正常工作電壓 的英文怎麼說

中文拼音 [zhēngchánggōngzuòdiànyā]
正常工作電壓 英文
normal working voltage
  • 正 : 正名詞（正月） the first month of the lunar year; the first moon
  • 工 : Ⅰ名詞1 （工人和工人階級） worker; workman; the working class 2 （工作; 生產勞動） work; labour 3 ...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 壓 : 壓構詞成分。
  • 正常 : normal; regular; average
  • 電壓 : voltage; electric tension; electric voltage
  1. Utilize the principle of wavelength 1 / 4, when there is high pressure to interfere, the lightning conductor will hold up automatically ( discharge ), the normal work of the system

    利用1 / 4波長原理，當有高壓干擾時，避雷器會自動短路（放電） ，系統正常工作。
  2. The second, at the high frequency primary coil, when switch turn on with control signal ( the spwm pulse is modulated ), in the positive or negative semi - period of low frequency modulation signal, transformer coil with same direction voltage. the magnetic flux of transformer core will increase step by step. at the end, it leads to magnetic flux saturation

    二、在高頻變壓器原邊，當開關管接收控制信號脈沖列（經調制的spwm波列）導通時，在低頻調制信號的正半周或負半周內，施加在變壓器繞組上的是同一方向的電壓，變壓器磁芯中的磁通可能將級進地逐漸增加，導致磁芯飽和，造成磁偏或單向磁化，導致低頻電信號放大失真或由於很大的磁化電流而無法正常工作。
  3. With the development of modern industry, the nonlinear loads of power system are greatly increased. they absorb the non - sine current waves from power network and result in voltage aberrance. voltage aberrance makes the power quality severely deteriorate, endangers the safe and economical running of power system and affects some users ’ s normal work

    隨著現代工業的發展，電力系統中的非線性負荷大量增加，這些非線性負荷從電網吸收非正弦電流，導致電網電壓發生畸變，使電能質量嚴重惡化，危及電力系統安全和經濟運行，影響了用戶的正常工作。
  4. As the electric power & electronic technology is used widely in low voltage area, the properties of voltage and current in normal working conditions of electrical appliance closely resemble or mimic the un - normal properties created by the arc fault, so it is difficult to distinguish between normal and un - normal cases

    隨著電力電子技術在低壓領域的廣泛應用，一些電器正常工作時的電壓電流特性與故障電弧的典型特性相似，給檢測工作帶來了難度。
  5. Characteristic : the machine possesses the features such as simple structure, low noise, wide range of normal working temperature and normal voltage, firmly, and cheap price as well

    特點：該機具有結構簡單，噪音低，正常工作溫度和正常電壓范圍廣，堅固耐用，且成本低廉。
  6. It works at high frequency with a selectable pin outside ; the working frequency is fixed at 640k / 1. 2mhz. so far as the output signal of the single - chip ic is concerned, the maximum time proportion of its high level is 88 percent, but the minimum one is 10 percent

    該控制器為pwm脈沖寬度調制方式;電路正常工作溫度范圍為- 20oc 85oc ;工作開關頻率根據外圍電路輸出電壓需要為640k / 1 . 2mhz可選;輸出信號的最大占空比為90 % ，最小占空比為10 % ，晶元主要應用於lcd電壓電源管理設備。
  7. This is the maximum current that can flow safely into an input terminal of the device at voltages above or below the normal operating range

    在器件電壓高於或低於正常工作電壓原范圍內，可以安全地流入器件輸入端的最大電流。
  8. To make the system work normally, 12 volts " positive voltage is converted into 5 volts and 6 volts by power supply unit, in which 5 volts is provided for digital circuit and 6 volts is provided for analogue circuit

    為使裝置正常工作，電源電路將+ 12v電壓變換后，給裝置中數字電路提供+ 5v電源電壓，給模擬電路提供6v電源電壓。
  9. The machine works abnormally when power on the working voltage below 220v

    電源工作電壓低於220v導致不能正常工作
  10. Very large scale integration systems, 2004, 12 : 235 - 244. 7 mathew s k et al. sub - 500 - ps 64 - b alus in 0. 18 - mum soi bulk cmos : design and scaling trends

    而且在動態邏輯門中增加了一定范圍的電荷保持器，使系統在最壞情況下仍能正常工作，同時可承受一定的電源電壓和溫度變化。
  11. Software design includes voltage setting, capacitors monitoring. working status judging. fourth, the serial communication between plc and computer has been completed with using the software mcgs ( monitor and control generated system )

    軟體方面，在硬體設計的基礎上編制出滿足控制要求的程序，實現了監視狀態下工作電壓設定、電容狀態自動監測等功能，系統可根據電容狀態來判斷工作是否正常。
  12. The dc regulated power supply provides steady voltage to signal circuit, driving circuit, relay safeguard circuit and so on

    直流穩壓源用於對實驗單元中的信號產生電路、驅動電路以及繼電操作和保護電路提供恆壓電源，使得這些電路能夠正常工作。
  13. The ml converter splits voltage constraints among series - connected switches through the flying capacitors, so keeping the flying capacitor voltages at proper value is very important

    該變換器利用飛跨電容使得輸入電壓在串聯的各開關管之間均分，以降低開關管的電壓應力，因此飛跨電容電壓保持在適當值是保證變換器正常工作且具有良好性能的關鍵。
  14. Starting current the meter can work corectly at rated voltage, rated frequency. when load currdnt is large then 0. 4 ib. power facotor : 1. running with no - load the meter use logic circuit to anti - creep

    啟動電流：在額定電壓額定頻率功率因數為1的條件下，當負載電流大於0 . 4 ib時電度表都能正常工作。
  15. At first, it describes structure of the full - length prototype, manufacturing craft and prepare to work, including sting, sealing, wire tension and leak current measurement, mounting of the preamp, gas system, high voltage system, reduction of noise and so on. the construction of full - length prototype provided valuable experience and important reference to the besiii drift chamber. then good function of the full - length prototype was performed using 55fe 5. 9kev x _ ray source. we can see that the uniformity of gas gain of the full - length prototype is well and it is effective for the compensation voltage to adjust the uniformity of gas gain of the boundary cells

    為了初步測試模型的性能用55fe5 . 9kevx射線進行了氣體增益的均勻性檢測，隨之用55fe5 . 5kevx射線初步測試了模型性能，對部分高壓和補償電壓的設置進行了調整，驗證了對邊界場絲層加補償電壓能夠有效地調節邊緣層氣體增益的均勻性，實驗結果表明全長模型能正常工作並具有良好的性能。
  16. Although the structures of these modules are simple, they can work properly and efficiently in a wide range of ambient temperatures and supply voltage variations

    模擬結果表明，本文設計的電源電路類ip核結構簡單，穩定性好，能夠在比較大的電源電壓和環境溫度變化范圍內正常工作，具有一定的先進性和實用性。
  17. Although the structures of these modules are simple, they can work properly and efficiently in a wide range of ambient temperatures and supply voltage variations. because of these characteristics, the ip cores can be easily reused in smart power control ic design and soc design

    模擬結果表明，本文設計的智能電源電路類ip核結構簡單，穩定性好，能夠在比較大的電源電壓和環境溫度變化范圍內正常工作，具有一定的先進性和實用性。
  18. The character of threshold voltage in vlsi circuit is analyzed. it can make a serious effect on power dissipation and performance. an algorithm based on partition is designed to choose the most favorable working voltage and threshold

    在低電壓電路中，既要使電路實現正常的開關，又必須限制延時和亞閾值漏電流的急劇增加，就必須認真地選擇工作電壓和閾值電壓。
  19. By using the correction approach of vary - transfer function for designing parameter of closed - loop in the area of power electronics, the system could work reliably under wide range input voltage conditions. compared with the design method of closed - loop parameter, the advantages of the correction approach of vary - transfer function were highlighted and testified by simulation and experimental results

    為了使系統能夠在寬電壓輸入范圍內穩定正常工作，本文實現了提出的變傳遞函數系統校正方法在電力電子閉環參數設計中的應用，並與閉環參數設計方法進行了比較，指出了該方法的優點，並通過模擬和實驗驗證了該方法的正確性。
  20. This is the maximum continuous sinusoidal rms voltage, which maybe applied at any temperature upto the maximum operating temperature of the device

    在規定的環境條件下，保證壓敏電阻器正常工作所允許連續施加的最大交流電壓值。
分享友人
分享到 Line

分享到臉書