檢波器大線 的英文怎麼說

中文拼音 [jiǎnxiàn]
檢波器大線 英文
master cable
  • : Ⅰ動詞1 (查) check up; inspect; examine 2 (約束; 檢點) restrain oneself; be careful in one s c...
  • : Ⅰ名詞1 (波浪) wave 2 [物理學] (振動傳播的過程) wave 3 (意外變化) an unexpected turn of even...
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • : 名詞1 (用絲、棉、金屬等製成的細長的東西) thread; string; wire 2 [數學] (一個點任意移動所構成的...
  1. The specific research methods are listed : 1. matched filter taking the max ouput snr as the best rule correlates nonstop divided signal and divided echo to detect low snr target signal. then all one dimension divided correlation outs and done fft in portrait to leach interferential signal such as static or low rate mussy meaves, many pathway echo and so on and to take target ' s time difference and doppler frequency that combine parameters that target ' s direction taken from antenna and so on to implement target ' s orientation and tracking

    具體研究方法如下: 1 、採用以輸出信噪比最為準則的最佳匹配濾來對分段的參考和目標信號作相關處理來測低信噪比目標信號,然後對一維分段相關輸出組作縱向傅立葉變換來濾除靜態或低速的雜、多徑回等干擾信號,並提取目標的時差和多普勒頻率,再結合由天獲得的目標方向等參數,就可以實現目標的定位和跟蹤。
  2. A uhf sensor is designed and fabricated, which mostly consists of antenna, uhf amplifier, high pass filter, and broadband wave detector

    通過與華無電廠合作,研製了超高頻傳感,其主要由天、超高頻放、高通濾、寬帶等組成。
  3. Eddy - current sensor conversion circuit consist amplification circuit, band - pass filter circuit, demodulation circuit, differentiation phase and data sampling circuit. these circuits are used to convert the test signal of eddy - current sensor to discrete signal tend to process. the microprocessor system that formed of dsp chip is used to data fitting of test system, data displaying and data communicating with personal computer, etc. the interference questions of hardware design and the measure of eliminating interference signal in the subject are introduced in the last of this chapter

    硬體電路的設計主要分三部分來實現:激勵源電路部分,由分頻電路和頻率合成電路組成,產生頻率穩定的激勵信號以確保測任務的正常進行;傳感變換電路部分,由放電路、濾電路、電路、鑒相電路和數據採集電路組成,主要將電渦流傳感測到的信號變換成只含有被測信息的離散信號,易於后續電路處理;由dsp晶元構成的微處理系統,主要完成測系統的數據擬合、顯示及與主機通信等功能。
  4. In the paper, it is discussed to the winding of hydrophone array, the deviation and depth difference between focus and hydrophone array, and the deviation of time - distance curve, and presents a way to solve the problems

    本文針對排列彎曲、炮點偏移距小、炮點與不在同一深度以及時距曲偏移等問題進行了討論,並提出了校正和解決的方法。
  5. It can acquire the voltage on the test appliance and current in the circuit. and it can see these electrical signals as its input and calculates based on the data and gives the parameters and waveform that user needed. the parameters we can get through calculation include power factor, joule ' s integral, available value, maximal value, minimum value, time constant etc. recently, there are many scholar is studying the algorithm that calculate the parameter using test data, but many of them adopt the heuristic method, not using the test data directly

    本課題研製一套電試驗參數高速採集系統,能夠測試驗迴路中試品上的電壓信號和迴路中的電流信號,並根據這些電信號的數值利用計算機進行在計算,並給出用戶需要的各種電參數值和用戶需要的形圖,通過計算得到的電參數有功率因數、焦耳積分、有效值、最最小值、時間常數等。
  6. Firstly, the temperature varies in a large range in the place where the gap sensor works, so this paper analyzes the temperature drift of gap sensor, and finds out that the main reasons which result in temperature drift are the resistance of detecting coil and demodulating circuit parameters. to resolve this problem, a practical design of detecting coil is given, and a compensative measure considering the detecting coil and demodulation circuit is proposed to improve the temperature stability of gap sensor

    首先,針對間隙傳感工作環境溫度變化較的情況,本文對間隙傳感溫度漂移現象進行了分析,認為圈電阻和電路參數變化是造成傳感溫漂的主要原因,建立了圈的數學模型,提出了圈和電路綜合補償方法,解決了間隙傳感的輸出信號溫度穩定性的問題。
  7. Through observing the influence of different geometry to reflect wave in deep layer, using seismic digital simulation tracing method, analyzing the influence of max - offset, trace interval, fold and geophone planting to reflecting energy, this article, summarizes, in both theory and practice, the application result of " bin stack " acquisition method

    通過不同觀測系統對提高深層反射信號的影響,採用地震數值模擬射追蹤方法,分析了觀測系統中最距、道距、覆蓋次數及埋置,對提高深層反射信號能量的影響,從理論到實踐總結了「面元疊加」採集技術的應用效果。
  8. In order to ensure the real - time monitor this design choose special dsp chip and high - efficiency a / d transfer chip, the former ensure the time is enough to complete the calculation. tests proved that this equipment can satisfy the requirement of international standards about harmonic detection

    論文提出了基於dsp的電能質量在測最小測量系統的設計方案。論證了用於電能質量測系統的a / d轉換的位數應於等於16位,才有可能使各次諧測精度達到小於1 %的相對誤差。
  9. Our item choiced msp430f149, a sort of singlechip as controller, designed our hardware electrocircuit to get the pulse wave singnal, and used msp430f149 to continuously search and calculate the peak - peak value of the pulse wave, and compute oxygen saturaction. in our study, in order to hurdle the dirft of baseline caused by the physiological difference of human bodies. we designed one circuit which can automatically regulate of the baseline of signal

    本文以msp430f149晶元為控制,設計硬體電路提取脈搏信號,連續測脈搏峰?峰值,計算氧飽合度。本課題採用了基自動調節電路,以克服不同人體生理差異引起的基漂移;設計了直流截取電路和可控積分放電路,以滿足臨床連續監測的特殊需要,解決信號飽和問題。
  10. Eddy - current sensor test technology is a kind of very popular untouched nondestructive test technology developed in last decades, which makes up five major modern nondestructive test technologies together with magnetic particle test, radial test, ultrasonic test and osmosis test

    電渦流傳感測技術是近年來應用較廣泛的一種無損測方法,它同磁粉測、超聲測、射測和滲透測統稱為五無損測技術。
  11. The linear scale before and after log is an effective way to inspect the reality and accuracy of the log curves, such as downhole signal ' s amplitude limit or not and serious distortion, the variable density logging tool ' s signal linear amplification and working stability

    測前、測后性刻度對分析、判定變密度測井曲的真實性與準確性體現在對井下列的限幅與畸變程度、測儀性放狀態和穩定程度。
  12. In this thesis some nonlinear color - scale morphological filter are designed to filter some noised color images and detect the color edge of image based on max lift decomposition scheme. and the performance index is presented, which implies that the new color - scale morphological filter has better performance

    在本論文中,我們基於最提升格構造出非性彩色形態濾,並對一些受污染的彩色噪聲圖像進行濾和進行一些彩色圖像邊緣測的工作,所構造出來的彩色形態濾其具有較好的濾效果。
  13. In the blue print of the digital, make sure of the logarithmic amplifier, a / d / a converter and fpga realize the if amplifier, big dynamic range agc, detect and video process same as that in the blue print of the analog

    在數字方案中,筆者結合軟體無電技術,通過使用對數放、 a / d / a轉換以及fpga軟體實現了同樣的中頻放動態范圍的agc控制、以及、視頻信號處理等功能。
  14. This paper utilizes masking rate theory to analyze the variation of center zero - level energy, the influence of metallic mesh ’ s different parameters on infrared transmitting ; deduces the relational expression between infrared transmitting efficiency and metallic mesh ’ s parameters ; comes to the conclusion that we can improve infrared transmitting efficiency by increasing

    理論研究表明,金屬網柵的周期選擇在200 ~ 400 m之間,寬不於10 m ,是較為理想的網柵參數。最後,在實驗室里用1 ~ 20ghz的信號發生、功率放和頻譜分析儀等雷達測設備,對金屬網柵的屏蔽效率進行測試。
  15. Conventional detectors, for example, inductive loop, detectors using ultrasonic, microwave, or infrared, have been put into use for several decades. meanwhile, a promising approach, video - based measurement system, has developed quickly. since it has many advantages, for instance, wider - area detection and superior flexibility, many researches have been done in this area

    交通流有電磁感應圈、超聲、微和紅外光標等多種方式,而基於圖像處理的視頻測方式近年發展很快,因為它具有區域測、設置靈活等優越性,已成為智能交通系統的一個研究熱點。
  16. Presents the simple but highly reliable on - line detection of ultrasonic transducer clamping capacitance based on the impedance circuit model constructed through the impedance characteristics of the ultrasonic transducer under triple harmonics, and concludes from experimental results that this method can be used to effectively detect the variation of clamping capacitance while the transducer is operating, and the matching inductance can be dynamically regulated according to the results of detection, and dynamic matching can therefore be achieved in the real sense at the end of the transducer to improve the overall performance of the whole system

    為了解決功率超聲應用的換能電端匹配問題,分析了超聲換能在諧振頻率三次諧下的阻抗特性,給出了超聲換能三次諧下的阻抗電路模型.並根據阻抗電路模型建立了對超聲換能的夾持電容實現在測簡單、可靠性高的方法,實驗證明該方法有效的.該方法可以在換能工作過程中隨時測夾持電容的變化,根據測結果對匹配電感進行動態調整,實現真正意義上的換能電端的動態匹配,從而改善匹配質量,提高系統的工作性能
  17. The list betterments aimed at the properties of system : through the testing of dc voltage, pulse width and inverting voltage and frequency can be regulated online to fit for different steady load ; reducing speed ripples by compensating with nonzero voltage working proportional time ; adopting the technology of harmonics suppression. as a result, the high precision and wide speed control is realized and the step out is overcome

    針對系統的性能指標,做了如下改進:對直流側電壓的測,在調整逆變導通脈寬、輸出電壓和頻率,可以適應不同小的恆負載;並用非零電壓矢量作用時間進行補償的方法,減小電機的低速脈動;加入了諧抑制技術等。
  18. The apfs using according detection method are investigated and developed by simulating and experimenting to demonstrate the performance of the proposed detection method and apf. secondly, a nonlinear, large signal control theory - one cycle control, which was presented in the 90 ' s and suitable especially for switch power converter , was investigated. the integration reset control and extension applications , which was < wp = 7 > developed based on one cycle control theory, was emphatically studied

    本文深入分析了90年代初發展起來的一種適合開關變換信號非性控制理論? ?單周控制( onecyclecontrol )理論,以及在此理論基礎上發展起來的常頻積分復位控制技術和它的最新應用,首次成功地將單周控制理論應用於apf的測和控制中,提出並實現了一種通用常頻積分復位控制有源電力濾,從而簡化了apf的工作原理和結構。
分享友人