殘余氣量 的英文怎麼說

中文拼音 [cányúqìliáng]
殘余氣量 英文
residual volume
  • 殘 : Ⅰ形容詞1 （不完整; 殘缺） incomplete; deficient 2 （剩餘的; 將盡的） remnant; remaining 3 （兇惡...
  • 余 : Ⅰ動詞（剩下） remain; leave: 9減4 余 5。 nine minus four is five ; four from nine leaves five ; i...
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 氣量 : 1 （容忍謙讓的限度; 度量） tolerance 2 （舊指才識和品德的高低） ability and insight; 氣量表 gas m...
  1. Standard test method for determining residual vinyl chloride monomer content in ppb range in vinyl chloride homo - and co - polymers by headspace gas chromatography

    用液上氣相色譜法測定氯乙烯均聚物和共聚物中的十億分之一級殘余氯乙烯單體含量的標準試驗方法
  2. This circumstance means that cool molecular gas is located there, a vestige of the original gas-dust cloud from which not massive stars were formed, spawning hii zones.

    這種情形意味著那裡有冷分子氣體，它是形成大質量高溫星、產生H區的原始氣塵雲殘余。
  3. Through measuring residual swhirling flow field in the flue duct of a real boiler, and analysing layout features of front and back platen supe - heaters in large - scale tangential firing boilers, the flue gas energy distribution regularity in horizontal flue duct of tangential firing boilers has been studied

    摘要通過對實際鍋爐煙道煙氣殘余旋轉流場的測量及大型切圓燃燒鍋爐前、后屏過熱器的布置特點分析，研究了切圓燃燒鍋爐水平煙道煙氣能量的分佈規律。
  4. Semiconductor devices - mechanical and climatic test methods - internal moisture content measurement and the analysis of other residual gases

    半導體器件.機械和氣候試驗方法.其他殘余氣體的內部濕氣含量的測量和分析
  5. In the paper, we analyze the reason and effect of the bremsstrahlung, calculate the dose in the linear section of the storage rings, and propose the defense project to shield it

    針對北京正負電子對撞機（ bepc和bepcii ）儲存環直線節結構特點，分析其中殘余氣體產生的軔致輻射，計算該氣體軔致輻射所產生的劑量並提出防護措施。
  6. Standard test methods for leakage measurement using the mass spectrometer leak detector or residual gas analyzer in the hood mode

    用罩式質譜探漏儀或殘余氣體分析儀作檢漏測量的標準試驗方法
  7. The paper mainly discussed the reasons of stress from liquid ammonia pressure vessel causing crack through examing data and experimental results and analysing relevant referential documents and materials, taking 1200 ammonia vessel ' s crack and leaking in a certain fertilization company as an example : there existed remaining welding, stress in the equipment ; there existed a stress decaying surrounding, i. e., moisture 0. 2 %, and temperature > - 5 with o2 or co2 inside ; the higher the intensity of raw materials, more possible it was to have stress decaying crack

    摘要以某化肥公司1200氨冷器殼體開裂泄漏的失效分析為例，通過對檢驗數據和結果及有關文獻資料的分析研究，探究了液氨介質壓力容器產生應力腐蝕裂紋的原因：設備中存在較高的焊接殘余應力；液氨介質具備應力腐蝕環境，即含水量0 . 2 % ，且有空氣（ o2或co2 ）污染（或摻入） ，使用溫度高於零下5 ；母材強度越高，應力腐蝕裂紋產生的傾向就越大。
  8. Through analyzing the effect of temperature and nitrogen on crude oil viscosity the influences of different nitrogen injection volume and injection modes on steam displacement are contrasted, the mechanism of nitrogen - assisted steam stimulation is clarified, which includes : heat carrying capacity is raised, the saturation of remaining oil is reduced after nitrogen - assisted injection is made ; crude oil flow is enhanced because of nitrogen compression and dispersion and the change of oil flow shape ; water back - production rate is improved by expanding the steam sweep volume and compensating in - situ energy ; steam distillation effect is enhanced

    通過分析溫度、氮氣對原油粘度的影響，對比不同注氮量、不同注入方式等對蒸汽驅油效果的影響，弄清了氮氣輔助蒸汽增產的機理主要表現在：氮氣輔助后增加攜熱能力，降低殘余油飽和度，氮氣的壓縮膨脹作用分散和改變了原油流動形態，增強了原油流動性；擴大蒸汽的波及體積，補充地層能量，提高回採水率，強化蒸汽蒸餾效應。
  9. Methods of testing plastics - chemical properties - determination of residual acrylonitrile monomer content in styrene acrylonitrile copolymers using gas chromatography

    塑料試驗方法.第4部分:化學性能.試驗方法453c :用氣相色譜法測定苯乙烯丙烯腈共聚物中殘余丙烯腈單體含量
  10. In the second, in allusion to non - stationary the characteristic of the signal, the author introduces to the method that using empirical mode decomposition to analysis the vibration signal so that the signal are made up of some intrinsic mode function, after this process, we can use stochastic subspace identification to identification the mode parameter of the structure and find the same work frequency

    其次，針對氣閥振動信號的非平穩特點，本文採用了經驗模式分解法（ empiricalmodedecomposition ）對振動信號進行分析處理，使之成為若干個基本模式函數imf （ intrinsicmodefunction ）和一個殘余量的線性組合。接著採用隨機子空間參數識別法對各個基本模式函數其進行結構參數識別，同時找出各種狀態的共同工作頻帶。
  11. On the basis of above experiments, the chemical kinetic model inwhich organic matter of source rock of deep - formation in the north of songliao basin primarily crack into oil or gas is established, which set up a basis for evaluating oil - generating amount, gas - generating amount of source rock of deep formation in different periods ; set up the chemical kinetic model inwhich different qualities of oil and family constituents in oil secondarily cracked into gas, which provide theoretical foundation and practical methods for dynamic evaluation of gas - generating amount and oil - consuming amount in process of oil cracking. the geochemical features of source rocks in deep - formation of basins are systematically evaluated

    在上述實驗基礎上，建立了松遼盆地北部深層源巖有機質初次裂解成油、成氣的化學動力學模型，為評價深層源巖于不同時期的生油量、生氣量奠定了基礎；建立了不同性質原油及原油中各族組分二次裂解成氣的化學動力學模型，為動態評價油裂解過程的成氣量和耗油量提供了理論依據和實用方法；對盆地深層源巖的地化特徵進行了系統評價；考慮到深層源巖的成熟度較高，實測地化指標（殘余有機碳、氫指數等）不能客觀反映源巖有機質的原始豐度和原始生烴潛力。
  12. The technology process : the waste, through operation stand, to be rationed into the standing majorcombustion room, being ignited by the ignition - burningmachine, upon the principal of burningthree t, fully burned in the major combustion room （ 800 - 1000 ). the remaining waste gas afterburning via flue goes into secondary combustion room for further high temperature oxidizingcombustion. the gas flow after the secondary combustion goes into the highly effective cyclonedust remover, removing the bigger granule of dust, flowing into rapid - cooling spay and washing equipment to absorb acid gas

    廢棄物經操作臺連續定量投入立式爐本全燃燒室，由點火文空燃燒機自動點火，根據三t原則在爐本體燃燒室（ 800 - 1000 ）以充分燃燒，焚燒后產生的殘余廢氣經煙道進入二次燃燒室再經高溫（ 1100 - 1200 ）氧化焚燒，經二次焚燒后的氣體進入高效旋風除塵器，除去顆粒較大的粉塵后，進入急冷塔噴淋洗滌裝置吸收酸性氣體。
  13. In addition, imperfections like drag and gas holes were easy to turn out in the surface of epc casting for imperfect technology design, and this was verified by the actual castings

    同時發現，在消失模鑄件表面容易因殘余泡沫而造成表面渣氣孔，實際鑄件的表面質量也證明了這一點。
  14. Plastics - phenolic resins - determination of residual phenol content by gas chromatography

    塑料.酚醛樹脂.用氣相色譜法測定殘余酚含量
  15. The length should be added if the cost is n ' t increased and the installation is convenient, the diameter should be chose by the local weather condition and the using requirement ; the gas pressure should be not higher than 5 x 10 - 2pa and the emissivity should be less than 0. 1, the spring should be small and narrow in order to decrease the heat loss, the gas absorbed getter should not be too many as long as it can absorb the residual gas and keep the vacuum degree

    在不影響安裝和增加成本的情況下，應適當增加太陽能真空集熱管的長度;根據當地的氣候條件和使用要求來綜合考慮選擇直徑;國標規定的真空度必須達到5x10 』 zpa ，發射率小於0 . 1是合理的;彈簧卡子不要選用很寬、很大的尺寸，盡量減少接觸熱損;吸氣劑並非越多越好，只要能夠吸收殘余氣體，保證一定的真空度即可。
  16. This circumstance means that cool molecular gas is located there, a vestige of the original gas - dust cloud from which not massive stars were formed, spawning hii zones

    這種情形意味著那裡有冷分子氣體，它是形成大質量高溫星、產生h區的原始氣塵雲殘余。
  17. Plastics - phenolic resins - determination of residual phenol content by gas chromatography iso 8974 : 2002 ; german version en iso 8974 : 2002

    塑料製品.酚醛樹脂.採用氣相色譜法對殘余酚含量的測
  18. Essential oils. evaluation of non volatile residu content. general gas chromatographic method on packed and capillary column

    香精油.非揮發性殘余物含量的評價.填充柱和毛細管柱通用氣相色譜法
  19. Semiconductor devices - mechanical and climatic test methods - part 7 : internal moisture content measurement and the analysis of other residual gases

    半導體器件.機械和氣候試驗方法.第7部分:其他殘余氣體的分析和內部水分含量的測量
  20. Rcd electrical safety in low voltage distribution systems up to 1000 v a. c. and 1500 v d. c. equipment for testing, measuring or monitoring of protective measures - residual current devices in tt, tn and it systems

    不超過交流1000v和直流1500v低壓配電系統電氣安全性.防護用試驗測量或監測設備. tt tn和it系統用殘余電流裝置
分享友人
分享到 Line

分享到臉書