a 20b parallel - plate coaxial slotted line with big size connector

    Clx - 2型和clx - 20a 20b型大接頭平型同軸測量線規程
  17. Verification regulation of fineness of grind gage

    細度計規程
  18. Verification regulation of specular gloss meters and gloss plates

    鏡向光澤度計和光澤度規程
  19. Verification regulation of steering force stering angle brake pedal force tester ' s aligner

    轉向力角儀制動踏力計儀試行
  20. Motor vehicle safety testing equipment technical requirements of verification - part 9 : technical requirements of verification for platform brake tester

    機動車安全測設備技術條件第9部分:平制動試驗臺技術條件
分享友人