檢定極限 的英文怎麼說

中文拼音 [jiǎndìngjíxiàn]
檢定極限 英文
detection limit
  • 檢 : Ⅰ動詞1 （查） check up; inspect; examine 2 （約束; 檢點） restrain oneself; be careful in one s c...
  • 定 : Ⅰ形容詞1 （平靜; 穩定） calm; stable 2 （已經確定的; 不改變的） fixed; settled; established Ⅱ動詞...
  • 極 : i 名詞1 （頂點; 盡頭） the utmost point; extreme 2 （地球的南北兩端; 磁體的兩端; 電源或電器上電流...
  • 限 : Ⅰ名詞（指定的范圍; 限度） limit; bounds Ⅱ動詞（指定范圍, 不許超過） set a limit; limit; restrict
  • 檢定 : docimasy; docimasia; verification; calibration; appraisal檢定報告 probation report; 檢定滴定管 [...
  • 極限 : 1 （最高的限度） the limit; the maximum; the ultimate limit; limitation; extremity; tipping point...
  1. Polarograph quantitative detection limit

    極譜儀定量檢測限
  2. The pyrogallol was adhered on the surface of the solid electrode by the direct oxidative electropolymerization to construct the chemical sensors for bi ( iii ). the sensor exhibits perfect long stability and reproducibility. a low detection was obtained in the determination of bi ( iii ) and this way can be applied to determine the real samples such as human hair and nails

    2 、將修飾劑鄰苯三酚直接電聚合到固體電極的表面，研製bi （ ）離子化學傳感器，該修飾電極穩定性和重現性很好，克服了以往碳糊電極機械強度差、重現性不好的缺陷，測定bi （ ）達到了很低的檢出限，應用於人發和指甲等實際樣品的測定。
  3. " in order to ensure flight safety the cad has been active in promoting new safety requirements relating to the avoidance of fatigue in aircrews and to this end, the flight time limitations working group ( ftlwg ) was established in 1997

    發言人說：為了保障飛行安全，民航處一向積極推廣避免飛行員過勞的新規定。飛行時間限制工作組遂於一九九七年成立，檢討有關計劃的現行條文，並且因應超長航距運作而訂立所需的要求。
  4. The conclusion of reappearing analysis is that crane bridge be used as usual because main weld maximum stress of upper cover plate of main beam lower than yield limit though it higher than permissible stress. inner stress of secondary beam was over ultimate strength, and deforming is ultra big. so it was unfit for produce and secondary beam must be changed

    再現分析得出的主要結論為：橋架的主樑上蓋板主焊縫的最大應力超過了許用應力，但小於屈服極限，可以繼續投入使用；副梁內部的應力遠遠超過了強度極限，變形特別嚴重，不能滿足生產要求，因此更換新的副梁；端梁內部的應力超過了屈服極限，小於強度極限，在應力較大的位置焊接補強板；投入使用后，要對整個橋架進行定期檢查。
  5. Second, the test report produced by the system is not the standard case report. the purpose of this article is to develop a way to increase the clinical samples per test and design the mis for autodelfia 1235. [ methods ] ( l ) the remain volume in the reagent bottle corresponding of the assay buffer, incubation buffer, eu and ab was obtained by surveying the limited probe position of the right and left dispenser, respectively

    [方法]測定左右兩個試劑分配器的探測極限位置，獲得各類試劑的最低剩餘量；定量分析和測試配套藥盒各類試劑的實驗用量，獲得雙微孔板測試各類試劑的實驗配置量；定量檢測各類試劑瓶的容積，評估雙微孔板測試採用單微孔板封裝藥盒的可行性。
  6. By a lot of trial and error, a new - type lightweight fireproofing board is developed. the test results indicate this production has obvious characteristics such as high temperature resistant, moistproofing, low distortion, and fireproofing limitation of 3h. its safety and toxicity has been examined according to relative national criterion and standard and the results show that no deleterious and poisonous gas is produced after combustion

    經過反復多次試驗、篩選，研製出的隧道防火板質輕，具有一定的柔韌性，便於施工;耐溫、耐潮濕;變形小;耐火極限達3h ;安全毒性方面，參照室內空氣質量檢測標準等規范進行了測試，測試結果為:產品不釋放有害氣體，屬環保型材料;按照國家相關的材料規范檢測其毒性，檢測結果表明，產品在燃燒后不產生有毒有害氣體。
  7. Testing of textiles ; determination of the limit - viscosity of celluloses, principles

    紡織品的檢驗.第1部分:纖維素極限粘度測定原則
  8. Testing of textiles ; determination of the limit - viscosity of celluloses, nitrate procedure

    紡織品的檢驗.用硝酸鹽法測定纖維素的極限粘度
  9. Testing of textiles ; determination of the limit - viscosity of celluloses, ewnn - procedure

    紡織品的檢驗.第3部分:纖維素極限粘度的測定. ewnn程
  10. Testing of textiles ; determination of the elastic behaviour of single and plied yarns by a single application of tensile load between constant force limits

    紡織品的檢驗.用恆定拉力極限間的單一拉伸載荷測定單
  11. Determination of long - term radiation ageing in polymers ; part 1 : techniques for monitoring diffusion - limited oxidation

    高聚物長期輻射老化的測定.第1部分:檢測氧化彌漫極限的技術
  12. Limit of detection and limit of decision for nuclear radiation measurements ; counting measurements by high resolution gamma spectrometry, neglecting the influence of sample treatment

    核輻射測量的檢測極限和判定極限.不考慮試樣處理影響
  13. Testing of textiles ; determination of the elastic behaviour of single and plied elastomeric yarns by repeated application of tensile load between constant extension limits

    紡織品的檢驗.用恆定拉伸極限間的重復拉伸載荷測定單
  14. Testing of wood ; determination of ultimate shearing stress parallel to grain

    木材的檢驗.順纖維方向的極限剪切強度的測定
  15. Under the comprehensive research and generalization of digital image processing, we got the general procedure about digital image processing. based on the general procedure, following the agile method and extreme programming, applying the recursive procedure composed by require analyze 、 framework design 、 coding, finally we got a experimental 、 stable 、 opened score platform. we checked the theory by practice

    通過對數字圖像處理的全面研究和總結，得出數字圖像處理的一般過程，以此一般過程為基礎，按照敏捷思想和極限編程方法，通過需求分析，架構設計，編碼等幾個不斷迭代進行的階段，最終開發出一個具有實驗性質的、穩定的、開放的評估平臺，運用實踐來檢驗了理論。
  16. Correlative function method and variable function method are used to calculate the relevant range of soil layer. the limit capacity of bored pile is determined by the cone penetration tests ( cpt ) and the static loading tests and related statistics parameters are also evaluated. considering the effects of group piles, the action effect is calculated by the settlement of pile foundation and the reliability index of single pile as well as group piles is determined by monte - carlo method

    本文選擇臨近場地的四座高層建築地基的全部勘測資料，以沿深度方向的一維平穩高斯隨機場作為樁基土層土性參數的數學模型，利用相關函數法和變異函數法計算土層的相關范圍，由cpt和靜載試驗結果綜合確定鉆孔灌注樁的極限承載力，進而對相同場地各試樁的承載力進行折算后檢驗其概率分佈，並估計有關統計參數：考慮群樁效應確定樁基承載力，由樁基沉降反算其作用效應，由monte - carlo方法計算單樁及群樁的可靠指標。
  17. Inspection of tolerances of plain workpieces. limit gauges. general, definitions, control, use

    普通加工件的公差檢驗.極限規.總則定義控制和使用
  18. The project is completed in the collaboration of the transportation college of jilin university and transportation science institute in jilin province. the paper mainly studies the characteristics and mechanical performance of small size member of bridge, the problems of concrete dense degree and shear lag effect of wide flange. the static load test and supersonic nondestructive test of four pieces of prestressed i - girder with varying section are carried out in bridge structure laboratory of jilin university

    本文針對橋梁構件局部尺寸較小部位的混凝土密實度問題，進行了2片腹板寬度為14cm ， 2片腹板寬度為16cm的變截面預應力工字梁的靜載試驗和超聲無損檢測試驗，提出密實度系數的概念，對試驗梁的密實度進行定量評定，推導了工字梁的塑性系數公式，基於塑性理論給出了試驗梁的開裂荷載和極限承載能力計算公式，分析了試驗梁的密實度對其開裂荷載和極限承載能力的影響。
  19. Limit of detection and limit of decision for nuclear radiation measurements ; counting measurements with allowance for the influence of sample treatment and equipment used

    核輻射測量的檢測極限和判定極限.考慮試樣處理影響和
  20. Verification regulation of smooth limit gauge

    光滑極限量規檢定規程
分享友人
分享到 Line

分享到臉書