檢測電路 的英文怎麼說

中文拼音 [jiǎncèdiànlù]
檢測電路 英文
circuitry detection
  • 檢 : Ⅰ動詞1 （查） check up; inspect; examine 2 （約束; 檢點） restrain oneself; be careful in one s c...
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 檢測 : check; detection; test; gauging; detecting; sensing; [工業] checkout; measuring
  • 電路 : [訊] circuit （ckt）; electric circuit; electrocircuit電路板 circuit board; 電路保持 guard of a c...
  1. The design of detection circuit for dna biosensor

    生物傳感器檢測電路的設計
  2. Mems ( micro electromechanical system ) has become one of the most rapidly development technologies. along with the rapid development of mems techniques, capacitive sensor is used widely whose capacitance changes small, which has put forward the new request to the measurement technique. the common measure for capacitance measurement is that convert capacitance to voltage, electric current or frequency. the area of polar plate of the capacitor becomes smaller and smaller, and the total capacitance of micro capacitive sensor is usually several pico farad only. as a result, its change amount is smaller

    Mems （ microelectromechanicalsystem ）近年來發展最快的技術之一，隨著mems技術的快速發展，電容式加速度計的電容變化變化量越來越小，對檢測技術提出了新的要求。在電容式傳感器中，常用電容檢測電路是將其轉換為電壓、電流或者頻率信號。目前的微型電容傳感器的極板面積變得越來越小，電容總量只有幾個pf ，變化量就更小。
  3. Immersion - detection circuit - interrupters

    浸漬式檢測電路斷流器
  4. At the same time, the parameter monitoring circuit is designed to check the operational parameters of pharos that include voltage of power supply, operational current, based on lm339 voltage comparer, optical sensor and logical circuit

    以lm339電壓比較器為核心，結合光傳感器、邏輯電路等，設計出參數檢測電路，監測航標燈的電源電壓、工作電流等工作參數。
  5. Based on the character of ultrasonic spectrum analysis, considering the affection of the circuit responsion of checking system, coupling state, position of checking transducer, this thesis established reasonable ultrasonic spectrum analysis method. using this method, several kinds of linear spectrum ( such as phase amplitude spectrum, phase power spectrum ) were researched and discussed

    本文根據超聲波頻譜分析的特點，綜合考慮了檢測電路響應、耦合狀況、探頭位置等因素的影響，制定出了一套合理的超聲波頻譜分析方法，並用此方法對幾種線性譜（如相位幅度譜、相位功率譜等）進行了研究和探討。
  6. Zero - cross circuit makes sure output synchronism signals drive silicon control

    過零檢測電路保證了輸出信號零點同步驅動可控硅，降低電源污染。
  7. Accelerometer is used widely for measuring acceleration in civil and military field. at present, there are several type of accelerometers such as piezoelectricity electric charge accelerometer, ic piezoelectricity electric accelerometer, compressive resistance accelerometer and alteration capacitance accelerometer. the main part in alteration capacitance accelerometer is capacitance measurement circuit. foreign countries have produced accelerometer that have tiny volume and high performance. however, our country is not able to produce such accelerometer due to the lack of technique

    加速度計作為一種測量加速度的儀器，在民用、軍用領域都有廣泛的應用。目前市場上的加速度計主要有壓電式電荷加速度計、集成電路式壓電加速度計、壓阻式加速度計、變電容式加速度計等幾種類型的加速度計。變電容式加速度計的設計中一個重要的環節就是電容檢測電路的設計。
  8. The bias magnetic field of the bias coil driven by bias current and small signal test current, results in the induced signal of the control coil. the terminal voltage of the control coil is detected by the test circuit. then the signal containing the information of rotor displacement is obtained, from which we can get the dc voltage signal proportional to the rotor displacement through half - wave rectification circuit and low pass circuit. this dc signal is put into a pid controller to get the control signal of the rotor displacement

    偏置測試電路向偏置線圈輸入偏置電流和小信號測試電流，兩者產生的偏置磁場在控制線圈產生感應信號，檢測電路檢測控制線圈端電壓並提取含有轉子位移信息的電壓信號，該信號經半波整流電路和低通濾波電路后得到與轉子位移成正比例的直流信號，再由pid控制器轉換為轉子位移的控制信號，最後控制信號輸入功放電路產生控制電流，實現閉環控制。
  9. The reactive power compensation is an important engineering in the power system. the active reactive power compensator designed in this text takes the instantaneous reactive power theory of three - phase as foundation, and is formed by the reactive current testing circuit, current tracking control circuit and the main circuit, and among them the current tracking control circuit is formed by instruction current arithmetic circuit, current polarity checkout circuit and current tracking control logic circuit three parts in the circuit form

    無功功率補償是電力系統中的一項重要工程，本文所設計的有源無功功率補償器是以三相瞬時無功功率理論為基礎的，它由無功電流檢測電路、電流跟蹤控制電路和主電路三大部分組成，其中電流跟蹤控制電路由指令電流運算電路、電流極性檢測電路和電流跟蹤控制邏輯電路三部分構成。
  10. Design a kind of detection circuit for vector signal

    一種矢量信號檢測電路設計
  11. The effect of the hardware system is ensured through the reasonable designation of a band - pass filter coefficient, and several simulations and experiments for this detecting circuit

    通過合理設計帶通濾波器參數，並在對檢測電路的模擬和多次實驗的基礎上，實現了心電信號的有效檢測。
  12. Assisted with the sensitivity of the linear analog circuits, the feasibility of parametric faults detection was analyzed through the maximum fault errors acquired at the sensitive frequencies, a stimulation matrix and its stimulation expression were put forward on the test points information

    摘要從線性模擬電路靈敏度的概念入手，分析了通過獲取敏感頻點激勵下的最大故障誤差來檢測電路參數故障的可能性，提出了一種針對測試頻率和測點信息的激勵矩陣。
  13. Among them, the action of the reactive current testing circuit is testing the reactive current component in the compensated object current

    其中，無功電流檢測電路的作用是檢測出補償對象電流中的無功電流分量。
  14. According to step - response experiment, math model of the hotplate was set up and the temperature of controlling system including temperature detection circuit, pd controller, voltage pulse - wide transforming circuit and executor was designed

    以階躍響應實驗為基礎，初步建立起控制系統的數學模型，設計了適用於該電熱板的閉環溫度控制系統。系統主要包括溫度檢測電路、 pd控制器、電壓-脈寬變換電路及執行元件。
  15. This digital pattern generator composes of eight parts : interface circuit unit, dual - port sram unit, dsp unit, dac unit, expose / mark signal detection control unit, mark signal diction unit and final expose shape registers unit

    本論文中的新型圖形發生器由介面電路、雙埠存儲電路、數字信號處理電路、數模轉換電路、曝光標記檢測控制電路、標記檢測電路、最終曝光數據寄存器單元和束閘控制電路構成。
  16. For above problems, i design boole process - based algorithm. for example, hazards finding theory work out a formal method of finding hazards by waveforms computing ; waveforms increasing algorithm settle the defect of boole process in feedback cycle treatment ; false paths discerning algorithm can delete useless nodes in netlist effectively ; inertia conflict eliminating method describes the state of nodes truelier and reduces computing

    其中，冒險檢測定理給出了通過波形運算檢測電路中冒險現象的哈爾濱工程大學碩士學位論文形式化方法;波形遞增演算法解決了boole過程在處理電路中反饋環問題上的缺陷;偽路徑識別演算法能夠有效地去除電路網表中的無用節點;而慣性沖突消除法能使對節點狀態的描述更加真實，並減少了計算量。
  17. The false alarm is a fault indicated by bit or other monitoring circuitry where no fault exists

    虛警是機內測試或其它檢測電路指示有故障而實際上不存在故障的現象。
  18. The vital part of the design is the control system, including under - voltage checking circuit, over - current checking circuit, circuit for producing signals of mistakes, and circuit of resetting wrong signals

    主要工作是設計驅動電路的控制部分，包括:欠壓檢測電路、過流檢測電路、出錯信號產生電路和錯誤信號清零電路。
  19. The chapter of hardware design first expounds the whole design. the several primary circuit are designed, including power circuit, controlling circuit, detecting circuit and the dsp quadrature encode circuit

    硬體部分先作了整體設計的論述，然後具體介紹了功率電路、控制電路、檢測電路以及dsp的正交解碼電路。
  20. Simultaneouslydesigned one has planted the zero examination electric circuit, transformed the pid control increase cheng zhankong compared to, andoutput with the digital circuit has certainly occupies emptiescompared to the rectangular wave, achieved the quite accurateexamination effect

    同時設計了一種過零檢測電路，將pid控制增量轉換成占空比、並用數字電路輸出有一定占空比的矩形波，以達到比較準確檢測效果。
分享友人
分享到 Line

分享到臉書