正火溫度 的英文怎麼說

中文拼音 [zhēnghuǒwēndù]
正火溫度 英文
normalizing temperature
  • 正 : 正名詞（正月） the first month of the lunar year; the first moon
  • 火 : fire
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 溫度 : [物理學] temperature
  1. This paper analyzes the cause of small concaves around the welding seam in the long rail of guangzhou metro line 2, and presents preventive measures, such as increasing the under layer of the rail, limiting the weld seam, lowering the welding temperature etc

    摘要結合廣州地鐵2號線接觸焊焊接長鋼軌的實踐，分析了產生焊頭表面小凹痕的原因，提出改變墊高鋼軌的方式、縮小正火范圍、降低正火溫度、限制接頭錯牙量等預防措施。
  2. Thus, during a normal light-up there is a blade temperature charge of about 30 degrees/sec.

    於是，在正常點火時，葉片溫度的變化率約為30度秒。
  3. The principle of multi - method and multi - parameter is suggested, which should be followed during characterizing microstructures of alloy steels by ultrasonic not method. ultrasonic velocity ( c, ) of transformation products through different heat processes of three steels was measured by high - accuracy ultrasonic installation. the velocity of quenched microstructure of 38crmoal is the lowest, which gradually increases with increasing tempering temperature between 200 ? and 650 ? after quenching process

    利用ti - 40n高精度超聲波測厚儀，研究了超聲波在不同鋼種、不同熱處理轉變產物中的超聲波速度c _ 1 : 38crmoal鋼淬火組織c _ 1最小，淬火后在200 650范圍內進行回火處理時，隨回火溫度的升高， c _ 1逐漸升高， hrc與c _ 1之間具有較好的相關性；正火組織的c _ 1介於淬火后中溫回火及高溫回火產物組織的c _ 1之間。
  4. With the combination of automatic control theory and practical thermal process automation object in the power station, three main fields including nonlinear calibration of thermal instrument, new control strategies of main steam pressure and advanced control strategies of main steam temperature are studied in detail in this paper

    本文將自動控制理論和火電廠熱工自動化的具體對象相結合，進行了3個方面的研究工作：熱工儀表非線性校正、主蒸汽壓力的新型調節策略、主蒸汽溫度的先進控制策略。
  5. These results show that since the existent defects of combustion device structure and its hypothetical circle of contact, these make a poor primary and secondary wind rigidity in operation and a too big actual circle of contact. in addition, the coal used is extreme prone to burn and reside in boiler. under such a condition, the coal powder ignites earlier in a short time and short distance when it leave the jet - combustioning device, and splashes the water cooler, eventually this results in a burned coal residue in boiler

    針對宏偉熱電廠410t / h燃煤鍋爐嚴重結渣問題，對燃煤的結渣性、爐內溫度工況及空氣動力工況等進行實驗研究，由於燃燒器結構和假想切圓選擇的缺陷，使得鍋爐在正常運行時，一、二次風剛性較差，實際切圓過大，加上目前燃用煤質屬于極易燃、易結渣煤質，致使煤粉在離開噴燃器很短的時間、較短的距離內開始著火，並沖刷水冷壁，最終造成爐膛結渣。
  6. In order to improve measurement precision and display fidelity of the instrument, three new methods of nonlinear calibration of thermal instruments, which are based on intelligent control theory, are presented in this paper, such as nonlinear compensation of zr02 oxygen measurement instrument using bp nn, nonlinear calibration of temperature measurement sensors using cmac nn and nonlinear identification of throttle flow meter using ga. these methods prove to be not only simple but also effective

    火電廠熱工儀表普遍存在非線性特性，為了提高參數測量的準確度和儀表顯示的精確度，基於智能控制理論，文中提出了熱工儀表非線性校正的新方法： bp神經網路補償氧化鋯氧量計非線性特性的方法、 cmac神經網路校正測溫傳感器非線性特性的方法、遺傳演算法辯識節流式流量儀表非線性特性的方法。
  7. The difference among the elasticity modulus of various microstructures is probably the main reason, which caused the experiment results above. under the same experiment conditions, such as sample shape, size, surface roughness, establishment of testing system, pressure on the probe, and thickness of coupling medium, the variety of relative attenuation coefficient ( or ) in different heat treatment samples is measured and compared by measuring the attenuation obtained from the cylindrical surface of column. the result is as following : for 40cr and 38crmoal, a mt < az mq < a s < a p + f ; for gcrlssimn, a mt < a annea < s < a p + f ; and a increased with the increasing of frequency

    在保證試樣形狀、尺寸、表面光潔度、系統參數設置、施加在探頭上的壓力以及耦合層厚度等測試條件一致的情況下，利用棒材圓柱面測衰減系數法，分別測定並比較上述不同熱處理試樣相對衰減系數的變化情況，得到的實驗結果是：對於40cr及38crmoal鋼， _ （低溫回火） （淬火） _ （高溫回火） _ （正火） ；對于gcr15simn鋼， _ （低溫回火） _ （退火） _ （高溫回火） _ （正火） ；且隨著頻率的提高，衰減系數均呈現增加的趨勢。
  8. According to structural characteristics of multi - phased alloy steels and the properties of ultrasonic propagation, microstructures characterization with different heat treatment processes ( normalizing, quenching / annealing, quenching plus low tempering, quenching plus high tempering ) for three steels ( 40cr, 38crmoal, gcrlssimn ) was studied experimentally by using ultrasonic methods. ultrasonic velocity, relative attenuation coefficient, and power spectral analyses were researched on the same samples respectively, on the basis of theory and experiment, the sensitivity and other characterizations of the three methods used to distinguish different microstructures were compared

    根據具有多種相結構合金鋼不同熱處理轉變產物的組織特點，以及超聲波在其中的傳播規律，利用超聲波速度、相對衰減系數以及功率譜分析三種方法，對三種鋼（ 40cr 、 38crmoal及gcr15simn ）不同熱處理（正火、淬火退火、淬火+低溫回火及淬火+高溫回火）轉變產物的顯微組織進行了超聲表徵研究。
  9. In the second part, considering the depress of the stiffness of concrete caused by its transient thermal strain under fire, the current formulas can be conducted, and then the formulas to calculate the internal force and deformation of rc frame under fire can be conducted by structure mechanics

    （ 2 ）受火構件等效成常溫構件后，再對火災高溫下混凝土瞬態熱應變導致的軸向剛度降低進行修正，推導了受火樑柱的剛度降低修正計算公式，基於結構力學矩陣分析法推導了受火構件的溫度內力和變形計算公式。
  10. So, the accurate measurement and forecasting of flame temperature field in the stove is very important for the burning state judgement, and adjust the operation parameter of the boiler in view of the above, it is very important to ensure the normal running of the boiler

    因此，爐內火焰溫度場的準確測量和預估對判斷爐膛的燃燒狀態，並據此調整鍋爐的運行參數，保障鍋爐的正常運行非常重要。
  11. The same with normal metal film, fe0. 3cu0. 7 ( 500nm ) granular film have positive coefficient of temperature. the negative resistance is observed in fexcu ( 1 - x ) granular film under certain condition. this characteristic of negative resistance is weakened or changed to positive with the change of thickness of film, ratio of fe atom to cu atom, anneal, test temperature

    N ） fecu顆粒膜月一i特性研究發現，極小電流下電阻測量具有不確定性； fe cu矚00川）顆粒膜己與普通金屬薄膜一樣，具有正的溫度系數； f民c山x顆粒膜在一定條件下存在負阻現象，並且隨顆粒膜厚度、鐵銅原子比、退火條件、溫度的改變分別存在負阻特性的減弱或向正阻特性的轉變。
  12. In czochralski silicon crystals ( czsi ) through fast neutron irradiation, formation and conversion of defects were investigated using fourier transform infrared spectroscopy ( ftir ), positron annihilation technology ( pat ) and scanning electron microscope ( sem ). the results showed that fast neutron irradiation induced large quantity of metastable defects which can be the capture centers of positron, positron annihilation average lifetime of samples increased with increasing of irradiation dosage. positron annihilation average lifetime of irradiation samples through dosage up to 1 1018 n. cm - 2 tended to constant

    本文對直拉硅樣品進行了不同劑量的快中子輻照，在硅中引入大量的亞穩態缺陷，研究這些亞穩態缺陷的形成，並在較寬的溫度范圍內對輻照樣品進行了退火處理，研究退火后亞穩態缺陷的轉化及同硅中氧的相互作用，應用傅立葉變換紅外光譜技術（ ftir ） 、正電子湮沒技術（ pat ）和掃描電鏡（ sem ）進行了測試。
  13. Correct control of the tempering temperature of quench steel

    淬火鋼回火溫度的正確控制
  14. In order to verify the validity and feasibility of temperature distribution measurement principle, an experimental bench using infrared radiation absorption ct technology has been established

    為驗證上述測量原理的正確性和可行性，建立了吸收發光ct法火焰溫度測量系統。
  15. In this paper, multilayered pt / bst / pt thin film capacitors were fabricated by the sol - gel process. both the reverse and forward leakage currents of the pt / bst / pt capacitors were reduced several orders of magnitude by employing this multilayered structure with top and bottom layers annealed at low temperatures during the sol - gel deposition of bst films

    本文採用溶膠-凝膠法，通過降低最底層和最上層的退火溫度，在pt ti sio _ 2 si襯底上制備了非晶多晶型bst多層膜，不僅改善了正向漏電流特性，而且也改善了反向漏電流特性。
分享友人
分享到 Line

分享到臉書