殘余體 的英文怎麼說

中文拼音 [cányútǐ]
殘余體 英文
residual body
  • 殘 : Ⅰ形容詞1 （不完整; 殘缺） incomplete; deficient 2 （剩餘的; 將盡的） remnant; remaining 3 （兇惡...
  • 余 : Ⅰ動詞（剩下） remain; leave: 9減4 余 5。 nine minus four is five ; four from nine leaves five ; i...
  • 體 : 體構詞成分。
  1. The archaean and katarchaean units are preserved mainly as relic masses.

    太古界與遠太古界主要作為殘余體保存下來。
  2. Abstract : for analyzing the residual stress distributing state within the weld joint, and its effect on the performance of welding structure, when welding the ferrite pearlite steel with the austenite steel, this paper develops a finite element program to compute the interface stress of two or over two material. finally, this program is used to analyze the mechanical behavior of heterogenic joint

    文摘:為了分析鐵素體、珠光體類鋼與奧氏體類鋼焊接時，焊接接頭處焊接殘余應力的分佈狀態及其對焊接構件性能的影響，研製了可計算兩種或兩種以上材料界面應力的有限元程序，並用此程序分析了異質接頭的力學行為。
  3. Composition : ovine meat and bone meal ? produced from the solid material left over after the dehydration of the offal and removal of the fat

    合成方式:綿羊肉骨粉?由脫水去脂后的動物的固體殘余物製成。
  4. Composition : bovine meat and bone meal ? produced from the solid material left over after the dehydration of the offal and removal of the fat

    合成過程:牛肉及牛骨粉?由脫水去脂后的動物的固體殘余物製成。
  5. Coal is destructively distilled leaving a solid residue, coke.

    煤被干餾后剩下固體殘余物：焦炭。
  6. Based on the analyses on mechanical properties, microstructure and fracture of - the microalloyed steels socrv with various heat treatment technique, it can be affirmed that various fractures arttribute to various mechanism, we can draw conclusion that the strength and toughness of microalloyed steels 50crv will be increase simultaneously by optimal heat treatment technique. to illustrate the mechanism of the strength and toughness of microalloyed steels socrv, we designed the comparative experiment and observed the microstructure of the sample which occurred at different quench and tempering temperature and different tempering time. the last experiment results were determined by the four factors : fined microalloyed elements grains, the decompound of martensite, martensite transformation of remnant austenite and the second phase precipitation

    為解釋微合金化50crv鋼強韌化機理，本文通過對不同淬火溫度，回火溫度，回火時間下的力學性能指標的對比及顯微分析，認為微合金元素的細化晶粒，馬氏體的回火分解，殘余奧氏體的轉變，第二相的沉澱析出共同決定了微合金鋼的強韌化情況，特別是由於微合金元素的存在，其細化晶粒及其碳氮化物的沉澱析出，導致鋼的良好的強韌性，並且如果工藝滿足第二相的沉澱析出強化大於回火馬氏體分解引起的軟化效應，會在硬度曲線中產生明顯的二次硬化現象。
  7. Before intervening in any circuit which has a gas filled pressure vessel, the pressure must be discharged from the circuit

    當管道與充有壓力氣體的容器連接時，如果需要對任何管線進行操作，必須先將管線中的殘余壓力進行釋放。
  8. The remnant nebular gas pervades the interplanetary space.

    星雲的殘余氣體充斥星際空間。
  9. The relations of metallography and remains austenitic to bearing ' s life

    軸承工作表面的金相組織和殘余奧氏體對壽命的影響。
  10. Standard test method for determining residual vinyl chloride monomer content in ppb range in vinyl chloride homo - and co - polymers by headspace gas chromatography

    用液上氣相色譜法測定氯乙烯均聚物和共聚物中的十億分之一級殘余氯乙烯單體含量的標準試驗方法
  11. However, by the time a lightning strike has traveled through the distribution network, surge arrestors will have dissipated a proportion of the charge, network impedance will have shaped the impulse and the residual energy can be represented in terms of its waveshape, and its peak current which is what will be present at a service entrance

    然而，雷擊經過電力網路進行傳送以後，避雷放電器會將一部分能量泄放掉，網路的阻抗也會對電涌進行修整，而殘余的能量將可以以它的波形來體現，其峰值電流也就是建築物進入端將會出現的情況。
  12. This circumstance means that cool molecular gas is located there, a vestige of the original gas-dust cloud from which not massive stars were formed, spawning hii zones.

    這種情形意味著那裡有冷分子氣體，它是形成大質量高溫星、產生H區的原始氣塵雲殘余。
  13. The variations in trace element contents and ratios may hold up a mirror to the lake - level fluctuations and climatic changes, which, in turn, have exerted a direct and important effect on the sequence stratigraphic development. collectively, the reservoir rocks from the yanchang formation consist dominantly of the delta front subfacies subaqueous distributary channel and channel - mouth bar microfacies and delta plain subfacies subaerial distributary channel microfacies fine - grained feldspar sandstones and siltstones. the reservoir rocks have been subjected to three stages of diagenetic and porosity evolution : ( 1 ) the porosity reduction by the mechanical compaction and chemical pressure solution during the early diagenetic stage ; ( 2 ) the porosity increase by the dissolution during the a substage of the late diagenetic stage, and ( 3 ) the porosity reduction by the cementation and filling during the b substage of the late diagenetic stage

    系統的儲層特徵研究表明，該區延長組儲層成因類型主要為三角洲前緣水下分流河道、河口砂壩及三角洲平原水上分流河道微相細粒長石砂巖、粉砂巖；儲層巖石經歷了壓實，膠結，溶蝕等成巖作用，歷經早成巖機械壓實和化學壓溶孔隙縮小期、晚成巖a亞期溶蝕作用孔隙擴大期及晚成巖a亞期（ b亞期）膠結充填孔隙縮小期三個成巖-孔隙演化階段；儲層物性總體上具有較低孔滲、低孔滲的特點，孔隙類型主要為粒間溶孔、殘余粒間孔隙、粒內溶孔、晶間孔及晶間溶孔，裂縫不發育，儲集巖排驅壓力和中值壓力較高，孔隙結構類型以細小孔-微孔隙，微細喉-微喉型為主。
  14. The results show that the solidification microstructure of high speed steel fe - 2 % c - 4 % v - 4 % mo - 5 % cr - x % w ( wt ) contains of martensite, retained austenite structure, and mc, m6c, m2c carbides, and mc / m2c complex carbides by xrd, sem and metallographs. most of the mc carbides locate in the cell and other carbides distribute along the boundary of the cell

    結果表明：經金相組織觀察、 x射線衍射和掃描電鏡分析， fe - 2 c - 4 v - 4 mo - 5 cr - x w合金系高速鋼凝固組織包含馬氏體基體、殘余奧氏體及各種類型的碳化物如mc型碳化物、 m _ 2c型碳化物、 m _ 6c型碳化物和mc m _ 2c類型復雜碳化物，大部分mc型碳化物分佈於晶粒內部，其它類型碳化物則沿晶界呈網狀分佈。
  15. Measuring retained austenite of carburize layer of low carbon alloys with x - ray diffraction method

    射線衍射法測定滲碳鋼中殘余奧氏體
  16. The despising of manual labour, a vestige of the ideology of the exploiting classes, is an obstacle to the progress of our new society

    輕視體力勞動的剝削階級思想的殘余，是我們的新社會前進的障礙物。
  17. Packaging - flexible packaging material - determination of residual solvents by static headspace gas chromatography - industrial methods

    包裝.軟性包裝材料.應用靜態液體上部氣相色譜分析法測定殘余溶質.工業法
  18. In the hogging condition, double bottom and the side shell remain the ultimate bucking strength, deck and upperwing tank remain the yield stress, and the other parts keep elasticity. then the key to calculate the ultimate strength of ship hull girders is to ascertain the ultimate bucking strength of the stiffened panels. in this regard, the developed formulation is designed to be more sophisticated than previous simplified theoretical method for calculating the ultimate strength of stiffened panels under combined in - plane bending and lateral pressure. fabricatio n - related initial imperfections ( initial deflections and residual stresses ) are included in the panel ultimate strength calculation as parameters of influence. all possible collapse modes involed in collapse of stiffened panels, including overall buckling collapse, column or beam - column type collapse, tripping of stiffeners and local bukling of stiffened web are considered

    確定了船體梁整體破壞時的剖面應力分佈之後，關鍵在於確定板架的極限屈曲強度。本文充分考慮了在縱向彎曲、橫向壓力作用下加筋板可能發生的幾種破壞模式，即板架的整體屈曲破壞、樑柱形式的破壞、筋的側傾、腹板的屈曲並同時考慮了初始焊接殘余應力、初撓度的影響，使其更精確的計算加筋板的屈曲強度。對于加筋板中加強筋腹板的局部屈曲，採用解析法推導出筋的腹板的撓度方程及其邊界條件，求解相應的方程，從而計算出腹板的局部屈曲應力。
  19. Physiologically deaf, that is with little or no usable residual hearing, late deafened people are nevertheless recognized, and recognize themselves, as a group with overlapping, but still distinct needs and characteristics than either the pre - lingually deafened or the hard of hearing

    生理學上的聾，是指只有很少一點或者完全沒有殘余聽力，後天變聾的人仍然被認為是一個與生理學聾人有相同之處的群體，他們自己也這樣認為，但是，語前聾和重聽仍舊有著不同的需求和特性。
  20. In metal matrix composites, thermal residual stresses will arise due to get ( coefficient of thermal expansion ) mismatch between matrix and fiber during cooling

    在擠壓鑄造的金屬基復合材料中，由於基體和纖維的熱膨脹系數相差很大，所以在制備過程中由高溫（工藝溫度）冷卻至室溫時復合材料中會有熱殘余應力產生。
分享友人
分享到 Line

分享到臉書