檢測器探頭 的英文怎麼說

中文拼音 [jiǎncèqìtàntóu]
檢測器探頭 英文
detector probe
  • 檢 : Ⅰ動詞1 （查） check up; inspect; examine 2 （約束; 檢點） restrain oneself; be careful in one s c...
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 探 : Ⅰ動詞1 （試圖發現） try to find out; explore; sound 2 （看望） call on; visit; see 3 （向前伸出）...
  • 檢測器 : detector
  • 檢測 : check; detection; test; gauging; detecting; sensing; [工業] checkout; measuring
  • 探頭 : probe; detector; searching unit
  1. Ultrasonics. hand - held probe doppler foetal heartbeat detectors. performance requirements and methods of measurement and reporting

    超聲波學.手持探頭式多普勒胎兒心音檢測器.性能要求和測量及報告方法
  2. The probe ' s linearity, temperature and dynamic characteristics are analyzed base on principal theory of eddy - current displacement sensor, such as the influence of the coil q value to the linearity characteristic, influence of the diameter of coil to the linearity characteristic, influence of coil resistance to the temperature characteristic, influence of the measuring coil to the syntony loop

    在介紹渦流位移傳感器的基本理論的基礎上，分析了傳感器探頭線性特性、溫度特性、動態特性的影響因素。從探頭線圈q值對線性特性的影響；探頭直徑對線性的影響；探頭線圈電阻對溫度特性的影響；激勵信號溫度特性的影響：檢測線圈?振迴路動態響應特性等方面分析並提出製作高質量傳感器探頭的改進措施。
  3. 3 in experiment the common electrical - resistance strain gages is used as receiver to replace the pzt or velocity and acceleration transducer which is frequently used in pipeline not

    3 、實驗採用動態電阻應變電測法，採用普通的電阻應變片作為接收傳感器，代替了通常用於管道檢測的壓電探頭或樁基完整性檢測的反射波法中使用的速度傳感器或加速度傳感器。
  4. In principle, ultrasonic sensors are suspended over a road, which keep emitting pulse signals periodically to nearby and feed back waves to decide existence of any obstacles, thus to detect the speed, height, length, different sizes ( heavy, medium and small ) of moving vehicles and accumulative flow as well as length of motorcade. optionally, it can be applied to multitude driving lanes simultaneously for traffic data. by integrating and analyzing these measured data, the necessary figures concerning traffic flow may be obtained, which are fundamental basis guiding road buildings

    本課題設計的是一種懸掛式超聲波車流多信息檢測器，通過懸掛于路面上方的超聲波探頭向路面周期性地發射脈沖信號，利用地面回波來判斷遮擋物地存在，可用於檢測行駛中的機動車車速、車高、車長、大中小分型以及累計車流量、車隊長度等信息，並可用於多個車道車流信息的同時檢測，綜合這些測量參數可獲得車流量的必要數據，可為公路建設提供必要的基礎依據。
  5. Travel time is the key point of system, its measure quality decides the survey precision of the stress. time to digital convertor ( tdc ) was applied to accomplish the precision time interval measurement. at the same time, one transmitter - two receivers probe arrangement and zero - crossing detecting method were also applied to reduce the errors in measurement

    傳播聲時是整個測量系統中的關鍵量，其測量水平決定應力的測量精度，對此本文採用時間-數字轉換器（ timetodigitalconvertor ， tdc ）完成高精度時間間隔測量，在實現過程中又分別採用「單端發射-雙端接收」的探頭布局模式和「過零檢測」手段來降低系統檢測誤差。
  6. Although there are many literatures describing ultrasonic detector for traffic flows, none of the same category has referred the techniques applied in the design herein such as multi - sensor construction, automatically establishing datum line regardless of suspension height, digital filtering and multi - lane detection as well as measuring length of motorcade

    目前有關超聲波車流檢測器的文獻較多，但本設計中採用的多探頭結構、自動標定超聲波探頭的架設高度、數據濾波以及多車道測量和檢測車隊長度等技術在同類設計中未見使用。
  7. Secondly, the wavelength of light source and the distance between the source and detector, two key parameters in reflectance sensor design, are determined according to theory in light transmitting and experiments in lab. thus the sensitivity and dependability in reflectance monitoring is improved as much as possible

    本文接下來討論了反射式血氧探頭中兩個重要參數? ?光源波長的選擇和光源與接收器之間距離的確定，以保證在反射檢測中能獲得最高的血氧測量靈敏度和可靠性。
  8. The main performances of the afm were in the advanced level around the world. the probe unit of the horizontal afm includes a photo - electronic detection unit with a particular optical - beam - deflection path, a regulating block of the setpoint of imaging force, the xy scanner and z feedback controller, the coarse adjusting and fine adjusting mechanism for the sample approaching to the probe tip. the powerful circuits of preamplifier, as well as the circuits of xy scanner and z feedback controller were developed

    成功研製了臥式afm探頭，包括特有的微懸臂偏轉量的臥式光電檢測系統、 afm成像工作點（即原子力的預設置點）的調節機構、 jy }藝掃描與反饋控制器、樣品的粗調與微調機構;自行研製了高性能的psd前置放大電路、 xy掃描控制電路和z向pid反饋控制電路系統;設計了a / d & d / a控制介面，獨立開發了性能完善的afm掃描與控制軟體系統及功能強大的圖像處理軟體系統。
  9. Secondly, methods of improving on probe are investigated in detail : using the electromagnetic shielding effect to decay the direct - coupled magnetic field and using the dual probe to control the energy flow, so as to make the probe to be shorter ; designing 3 - d pick - up coil array to increase detection sensitivity. at last, experiment system is set up to verify the simulation result and the comparing result shows simulation result agrees with experiment result

    其次，對改進傳感器性能的幾種方法進行了詳細研究:利用電磁屏蔽效應以衰減在直接路徑上的磁場傳播、採用復式探頭激勵方式以實現能流控制，從而減小傳感器體積，模擬證實這兩種改進方案有效;設計三維周向檢測線圈陣列以提高缺陷檢測靈敏度，模擬結果證實三維探頭的周向靈敏性。
  10. This kind of alarming device makes use of heat - releasing infrared transducer, which can discern the special infrared rays of the human body and transform them to electrical signals, then send the signals to single chip

    利用熱釋電紅外傳感器作為探頭，進行非接觸式遠距離檢測，將感測到的紅外信息轉換成電壓信號，經過單片機處理，完成數碼顯示和語音報警功能，從而實現了防盜報警功能，達到了安全防護的目的。
  11. The method of visual testing of the steel tube ends is an unresolved problem in petrol industry, chemical industry, pressure vessel industry and oil and gas transporting project. i discuss the visual method and system of the steel tube ends based on the magnetic flux leakage theory, design a visual testing system of steel tube ends that makes the undetected areas testing of the steel tube ends possible

    鋼管端頭可視化檢測一直是石油行業、化工行業、壓力容器行業和油氣高壓遠距離輸送工程著力解決的課題，本文根據漏磁檢測方法對「鋼管端頭可視化檢測方法與系統」做了探討，設計了一個基於漏磁檢測原理的鋼管端頭可視化檢測系統，從而使鋼管端頭的無盲區檢測成為可能。
  12. The multiunit floating sensor with wide detecting range is assembled as testing sensor so as to realize centralizing adjustment of tubings with different sizes

    檢測傳感器採用多單元浮動式傳感器，結合較大游動范圍的探頭張合結構，解決了在傳動線上因油管中心不等高難以實現檢測跟蹤的問題。
  13. Take the laser diode as the photoelectric detector ' s lamp - house, the optical system forms images of the sign, the double photoconductive resistance detects the excursion of the sign, a / d converter finishes a / d convert, the data is fuzzy processed by micro computer

    光電探頭採用激光二極體作為光源，光學系統完成標志的成像，雙光敏電阻檢測標志線的偏移， a / d轉換器完成偏移信號的模數轉換，數據由微機進行模糊處理。
  14. Some methods for overcoming these disadvantages are investigated as follows : first, using shield and magnetic circuit to shorten the sensor length and enhance the signal magnitude ; second, improving the data acquisition system to intensify the capability of fine defect detection ; at last, adopting digital signal processing technology such as homomorphic filter, wavelet transform and error correction to ensure detecting reliability

    本文結合有限元模擬和實驗方法，研究了改進遠場渦流技術性能的幾種方法，即：採用電磁屏蔽、磁路進行傳感器優化設計以縮短探頭長度、增大信號強度；改進信號調理電路以提高細微缺陷檢出能力；利用同態濾波、小波變換以及誤差修正等數字信號處理技術確保檢測結果的可靠性。
  15. Ultrasonic testing of the plates, pipes and tubings, forgings, bolts, welds and overlaid claddings used for pressure vessels was introduced, including probe selection, scanning mode, defect discrimination and quality classification

    摘要簡述了壓力容器用板、管、鍛件、螺栓、焊縫和堆焊層的超聲檢測，詳細介紹了每種檢測方法的探頭選用、掃查方式、缺陷判別和質量等級評定等。
  16. Finds wide application in such fields as pharmaceticals, pesticide and has been already marketing to america, europe and southeast asian countries. guangzhou xianghua info tech co., ltd. pays great emphasis over the innovation of technology and protection of the green enviroment and it is closely tied with several universities and research institute, witch enhances greatly the innovation capabilitiy of new product development. because of the advanced manufacturing processing and techniques, and techniques, and stability of the quality, changzhou kaiyuan chemicals co. ltd

    Xh系列金屬探測門安檢門tc tm系列金屬探測器avenir etoku日本精工鏡頭panasonic松下全系列監控產品vidonet維迪耐特全系列監控產品lcd tv主板和外殼led屏觸摸屏信息查詢和控制系統城市交通信息系統多媒體控制系統音視頻切換設備等等
分享友人
分享到 Line

分享到臉書