檢查閥 的英文怎麼說

中文拼音 [jiǎnzhā]
檢查閥 英文
inspection cock
  • : Ⅰ動詞1 (查) check up; inspect; examine 2 (約束; 檢點) restrain oneself; be careful in one s c...
  • : 查名詞1. [植物學] (山查) hawthorn; haw2. (姓氏) a surname
  • : 名詞1 (指在某方面有支配勢力的人物或家族) established house or power group; a powerful person or...
  • 檢查 : 1 (用心查看) check up; inspect; examine; censor; survey rummage; review; jerque; docimasia 2 (...
  1. Cleanup corrosive substance in pipe such as internal water, clean oil, methane hydrate, ferric oxide, carbide dust, carbon bisulfide, hydrosulphurice acide, etc. ; reduce corrosion damages to inner wall of pipeline caused by corrosive substance ; clarify pipe route again ; inspect pipe deformation ; check perfectness ratio of valves along pipe ; decrease working backpressure

    清除管線內部積水、輕質油、甲烷水合物、氧化鐵、碳化物粉塵、二硫化碳、氫硫酸等腐蝕性物質;降低腐蝕性物質對管道內壁的腐蝕損傷;重新明確管線走向;測管線變形;沿線門完好率;減小工作回壓。
  2. Inspect machined seat area for nicks and mineral build up clean with emery cloth

    機加工座區域是否有砂布清洗后留下的刻痕或礦物。
  3. When you install a new pcv valve, inspect and clean the system thoroughly.

    在安裝新PCV時,應仔細地和清洗PCV系統。
  4. There is no clutch, gearing, oil changes, smog check, pistons, rings, valves, crankshaft, flywheel, rods, wrist pins, etc., etc

    沒有離合器,傳動裝置,機油變化,尾氣,活塞,活塞環,門,曲軸,飛輪,連桿,肘節銷,等等。
  5. Examine and clean the air starting valves

    並清潔起動空氣
  6. Foreign matter may be lodged between disc ( 20 ) and seat ring ( 19 ). remove blind flange ( 24 ) to inspect

    外在物質可能淤積在瓣( 20 )和座環( 19 )之間。拆卸法蘭蓋( 24 )進行
  7. Inspect body bore and clean surfaces of any foreign material

    檢查閥體鏜孔,清洗表面上的任何外來雜質。
  8. The side entry design allows easy and quick in - line maintenance through the side cover with free access to the seat and disc for inspection or maintenance without disassembly of actuators

    側面入口結構使得在線維護變得容易迅速,通過側面蓋板可以或維護座和瓣,不需要拆卸執行機構。
  9. When inspection, maintenance, re - installation, should guarantee each jointing surface in the valve closely cooperate, descending and ascending of the discs are flexible

    維護重新安裝時,應保證內各接合面嚴密配合,盤升降靈活。
  10. Valves for water supply - fitness for purpose requirements and appropriate verification tests - part 6 : hydrants

    供水用門.適用性要求和專用試驗.第6部分:消防龍頭
  11. To clean : inspect or replace worn valve disc, disconnect control pipe and unscrew bonnet from valve body using blunt tool and hammer on bonnet lugs

    清洗:或更換磨損的瓣,斷開控制管道,用鈍工具和錘打蓋塞頂部,從體上旋下蓋。
  12. Before installation, check line of flow through valve so that valve will function properly

    在安裝前,流進門的管道,使得門能夠運轉自如。
  13. Inspect the disc rubber and clean or replace if required. the disc can be removed by screwing the white washer counterclockwise

    檢查閥瓣橡膠,如果需要,則進行清洗或更換。通過逆時針方向旋轉白色墊圈螺紋就可以拆卸瓣。
  14. Inspect rubber disc for dirt or debris

    橡膠瓣是否有污垢或堆積物。
  15. Inspect seat for nicks and replace as needed

    檢查閥座是否有劃痕,如果需要,則加以更換。
  16. Egc exhaust gas check valve

    排氣檢查閥
  17. Check the sealing parts and transmission parts thoroughly. detect he sealing parts and the detecting data should be registered

    門周期性維護時應全面檢查閥的各密封部位、傳動部位,對各密封部位進行測,對測數據應記錄在案。
  18. Check the sealing parts and transmission parts thoroughly. detect the sealing parts and the detecting data should be registered

    門周期性維護時應全面檢查閥的各密封部位、傳動部位,對各密封部位應進行測,對測數據應記錄在案。
  19. Add lubricant to the transmission parts regularly. check the sealing filler of the valve regularly. complement or change filler avoiding leakage of medium

    定期給的傳動部位加潤滑油。定期檢查閥的密封填料處,補充、更換填料以防介質外泄。
  20. Add lubricant to the transmission parts regularly. check the sealing filler of the vlave regularly. complemetn or change filler avoiding leakage of medium

    定期給門的傳動部位加潤滑油。定期檢查閥的密封填料處,補充、更換填料以防介質外泄。
分享友人